evluma RX2 LED Roadway Luminaire Installation Guide
- June 2, 2024
- evluma
Table of Contents
ROADMAX RX2
SECONDARY LENS INSTALLATION INSTRUCTIONS
Installing the RX2 LENSG1 over the primary optic
Secondary lenses can be installed on the RX2 to provide additional glare
control. Lenses are available installed from the factory, or as an accessory
that can be installed at a later date.
Please see the RoadMax datasheet for ordering information and color choices.
When ordered separately the bezel for the lenses is shipped with captive #10
hex head screws.
Lenses may be installed with the luminaire on a workbench, or in the field
after the luminaire itself has been hung. The following instructions are for
installation on a workbench.
Tools Required: 5/16” socket driver, or 1/4” flat head screwdriver. Use of a
socket driver recommended.
A. Place the RoadMax on a flat surface with the lens side facing up.
B. Take the two acrylic secondary lenses and line each up with the three
outermost, empty screw holes to the left and to the right.
C. Place the metal bezel over the lenses and align the center screw to the
empty screw hole between the two lenses accordingly. The metal bezel will hold
the lenses in place and flat against the luminaire.
D. With the metal bezel in place begin to fasten the seven captive screws.
Alternate tightening to avoid cross threading. 25 in-lbs recommended. Do not
over tighten.
PN-101166-001 Rev A01
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>