PHILIPS PPM4331 Abdominal Massage Belt User Guide
- May 15, 2024
- Philips
Table of Contents
PHILIPS PPM4331 Abdominal Massage Belt
Instruction For Use
-
Insert the controller along the guide rail and fix it tightly on the massager.
Note: If the controller is not installed on the massager, is not installed in place, or is no-load for 1 minute, it will enter the standby state by default and automatically shut down after the voice prompts 11Turn off massager” -
Place the massager around the abdomen. Due to the large massage area, appropriate space needs to be reserved when standing and wearing it.
The purpose of loose fitting is to leave room for movement. If it is completely tightened, it will cause discomfort when sitting down. -
Press and hold the operation button for more than 2 seconds to turn on the massager. After power on, it will enter heating at 40°(, Mode 1 (abdominal strengthening) and intensity Level 1 by default, with a voice prompt of
“Turn on massager”. -
In the power-on state, press the operation button to switch the modes, and there are six modes to switch in turn: abdominal strengthening (M1), tapping (M2), kneading (M3), exercise (M4), massage (MS), relaxation (M6) and massage off. The screen will light up the corresponding massage mode with voice prompts.
-
After selecting the massage mode, press the “+” and ” – ” buttons to adjust the massage intensities. The intensity increases or decreases in Level 1 to Level 16. When adjusting, the screen displays the corresponding intensity level with voice prompts.
-
Press the temperature button to adjust the hot compress levels. There are 3 levels of hot compress to switch in turn: 40°(, 45°(, 50°( and heating off. The light bar lights up in different colors corresponding to temperatures with voice prompts.
-
In the power-on state, press and hold the operation button for more than 2 seconds to turn it off with the voice prompt of “Turn off massager”.
-
When the battery remaining capacity is lower than 10%, the red light bar will flash quickly for 5 seconds, with a voice prompt of “the battery power is low, please charge it in time”, and the device will be powered off.
-
Insert the Type-C cable connector into the charging port at the bottom of controller for charging. During charging, the indicator light flashes green slowly. When the massager is fully charged, the green indicator remains on.
-
The device is set to automatically shut down after 15 minutes. Adjust the quantity and frequency of use according to the status of your waist and abdomen.
-
During exercise, the controller needs to be removed. EMS and hot compress functions cannot be used. It can be used to concentrate heat and promote sweating. After exercising, you need to start from intensity Level 1 when using the EMS function.
-
Since the skin on the abdomen is relatively sensitive, it is recommended to wear clothes when using the hot compress function at 45°( and above to prevent burns.
-
It is recommended to select intensity Level 1 and hot compress at 40°( in the initial stage. After use, the skin on your waist and abdomen may become red for a short time, which can be relieved after a period of time. If this symptom continues and cannot be relieved, please consult a surgeon.
-
In case of any skin or abdominal problems during use, please stop using this product immediately and consult a doctor.
Customer Support
Visit us
www.philips.com
There may be certain differences between the content of this manual and your
product. Please refer to the actual product. We reserve the right to update
the product at anytime without prior notice.
© 2023 AquaShield
All rights reserved
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke
Philips NV. and are used under license.
This product has been manufactured by and is sold under the responsibility of
Guangdong Deerma Technology Company Limited and Guangdong Deerma
Technology Company Limited is the warrantor in relation to this product. Made
in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>