neovo FMC-06 Floor Mounting Cart Installation Guide
- June 4, 2024
- neovo
Table of Contents
FMC-06
Installation Manual
**Floor mounting cart
**
FMC-06 Installation manual
- To ensure using the stand correctly and safely, please read this manual carefully before installation.
- This model is recommended to be used for 55-86 inch interactive flat panel.
- Maximum load capacity: 100KG.
- Bill of materials:
Other accessories (in mm):
1. Cross recessed pocket hex head screw (including positioning pre-lock bolt|
M8×25| 14pcs|
---|---|---|---
2. M12 spring pad| | 4pcs
3. M6 screw (on wall han| M6×130| 2pcs
Phillips screwdriver (self-provided)ging strip)| | 1pcs
Adjustable wrench (self-provided)| | 1pc
Step 1 : Adjust the wheel to the brake state and screw it into the leg ( Figure 1).
Step 2: Attach the wall bracket to the end leg (Figure 2).
Step 3: Attach the other leg on the other end of the wall bracket (Figure 3).
Step 4: Assemble the tray between the two columns (Figure4).
Step 5 : According to the actual requirements of the whole machine, lock the wall hanging strip on the whole machine (Figure 5).
Step 6: The assembled machine will be hung on the wall bracket and the safety
screw of the wall hanging strip will be locked ( Figure 6).
Make sure the brakes are locked. This step requires at least 2 professionals
to complete.
Remarks: In some cases, the machine’s wall mount bracket don’t match with wall
mount of the stand, and need to be adjusted with the wall mount together.
Following is the adjusting process:
-
Lock the wall hanging board to the wall bracket
-
Hang the machine on the wall hanging and lock the safety bolts
Step 7: After the assembly is completed, refer to the figure below.
FMC-06_User Manual_V011
Documents / Resources
|
neovo FMC-06 Floor Mounting
Cart
[pdf] Installation Guide
FMC-06 Floor Mounting Cart, FMC-06, Floor Mounting Cart
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>