303031 Frukost Long Slot Toaster User Manual

303031 Frukost Long Slot Toaster

Specifications

• Power supply: 220-240V AC 50/60Hz
• Power consumption : 1000W
• Ambient temperature: Suitable for indoor use

Current drivers, user manuals and other relevant documents for this product can be found on our homepage.

CAUTION! Important safety guidelines for this appliance

• Please read the following user manual carefully and ensure that you understand the instructions.

• Operate the toaster under the voltage specified on the device identification label.

• Do not touch the surface when in operation under any circumstances. There is a risk of burns!

• To protect against electric shock, please do not immerse the cable, the plug or any part of the device in water or in any other liquid.

• Supervision is necessary when the device is being used by children or being used in the vicinity of children.

• Remove the plug from the power socket when the device is not in use or when you intend to clean it.

• Do not use this device with a damaged cable or plug, or when in a faulty condition. If the power cord is damaged, it has to be replaced by the manufacturer, a customer service agency or an adequately qualified person.

• Keep the power cord away from hot surfaces. Never let the power cord hang over the edge of a table.

• The device must not be kept or used on or near hot surfaces
  (such as, for example, hotplates) or open gas flames.

• Use the product only for intended applications.

• The introduction of any other material, such as metal foils or other utensils, is strictly prohibited, as this could lead to fire or electric shock. Use the device only to brown toasted bread and bread slices or to warm up bread rolls.

• Bread may burn if it is toasted several times, or touches one of the heating elements. Therefore, never place the device close to or below flammable materials. The device must be kept under constant supervision when in operation.

• The use of accessories that are not recommended by the manufacturer of the device could lead to injuries.

• Always keep the toaster on a heat-resistant and level surface. Ensure that the toaster does not topple over!

• Immediately remove the power plug from the power socket if you notice smoke or fire!

• Do not insert fingers or objects into the long slot under any circumstances. The heating elements conduct voltage! There is a risk of injury!

• Make sure that you remove the bread very carefully after toasting is complete, to avoid injury.

• Do not use this device with external timers or separate remote controls.

• Children should be supervised to ensure that they do not play with the device.

• This device may be used by chil-dren above the age of 8 years and by persons with impaired physical, sensory or mental capabilities or lack of experience and knowledge, only if they are supervised or have been instructed about the use of the device and have understood the hazards involved. Cleaning and user maintenance should not be performed by children.

• Keep the device and the power cord out of the reach of children below 8 years of age.

• Do not use the toaster outdoors!

• The toaster is suitable for use in households and similar environments, such as, for example:

  • staff kitchens in businesses, offices and other working environments
  • on farms
  • by customers in hotels, inns and other residential areas
  • in guest houses.

• Read through the user manual carefully and keep it in a safe place, as it contains important details!

• Use only standard toast sizes. If the toast is too small, you may burn your fingers when removing the toast!

Thank you for choosing an Arendo product. Please read the following user manual carefully so that you can enjoy your purchased product for a long time. Before using the delivered product, check that it is complete, faultless and undamaged.

Scope of delivery

•  Long-slot toaster
• User manual

Technical data

• Defrosting mode

• Function for reheating already toasted bread/toast

• Crumb collector

• integrated bread roll warming rack

• LED display for the remaining time

Initial use

Note: The toaster may emit a burning smell when it is being used for the first time while the heating elements are warming up. This is not a hazard or a defect. When using the toaster for the first time, wait until the device has heated up and the smell has disappeared. When using the toaster for the first time, it is advisable to switch on the toaster without inserting any toast.

When the device is put into operation for the first time, check the intactness of the product or components and their function again. Take the device out of the package and remove all the packaging material. Before using the toaster for the first use time, connect it to a properly wired power socket. Set the rotary switch which has been provided for adjusting the degree of browning to the highest setting and switch on the toaster by pressing the slide switch down.
Repeat this procedure until the burning smell is no longer noticeable. To interrupt toasting, press the “CANCEL” button.

Product details

Commissioning and use

• Connect the power cord to a properly wired power socket. First, proceed as described in Section “3 Commissioning”.
• Ensure that the power plug has been inserted. Insert up to two toast slices into the toast slot. Turn the “rotary switch provided for adjusting the degree of toasting” to the desired setting and press the “slide switch” down until it snaps in place. The heating elements warm up and the toasting process begins.
• Once the process is complete, the “slide switch” automatically jumps back to its original position. This means that the toasting process has finished and the bread slices can be taken out carefully.
• If the degree of toasting is not satisfactory, adjust it using the “rotary switch provided for adjusting the degree of toasting” and repeat the toasting. In this case, ensure that the toast does not get burnt. If the desired degree of  toasting has already been attained, you may then end the process at any time by pressing the “CANCEL” key.

Bread roll warming rack

Bread rolls, baguettes and loaves are too large to place in the toasting slot. Always use the integrated bread roll warming rack for this purpose. Use the lever for the bread roll warming rack to open it.
Note: Ensure that the crumb collector has been inserted correctly.

• Before toasting on the bread roll warming rack, ensure that the toaster has cooled down completely. Ensure that no toast has been inserted into the “toast slot” when using the bread roll warming rack, as otherwise, this can result in fire.
• If you do not wish to use the bread roll warming rack, remove it by folding it.
• Generally, more time is required to achieve the desired degree of browning when using the bread roll warming rack. It is also advisable to turn the items on the bread roll warming rack.

Adjusting the Degree of toasting

The “rotary switch provided for adjusting the degree of toasting” allows you to specify the duration after which the toaster should automatically shut down. The longer the device is switched on, the darker will be the bread at the end of the browning time.

Note: In order to get optimal browning results, we recommend that you use only settings 1 to 4 for toast and sandwiches. The higher browning settings 5-6 should be used only if, for example, you want to use the bead roll warming rack for baguettes, bagels or rolls, since otherwise roasted toasts and sandwiches may get burnt quickly at the higher settings.

Reheating

The toaster can be used to reheat the bread slices if they cool down too quickly. To do this, press down the “slide switch” until it clicks in place and press the “REHEAT” button. When bread which has already been toasted becomes too cool or has been forgotten about, the toaster can be used to reheat it without affecting the degree of browning too much.

Defrosting

Frozen toast bread can be defrosted directly in the toaster. To do this, insert the frozen toast into the “toast slot” and then press down the “slide switch” until it reaches the limit stop. Switch the device to the defrosting mode using the “DE-FROST” button. To set the duration of the defrosting process, use the rotary switch provided for adjusting the degree of browning.

Interrupting the toasting
If the bread starts to smoke or you want to stop the toasting process, you can press the “CANCEL” button. In this case, the toaster interrupts the toasting process immediately.

Cleaning and care

• Before cleaning the toaster, unplug it completely from the mains by removing the power plug. Wait until the device has cooled down completely. Clean only the sur-face with a slightly damp cloth. Never use a metal polish for this

• purpose! Do not immerse the device in water under any circumstances!

• Ensure that crumbs do not collect in the toaster. Bread crumbs can be removed by taking the crumb collector out of the toaster and cleaning it with a damp cloth. Ensure that you afterwards re-insert the crumb collector correctly.
  Caution! Remember to empty the crumb collector regularly. If a large amount of crumbs are allowed to build up, this may lead to a fire! It is also advis-able to turn the toaster upside down and shake it, since crumbs may accumulate outside the crumb collector in case of frequent use.

• The internal components of the toaster can be easily damaged. Do not touch the components with tools or other objects under any circumstances!

Troubleshooting

The toaster does not function

| Insert the mains plug into the power socket If there is no improvement, have the device checked by a specialist!
The toast is too bright or too dark after toasting| ****

Select a different degree of browning.

Smoke is emitted from the toaster during toasting| • The degree of browning you have selected is too high for the type of bread used. Immediately press the “CANCEL” button to stop toasting.

• The toaster is dirty. A piece of toast has been caught in the heating surfaces. Clean the device

• The crumb collector is overfull and crumbs begin to smoke. Empty the collector!

The toast is imme- diately ejected after toasting has started| Ensure that you have engaged the slide switch correctly in the lowest position. If the device still ejects the toast in the same way at the next attempt, please contact a technician or the manufacturer of the device.
The power cord is damaged| In this case, you should no longer use the device! Contact an authorised technician or the manufactur- er of the device, in order to have the cable properly replaced!

Safety instructions and disclaimer

Please do not try to open the device to carry out repairs or modifications. Avoid contact with the mains voltage. Do not short-circuit the product. The device is not waterproof, therefore please use it only in dry surroundings. Protect it from high humidity, water and snow. Do not expose the device to high temperatures.

Do not expose the device to sudden changes in temperature or heavy vibrations, as this could damage the electronic components. Check the device for damage before using it. The device should not be used if it has been subject to impact or has been damaged in some other manner. Please comply with the local regulations and restrictions. Do not use the device for purposes other than those described in the user manual.
This product is not a toy. Keep it out of the reach of children or mentally disabled persons. Any repair or modification to the device not carried out by the original supplier will void any warranty and guarantee claims. The device should be used only by persons who have read and understood this user manual. The specifications of the device may be changed without special prior notice.

Disposal instructions

In line with the European WEEE directive, electrical and electronic devices should not be disposed of along with domestic waste. Their components have to be sent separately for recycling or disposal, as improper disposal of toxic and dangerous components may permanently damage the environment. According to the elec-trical and Electronic Equipment Act (ElektroG), you are obliged (as a consumer) to return (free of charge) all electrical and electronic devices to the manufacturer, the point of sale or public collection points at the end of their service life. The relevant local laws regulate the details in this regard. The symbol on the product, in the user manual or/and the packaging refers to these regulations. With this manner of sorting, recycling and disposal of used devices, you make an important contribution towards protecting our environment. For information on authorised collection points in your area, please contact your local city or municipal administration.

• WEEE directive 2012/19/EU
• WEEE Register no.: DE 67896761

The company WD Plus GmbH hereby certifies that the device 303031; 303089; 303095; 303836; 303837; 304574; 304591; 305302; 305303; 305299 complies with the fundamental requirements and the other relevant stipulations of the directive. A complete conformity statement can be obtained from: WD Plus GmbH, Wohlenbergstraße 16, 30179 Hannover

SCANNER

https://model.ganzeinfach.de/303031

FAQ

• Q: What should I do if the toaster shows no function?
  • A: Check the power connection and ensure the device is properly plugged in. If the issue persists, contact customer support.
• Q: How can I prevent toast from being immediately ejected after starting the toasting process?
  • A: Make sure the toaster is properly warmed up before inserting toast slices and starting the toasting process.

CONTACT US

• feedback@ganzeinfach.de
• (UK) +49 511 / 13221 720
• MO-FR 9:30am – 18pm CET
• www.arendo.de
• WD Plus GmbH
• Wohlenbergstraße 16 30179 Hannover, DE V

References

• Arendo
• Drivers, manuals, data sheets for our products

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>