L Oreal SA SK-01 Skin Connect User Manual

OPERATING MANUAL MODEL SK-01
PMN SKIN CONNECT,

DEVICE CONTROL

SK-01 LIGHT INDICATION GUIDE
The information below will help you to ensure that the pairing of the device and iPad goes successfully. In case of difficulties during pairing, make sure that device is fully charged.
ON CHARGING DECK

OUT OF CHARGING DECK

• if the LED turn RED during the experience, you can finish the experience/the diagnosis and you must put the device on charging deck at the end.
  NB: After 10 minutes of inactivity, the device turns off.

  • If the device was recharging, just remove it from the station charger
  • If the device was not recharging, just click on the button.

WIFI CONNECTION
5G Wifi Hotspot 5150-5250MHz restricted to indoor use only 1/Run the companion application on your Ipad, only Ipad Pro 11: 3 rd and 4 generation. 2/Go to ‘Setting’ menu of the tablet/ phone > Wi-Fi and among the Wi-Fi networks select the device SSID (SK-01XXXXXX). Located below the device. 3/ Enter the Wifi password of the device.
Follow the instruction of the companion APP on the tablet to connect to SK-01
Place the device in contact of the skin to observe the condition of the skin pores, press the main button to capture the image for images analysis and measure the hydration level of the skin.

IMPORTANT SAFETY AND PRODUCT INFORMATION

Skin diagnostic product, device not intended for skin care.
The device cannot be used while charging.
** This symbol identifies a potential hazard which, if not avoided, could result in death, serious injury or property damage. Read this guide for important safety and health information for the product that you purchased.
WARNING:** Failure to properly set up, use, and care for this product can increase the risk of serious injury, death, property damage, or damage to the product or related accessories. Exercise caution when using your sk-01 as part of your active lifestyle.
Always be aware of your surroundings to avoid injury to yourself and others.

• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Clean only with a dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus that produce heat.
• Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where it exits from the apparatus.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Refer all servicing to qualified personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

CAMERA SAFETY
WARNING: Failure to take the following precautions can result in serious injury or death from electric shock, fire, or damage to your device.

• Inspect your camera and accessories before use to ensure they are not damaged and are assembled according to instructions.
  For safety purposes, use only batteries, power cables, or other battery charging/recharging accessories provided. The use of any other component, accessory, or charger that is not recommended may cause fire, electric shock, or injury. Your warranty does not cover damage caused by use of unauthorized attachments.

• Do not drop, disassemble, open, crush, bend, deform, puncture, shred, microwave, incinerate or paint the camera, battery or powered accessories.

• Do not insert foreign objects into any opening on the camera, such as the USB port.

• Do not use the camera if it has been damaged—for example, if cracked, punctured or harmed by water.

• Do not dry the camera or battery with an external heat source such as a microwave oven or hair dryer.

• Do not place naked flame sources, such as lighted candles, on or near the product.
  When charging the camera, do not handle the plug or charger with wet hands. Failure to observe this warning could result in electric shock.
  Using a wall charger other than a provided wall charger can damage the camera battery and could result in fire or leakage. Use this product only with an agency approved power supply which meets local regulatory requirements (e.g. UL, CSA, VDE, CCC). Camera will not float. Do not get the battery wet. Failure to observe this precaution could result in fire or electric shock. Do not submerge your device in liquid if the battery door is open. Damage to the camera or battery caused by contact with liquid is not covered under the warranty.
  Only mount your camera where it will not interfere with vehicle or equipment operation
  Do not place the product on, or attach it to, unstable surfaces. Failure to observe this precaution could result in the product coming loose or falling over, causing accidents or other injury.
  If using the external power connection, follow all safety guidelines for the third-party power device.
  Your camera lens is glass. Should the lens break, care should be taken to avoid injury due to broken glass. Keep out of reach of children. The temperature of your camera may become warm during operation, which is a normal condition during use. In such circumstances, disconnect the battery or power source and let it sit and cool before attempting to use it again. Continued operation could result in fire, burns or other injury.
  This product is not a toy. It is solely your responsibility to comply with all local laws, regulations, and restrictions. Should a child swallow any part of this product, seek immediate medical attention.
  Do not use the device for unauthorized surveillance, surreptitious use, or in any manner that violates personal privacy laws. Such use is often strictly forbidden and can subject the operator to serious liability and criminal prosecution.

CAUTION:
Radio-frequency emissions from electronic equipment can negatively affect the operation of other electronic equipment, causing them to malfunction. The wireless transmitters and electrical circuits in your product may cause interference in other electronic equipment. When using the product near another device, read that device’s user guide for any safety instructions. Power your camera off whenever it is forbidden to use it or when it may cause interference. NOTICE:
Avoid exposing your camera or battery to very cold or very hot temperatures. Low or high temperature conditions may temporarily shorten the battery life or cause the camera to temporarily stop working properly. Abide by all local laws when using your camera and related mounts and accessories, including all privacy laws, which may restrict recording in certain areas. The product label is located at the bottom of the camera.

BATTERY SAFETY

WARNING: The following precautions apply to the battery that was included . Improper battery use may result in serious injury, death, property damage, or damage to the product or related accessories as a result of battery fluid leakage, fire, overheating, or explosion. Released battery fluid is corrosive and may be toxic. It can cause skin and eye burns, and is harmful if swallowed. If fluid from the battery contacts skin or clothes, flush skin with water immediately. To reduce the risk of injury and ensure proper performance of your battery, follow these guidelines:

• Keep batteries out of the reach of children.
• Keep batteries clean and dry.
• Do not dismantle, open or shred battery pack or cells. Do not short-circuit the battery. Do not store batteries in a box or drawer where they may short-circuit each other or be short-circuited by other metal objects. Failure to follow this warning can cause an explosion or fire.
• Do not subject batteries to mechanical shock.
• Never use or charge a damaged, leaky or swollen battery.
• Batteries need to be charged before use. Always use the correct charger and refer to the manufacturer’s instructions or equip- ment manual for proper charging instructions.
• Do not leave a battery on prolonged charge when not in use. Discontinue use immediately should you notice any discoloration or deformation in the battery. Failure to observe these warnings could result in the battery leaking, overheating, rupturing, or catching fire.
• Batteries give their best performance when they are operated at normal room temperature 68°F (20°C) ± 9°F (5°C).
• Do not dispose of the battery in regular trash containers. Recycle the battery according to your local regulations.
• There is a risk of explosion if the battery is replaced by an incorrect type.
• Replace the battery only with the same or equivalent type.
• Dispose used batteries according to the local laws and regulations regarding safe disposal of lithium batteries.
• Disposal of a battery into a fire or by crushing or puncturing it can result in an explosion.
• Leaving a battery in an extremely high temperature environment can result in an explosion or the leakage of flammable liquid or gas.
• A battery subjected to extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas.
• Installation should be done only by a trained electrician who knows all installation procedures and device specifications.

LIMITED WARRANTY

Warranty is for a period of two (2) year from original date of purchase, the product will be free from defects in materials and workmanship under normal use. In the event of a defect, contact support for assistance. Sole obligation under this warranty will be, at its option, to repair or replace the product. This warranty does not apply to products damaged by misuse, exposure to water, accident, alteration, or normal wear and tear. Damage resulting from use with non-manufacturer batteries, power cables, or other battery charging/recharging accessories or devices is also not covered by this or any warranty. ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED TO THE DURATION OF THIS WARRANTY. THE MANUFACTURER DISCLAIMS ALL OTHER EXPRESSED OR IMPLIED WARRANTIES OR CONDITIONS. TO THE EXTENT NOT PROHIBITED BY LAW, IN NO EVENT WILL MANUFECTURER BE LIABLE FOR ANY LOSS OF DATA, REVENUE OR PROFIT, OR FOR ANY SPECIAL, INDIRECT, CONSEQUENTIAL, INCIDENTAL OR PUNITIVE DAMAGES, HOWEVER CAUSED, ARISING OUT OF OR RELATED TO THE USE OF OR INABILITY TO USE THE PRODUCT, EVEN IF THE MANUFACTURER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN NO EVENT WILL THE MANUFACTURER LIABILITY EXCEED THE AMOUNT PAID BY YOU FOR THE PRODUCT. Some jurisdictions do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary by jurisdiction. European Union Consumers: the manufacturer grants for a period of two (2) years from the original date of purchase of the relevant product and free of charge a limited manufacturer’s guarantee to the end customer. This shall not limit any consumer rights which you have under consumer law; instead it grants you additional rights. The guarantee is governed by the following terms and conditions. The manufacturer guarantees that for a period of two (2) years from the original date of purchase, your product will be free from defects in materials and workmanship under normal use and provided it has been used in accordance with the instructions in the relevant user manual. In the event of a defect, contact Support for assistance. Sole obligation under this guarantee will be, at its option, to repair or replace the defective product. This guarantee does not apply to products damaged by misuse, accident, or normal wear and tear. This guarantee also does not apply to products damaged as a result of repair works not performed by the manufacturer or an authorized dealer. Australian Consumers: The benefits given by the manufacturer limited warranty are in addition to other rights and remedies available to you. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and to compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the product repaired or replaced if it fails to be of acceptable quality and the failure does not amount to a major failure.. Please dispose of used batteries properly, following local regulations. Do not incinerate.
This symbol means that, according to local laws and regulations, your product should be disposed of separately from household waste. When this product reaches its end of life, take it to a collection point designated by local authorities. Some collection points accept products for free. The separate collection and recycling of your product at the time of disposal will help conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. The manufacturer declares that the radio equipment type SK-01 is in compliance with Directive 2014/53/EU.
L’Oréal SA 14 rue Royale 75008 Paris France
The camera SK-01 transmits at the 5.150 GHz – 5.250 GHz frequency bands
Complies with IMDA Standards DA103787
The maximum power transmitted in these frequency bands is EIRP 635.727 mW.
Version SK-01 – Hardware Version: Rev3; Software Version: 2.0.5.
Country specific rules and regulations can prevent or limit the use of some or all of the listed frequency bands and power level.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
United States
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,  the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.

CANADA
ISED Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian Information on RF exposure and compliance.
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.
This radio transmitter (ISED certification number: 31813-SK01) has been approved by Industry Canada to operate with the antenna types listed with the maximum permissible gain indicated. Antenna types not included in this list, having again greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Specific Absorption Rate (SAR) information:
This Device meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.
FCC&ISED RF Exposure Information and Statement the SAR limit of USA (FCC) and Canada(ISED) is 1.6 W/kg averaged over one gram of tissue.
Device types: Device has also been tested against this SAR limit.
This device was tested for typical body-worn operations with the back of the device kept 0mm from the body. To maintain compliance with FCC&ISED RF exposure requirements, use accessories that maintain an 0mm separation distance between the user’s body and the back of the device.
The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly.
The use of accessories that do not satisfy these requirements may not comply with FCC&ISED RF exposure requirements and should be avoided.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>