CEETSS-0034 6 inch Black Aluminum Alloy Running Boards Side Step Nerf Bar User Guide

CARE AND USE INSTRUCTIONS
C- 0034

CEETSS-0034 6 inch Black Aluminum Alloy Running Boards Side Step Nerf

Bar

Tools Required
13mm Socket
Ratchet
Torque Wrench

Notes
Read this instruction carefully before starting installation.
Proper tools will improve the quality of installation and reduce the time required.
If missing parts or any damage found. please take a picture. and contact us.

Step 1:

1. Locate (3) mounting positions on each side inner rocker panel.
2. Clean the factory painting on mounting studs.
3. Clean the sealant and dirt around mounting positions.

Step 2:

1. Attach proper bracket to the factory studs oninner rocker panel .
2. Secure the bracket using (3) M8 flat washers, (3) M8 lock washers, (3) M8 hex bolts.
3. Repeat to install all brackets.

Step 3:

1. Remove (6) M8 hex bolts and (6) M8 flat washers behind the step bar.
2. Slide mounting tracks to proper positions.
3. With assistance, lift and attach the step bar to brackets. Secure the step bar on brackets with (6) M8 hex bolts and (6) M8 flat washers.
4. Repeat to install the other side step bar.
   Do not fully tighten.

Step 4:

1. Tighten M8 hex nuts on vehicle with 15 ft. lbs. torque.
2. Adjust the step bar to level and tighten M8 hex bolts with 15 ft. lbs. torque.
3. After the step bar installed. periodic check to ensure all mounting hardware remains secure and tight.

Part List:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>