NICOR T6C LED Troffer Instruction Manual
- June 4, 2024
- NICOR
Table of Contents
SALE on Nicor Lighting @ www.BulbAmerica.com take additional 5% Off with coupon code 5PDF
T6C LED TROFFER
INSTALLATION INSTRUCTIONS
T6C LED Troffer
The installation must only be performed by a licensed electrician.
To prevent death, injury or damage to property, this product must be installed
in accordance to National Electrical Code (NFPA70) in the US or Canadian
Electrical Code (CSA 22.1) in Canada.
Disconnect power before installing the product or servicing it.
Wait until fixture has cooled down before installing or servicing the fixture.
MIN. 90°C SUPPLY CONDUCTORS
What’s In The Box
Tools Needed
This LED Troffer requires very few tools for installation. A drill or a screwdriver and a pair of wirecutter.
1. Carefully unpack the fixture from its packaging. Inspect product for
defects due to shipping.
| 2. Bend four (4) mounting/grid-tie clips up and out from the fixture.
---|---
3. Place fixture into t-grid ceiling. Secure safety cables through holesas
required by local seismic requirements.
| 4. Remove j-box cover by removing screw. Carefully remove knockouts for
line voltage and 0-10V control wires.
5. Connect wiring to j-box with appropriate fittings. Line Voltage
and 0-10V wiring must be connected in seperate knockouts.| 6. Connect wiring
as shown. Grey and purple wiring are for 0-10V
dimming systems. Cap off if not used.
7. Reattach cover of junction box and secure with screw.
| 8. Power on fixture and test for proper function.
LED EXPRESS LIMITED WARRANTY
Subject to the exclusions below, each NICOR LED product, including the LED
electronics and components of a property-installed NICOR LED product, will be
free from defect in materials and workmanship for a period of ve (5) years
from the original date of purchase. The product shall be considered defective
only if 10% or more of the product’s LED components fail. NICOR LED product
warranty covers the following performance criteria: LED Light Output will be
maintained above 70% of initial output; LED color temperature will not shift
more than 200K in CCT; LED driver will operate within NICOR specications; and
the xture nish, excluding natural aluminum or brass products, will not exhibit
cracking, peeling, excessive fading, or corrosion during the warranty period.
Exceptions apply as dened in NICOR’s product specification sheets, which are
incorporated by reference herein.
This limited warranty is provided to you, the purchaser of the product
identied on Seller’s invoice, as your exclusive remedy and applies only to
NICOR products that have been purchased from an authorized NICOR Distributor;
the product was new and in an unopened NICOR package at the time of
installation; and the NICOR product was installed by a licensed electrician or
under the supervision of a licensed electrician and used by consumers in the
United States or Canada when accompanied with this warranty. This warranty
extends only to the rst consumer purchaser and is not transferable. A consumer
wishing to invoke the terms of this limited warranty must rst obtain a RGA
number within 30 days of discovery of the defect, and return the product to
NICOR for inspection. Once veried to be covered by this limited warranty,
NICOR will, at its sole discretion, repair, replace, or refund the purchase
price of any product that does not conform to this limited warranty. If NICOR,
at its sole discretion, determines that the product should be repaired or
replaced, this warranty is limited to the reasonable, customary, and necessary
costs and expenses associated with the repair/replacement. This warranty
requires that all repair/replacement estimates and costs, including but not
limited to equipment rental (if any), and any other cost or expense to be
incurred in the repair/replacement of the product, be approved in advance and
in writing by NICOR.
FAILURE TO OBTAIN NICOR’S ADVANCE WRITTEN APPROVAL OF ALL REPAIR/REPLACEMENT COSTS AND EXPENSES IN WRITING SHALL VOID THIS LIMITED WARRANTY.
THIS LIMITED WARRANTY DOES NOT COVER THE FOLLOWING:
- Defects or damages resulting from improper installation, operation, storage, misuse or abuse, accident, or neglect;
- Defects or damages resulting from improper service, testing, adjustment, installation, maintenance, alteration, connection to out-of-specification electrical service, corrosive or damp environments, or connection to incompatible equipment or devices (e.g., connecting non-dimmable lighting products to dimmers);
- Damage which occurs in transit;
- Power surges or overheating due to external conditions
- Acts of nature including but not limited to lightning strikes
ANY IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE SHALL BE LIMITED TO
THE DURATION OF THIS LIMITED WARRANTY, OTHERWISE, THE REPAIR, REPLACEMENT, OR
REFUND AS PROVIDED UNDER THIS EXPRESS LIMITED WARRANTY IS THE EXCLUSIVE REMEDY
OF THE CONSUMER, AND IS PROVIDED IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED. IN NO EVENT SHALL NICOR BE LIABLE, WHETHER IN CONTRACT OR IN TORT
(INCLUDING NEGLIGENCE) FOR DAMAGES IN EXCESS OF THE PURCHASE PRICE OF THE
PRODUCT, OR FOR ANY INDIRECT, INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES OF
ANY KIND, OR LOSS OF REVENUE OR PROFITS, LOSS OF BUSINESS OR OTHER FINANCIAL
LOSS ARISING OUT OF OR IN CONNECTION WITH THE ABILITY OR INABILITY TO USE THE
PRODUCT TO THE FULL EXTENT THESE DAMAGES MAY BE DISCLAIMED BY LAW.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
SHARE YOUR EXPERIENCE WITH US
SCAN the QR or visit
www.nicorlighting.com/support/survey
FOLLOW US
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107
P: 800.821.6283
F: 800.892.8393
www.nicorlighting.com
September 30, 2019 1:29 PM rev 1.0
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>