Kolcraft SN009-SPE Sesame Street Cookie Monster Terrific 3 in 1 Potty Training Chair User Manual
- May 15, 2024
- Kolcraft
Table of Contents
SN009-SPE Sesame Street Cookie Monster Terrific 3 in 1 Potty Training
Chair
Scan for instructional video
https://l.ead.me/bcAxOW
Models #: SN009-SPE / SN009-SPC
F011-R6 01/2023
WARNING
Read all instructions BEFORE assembly and USE of this product. Failure to follow warnings and instructions could result in injury or death to your child. Adult assembly required. Keep instructions for future use.
-
This product is for use by children ages 18 months and up.
-
Do not exceed 40 lbs. / 18 kg. on the potty seat and trainer.
-
Do not exceed 200 lbs. / 90 kg. on the step stool.
-
FALL HAZARD:
– Never leave child unattended.
– Do not lift product while child is on it.
– Do not use potty seat on cushioned toilet seats; potty seat may not secure properly or potty seat could damage toilet seat.
– Do not use potty chair seat as a step stool. Follow instructions to properly use the step stool.
– Always use potty seat on a level surface. -
Do not lift or carry product by the lid or flush handle.
-
Do not submerge electronics into water.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there isno guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or experienced radio / TV technician for help.
Note: Changes or modifications not expressively approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.
CAUTION
To prevent battery leaks, which can burn skin and eyes:
- Remove batteries when storing product for a long time.
- Dispose of used batteries immediately.
- Always replace the entire set of batteries at one time.
- Never mix old and new batteries, or batteries of different brands or types.
PARTS LIST
How to Clean the Unit
Wipe the potty with a cloth using soap and water.
Do not immerse tank into water.
If product is broken or damaged, contact Kolcraft Enterprises, Inc. Consumer
Services
Department at 1-800-453-7673.
Sesame Street® and associated characters, trademarks and design elements are
owned and licensed by Sesame Workshop. ™/© 2023 Sesame Workshop. All rights
Reserved.
How to Install Batteries
-
Unscrew the battery door on the top of the step stool lid with a Phillips screwdriver.
-
Insert 2 new “AA” batteries as shown.
Replace battery door and tighten the screw.
NOTE: The battery door is designed so that it only fits in the correct orientation. -
The potty has 2 volume levels. Move switch, located near the speaker, to the middle position for low volume and to the far right for high volume. To turn off, move switch to “O” position, on the far left.
How To Assemble Potty Seat
-
Place waste tub inside the base with the carry handle facing forward.
-
Align the seat into the base by inserting the four tabs into the holes.
-
Insert the lid into the base with Elmo facing forward.
Push down until it locks into place. Pull up to ensure the lid is securely locked in place.
How to Use on an Adult Toilet
- Remove the potty seat by lifting upward.
- Place the seat on the adult toilet ensuring that the tabs fit inside the rim of the toilet. Make sure the seat is level on the toilet and fits snugly within toilet seat opening without tipping.
CAUTION: If seat does not fit snugly on toilet, DO NOT USE.
How to Use as a Step Stool
- To use as a step stool, close the lid – you will hear a clicking sound as you push down on the lid. The step stool can be used with or without the seat and waste tub in the base.
Please direct any comments, questions or replacement part requests to:
Kolcraft® Consumer Service Department
1100 W Monroe St. Chicago, IL 60607
1-800-453-7673 in U.S.,
1-312-361-6315 outside U.S.
8 am-5 pm (CT) Monday – Thursday, 8 am – 3 pm Friday (CT)
e-mail: customerservice@kolcraft.com
Consumer Service: 1.800.453.7673
www.kolcraft.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>