iGPSPORT SRTL SR30 Radar Bike Rear Light User Manual

iGPSPORT SRTL SR30 Radar Bike Rear Light

Product Information

The product is a versatile electronic device designed to provide a range of functionalities. It features cutting-edge technology and a user-friendly interface for seamless operation.

Specifications

• Model: 14103511
• Power Source: Battery operated

FAQs

• Q: How do I replace the battery?
  • A: To replace the battery, (provide specific steps from user manual).
• Q: Can I connect the device to other devices?
  • A: Yes, you can connect the device to other compatible devices using (specify connectivity options).

INTRODUCTION

SRTL SR30 Smart Radar Tail Light is a safety auxiliary device which can detect vehicles within a certain range behind to realize two-way reminders and the coming vehicles for users. It contains a micro radar and a multi-mode controllable tail light, can actively detect the approaching vehicles within a certain range behind the rider, display them on the terminal device and actively remind the vehicles behind for riders. This device enhances detection of the environment but is not a substitute for the attention and judgment of the rider. Please keep your judgment on the road conditions at all times and ride safely. Failure to observe the relevant content carefully may result in serious accidents.

DEVICE OVERVIEW

Quick press to change the light modes Hold Seconds to restart the device

LED Working indicator| The color is changed based on the battery level, light mode and charging status.
Tail light| Multi-mode tail light, single press to change the light mode
Radar module| Built-in radar to monitor the moving objects behind

STATUS LED

remaining
Solid red| An error occurred.

You may need to restart the device

TAIL LIGHT MODE

*Single radar mode: Tail light is off, and only the radar is on normal working status.

RADAR DETECTION

1. Radar can detect approaching vehicles within a distance of about 140 meters.
2. The relative speed of approaching vehicles that can be detected by radar must be within 10km/h-160km/h( from 6 to 99mph).
   • Note: Radar will not detect vehicles moving at the same speed as you, or vehicles moving away from you.
3. The radar beam width is40° (-20°-20° ) in the horizontal direction.
4. Radar can detect up to eight approaching vehicles at most.
5. Radar detection can not be used indoor.

IN THE BOX

• Host X1
• Fixed seat X1
• Rubberpad X2
• Rubber band X2
• Lanyard X1
• Type-C charging cable X1

INSTALLATION INSTRUCTION

• Please select a suitable position to install the device to ensure that it will not affect your riding safety.
• Install the device at the appropriate height of the seat post to acquire the optimal detection range.
• The fixed seat shall be installed vertically and compatible with most seat post types and angles.
• Install the device correctly, making sure the device is facing backwards and perpendicular to the road.
• Make sure there is no obstruction in front of the device.

INSTALLATION INSTRUCTION

• Please select a suitable position to install the device to ensure that it will not affect your riding safety.
• Install the device at the appropriate height of the seat post to acquire the optimal detection range.
• The fixed seat shall be installed vertically and compatible with most seat post types and angles.
• Install the device correctly, making sure the device is facing backwards and perpendicular to the road.
• Make sure there is no obstruction in front of the device.

INSTALL THE FIXED SEAT

1. Please select the appropriate rubber mat based on the shape of your seat post and fix the mat on the back of the fixed seat
2. Place the fixed seat and rubber mat on the seat post.
3. Fix it with a rubber band.
4. Align the card tray on the back of the device with the card slot of the fixed seat and rotate it clockwise until the device is locked.

To prevent the device from falling, the lanyard can be installed together with the device.

DEVICE CHARGING

• Please open the waterproof cover on the USBsuriace and slowly insert the charging cable into the USB surface.
• Please keep the USB interface dry before charging to the prevent metal corrosion.
• Tighten the USB cover after charging to prevent water ingress or interface damage.

MAINTENANCE AND CLEANING OF THE DEVICE

• Avoid using organic solvents, chemicals, or repellents, because it may cause damage to parts of the device.
• Try to avoid violent impact or rough use because it may shorten the life of the products.
• Please do not use any cloth or other materials that may scratch the optical lenses. Scratches may give rise to a decline in the performance of the radar detection.
• Regular cleaning of mud or dirt on the device can extend the life of your device.

PRODUCT SPECIFICATION

Product parameters are laboratory test results, the actual use is affected by environmental factors, the actual results shall prevail.
The BLE and ANT+ wireless protocols are used to connect this device with the iGPSPORT cycling computer and app.

SAFETY AND PRODUCT INFORMATION

SAFETY AND PRODUCT INFORMATION NOTICES

Warning

If the radar device does not send radar detection information to the display device, it is recommended that you stop riding and check the device in a safe place to ensure riding safety, please turn off the two devices, and then try to connect after restarting.
The display device interface is for illustrative purposes only, and the specific display form is subject to the mark on the display device.

Riding warning

1. Be sure to keep your best sense of the attention and judgement and ride in the safest way.
2. Please make sure that your bike and all components are well maintained and all parts are installed correctly.

Distraction warning

1. The device can improve your riding experience if used properly; you may be distracted by the screen and suffer from severe injury or death of the device is used improperly.
2. Just check the information quickly and keep your attention on the surroundings at all the times. Do not keep staring at the display or be distracted by it.
3. Paying excessive attention to the screen display may lead to your neglect of the obstacles or dangers. You will take risks for all the serious consequence arising therefrom, therefore, please use this device in an appropriate and careful manner.

Battery Warning

1. The product has a rechargeable lithium battery.
2. Failure to follow the instructions listed below may shorten the battery’s shelf life, damage the device, or cause fire, chemical burns, electrolyte leakage, or the risk of injury.
3. Do not disassemble,modify, puncture, or damage the device or the battery violently.
4. So not expose the device or the battery to fire,explosion, or other hazards.
5. Do not place or store the device near a dryer, in a car under direct sunlight, or in the other high-temperature environments.
6. Do not immerse the battery in water or other liquids.

CONTACT US

• www.igpsport.com
• Wuhan Qiwu Technology Co., Ltd.
• 3/F Creative Workshop, No.04 District D Creative World, No.16 West Yezhihu Road, Hongshan District, Wuhan, Hubei, China.
• (86)027-87835568
• service@igpsport.com

Disclaimer:

This user manual is for users reference only. If there is any difference between the device and the manual, please subject to the device. We will not notify otherwise.

CE Warning:

1. CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDINGTO THE INSTRUCTIONS.
2. The product shall only be connected to a USB-C interface of version USB2.0.
3. Operation temperature:- 20~60°C.

Wuhan Qiwu Technology Co.,Ltd. hereby declares that this SMART RADAR TAILLIGHT is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.

This information has to be presented in such a way that the user can readily understand it. Typically, this will necessitate translation into every local language (required by national consumer laws) of the markets where the equipment is intended to be sold. Illustrations, pictograms and using international abbreviations for country names may help reduce the need for translation.

EU Declaration of Conformity

We,

Wuhan Qiwu Technology Co.,Ltd.( 3 / F, Creative workshop, No.04, District D, Creative world, No.16 Yezhihu West Road, Hongshan District, Wuhan City, Hubei Province, China.) hereby declares that this SMART RADAR TAILLIGHT is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. According to Article 10(2) of Directive 2014/53/EU, the SMART RADAR TAILLIGHTR can be used in Europe without restriction.

Function

|

Operation Frequency

| Max RF

output power:

|

Limit

---|---|---|---
BLE| 2402MHz-2480MHz| -1.57 dBm| 20 dBm.
ANT+| 2457MHz| -1.86 dBm| 20 dBm.
24G Radar| 24.025GHz-24-225GHz| -26.355 dBm| 20 dBm.

FCC STATEMENT

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference
2. this device must accept any interference received, including interference that may cause undesired operation.

This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

WUHAN QIWU TECHNOLOGY CO.,LTD.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>