Day-Brite CFI 2×2 DuaLED Recessed Surface Mount Installation Guide
- May 15, 2024
- Day-Brite CFI
Table of Contents
Day-Brite CFI 2×2 DuaLED Recessed Surface Mount Installation Guide
INSTALLATION INSTRUCTIONS
CAUTION: THE INSTALLATION AND SERVICING OF THIS PRODUCT SHOULD BE
PERFORMED BY A QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL
- ACCESS TO WIRING COMPARTMENT IS ACCOMPLISHED BY REMOVAL OF BOTH LENSES AND WIRING COVER. SEE ILLUSTRATIONS BELOW FOR DETAILS.
- REMOVE LENSES BY FLEXING THEM UNTIL THEY BECOME FREE OF THE HOUSING & WIRING COVER. MAKE SURE WHEN REINSTALLING THE LENSES, THAT THE GLOSSY SIDE OF THE LENS IS INWARD TOWARD LED LAMPS.
- REMOVE THE WIRING COVER BY PRYING UPPER EDGE AWAY FROM HOUSING ON BOTH SIDES UNTIL THE COVER IS FREE OF THE 2 MOUNTING STUDS AT EACH END. TO REINSTALL THE COVER, SPRING IT OVER THE 2 STUDS AT EACH END UNTIL COVER IS CENTERED AND FULLY SEATED
CAUTION: Electrical luminaires are designed for permanent installation in ordinary (Non-Hazardous) locations in accordance with the National Electrical Code and all applicable local codes. Do not use in areas of limited ventilation or in high ambient enclosures. The lamp and luminaire operate at high temperatures, contact with combustible materials can cause fire and personal contact can cause severe burns..
CAUTION: THE INSTALLATION AND SERVICING OF THIS PRODUCT SHOULD BE PERFORMED BY A QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL
Signify North America Corporation 200 Franklin Square Drive Somerset, NJ
08873, USA
Phone: 855-486-2216
www.day-brite.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>