Fosgoit Gesture Sensing RC Stunt Car User Manual

Table of Contents

Specifications

Switch Functions

Transformation Activation

If the car is inactive for 50 seconds, it will enter sleep mode automatically. Restart the car to repair it.

On-road Mode Activation

Press the finger sensor and tilt down to activate on-road mode.

Pairing Instructions

Insert batteries into the remote control and car, ensuring the indicator light flashes.
Switch on the car to initiate pairing. If successful, the controller light will turn off.
Each remote control can only pair with one car at a time to avoid signal interference.
If the connection is lost, reset the power switch to re-establish the frequency connection.

Q: How do I know if the pairing was successful?
A : The indicator light on the remote control will not flash if the pairing is successful.
Q : Can multiple cars be connected simultaneously?
A: No, each remote control can only pair with one car at a time to prevent signal interference.

Switch Functions

Operating the Watch

Four lights are on: Tilt forward to go forward; backward to reverse; right to turn right; left to turn left.
Tilt 45° to the right—for right horizontal movement.
Tilt 45° to the left—for left horizontal movement.
Tilt 60° to the right—for right rotation.
Tilt 60° to the left—for left rotation.
Four lights flash: For snake-like movement, forward/backward or sidesteps to the left/right.
Two indicator lights flash: Transformation mode activated.
Press the switch once: Car lights off.
Long press the switch: Power off.

Battery Charging:
When charging the 3.7V battery, the charger indicator will be red. Once fully charged, the red light turns off.

WATCH REMOTE CONTROL OPERATION DIAGRAM

Fosgoit-Gesture-Sensing-RC-Stunt-Car-fig-2

Pressing the Sensor to Enable Transformation

Fosgoit-Gesture-Sensing-RC-Stunt-Car-fig-3

Press the Sensor to Switch Modes

Fosgoit-Gesture-Sensing-RC-Stunt-Car-fig-4

After inserting the batteries into the remote control and seeing the indicator light flash, place the batteries in the car and switch it on to initiate pairing. If successful, the indicator light on the controller will turn off . Note: Repeat the above steps if pairing is not successful.
Each remote control can only be paired with one car at a time, ensuring that multiple cars do not interfere with each other’s signals. Note : Multiple cars cannot be connected simultaneously.
If the remote control does not detect the 2.4G signal from the car within one minute, the power indicator will flash, indicating the need to reset the power switch to re-establish the frequency connection.
To pair the remote control with other car models or to re-pair with the same car, turn off both the remote control and the car. This will reset the pairing process.

The remote control does not have an indicator for unsuccessful pairing attempts. If pairing is successful, the indicator light will not flash.

Fosgoit-Gesture-Sensing-RC-Stunt-Car-fig-6

For the Remote Control

Open the battery compartment cover of the remote control and insert 2 x 1.5V AA batteries according to the polarity indications (+/-) inside the battery compartment.
Close the battery compartment cover.

Fosgoit-Gesture-Sensing-RC-Stunt-Car-fig-7