Ibanez 88932 Pentatone Wqualizer Bax Music Owner’s Manual
- May 15, 2024
- Ibanez
Table of Contents
PENTATONE
EQUALIZER
OWNER’S MANUAL
88932 Pentatone Wqualizer Bax Music
Before using this device, be sure to read this manual thoroughly for safe use
of it.
After that, keep this manual in a safe place and read it whenever necessary.
Safety Precautions === Be sure to observe the following precautions ===
In order to use this device properly, the contents to be observed are
explained, classified as follows.
• The severities of the injury and damage due to incorrect usage by ignoring
the written contents are explained by the following classified indications.
Warnings| Indicates a potentially hazardous situation which, if not
avoided, will result in death or serious injury.
---|---
Cautions| Indicates a potentially hazardous situation which, if not
avoided, will result in injury or property damage.
• The contents to be observed are explained, being classified by the following
pictograms.
…This pictogram shows a compulsory action, something that you must do.
…This pictogram shows a prohibition, something that you must not do.
…This pictogram shows a notice, something that you need to be alerted to.
Warnings
| Never disassemble or modify the device.
---|---
| In case of an abnormality such as smoke, burning smell or abnormal sound,
immediately stop using the device.
Immediately unplug the AC adapter from the outlet.
| Do not operate with wet hands.
<>
Cautions
| Be sure to use the specified AC adapter.
<
---|---
| Do not store or use the device in places such as a bath or outdoors where
water splashes. Also do not use it in places of high humidity, places with a
lot of dust, or at high temperatures.
<<A fire, an electric shock or a failure may occur.>>
| Do not store in places of excessive vibrations. <
| When not in use for a long time, be sure to unplug the AC adapter from the
outlet for safety. <>
| Do not apply excess force, drop nor give strong physical impact.
<>
| Do not use thinner, alcohol, and the l ke for cleaning.
<
= = = = Observe the following instructions with a product that uses a battery
= = = =
Warnings
| Do not throw a battery into a fire.
<<A burst, heat generation and a fire may occur.>>
---|---
Cautions
| Mount a battery with its polarities +/- set correctly.
<
---|---
| Remove the battery when not in use for a long time.
<
SPECIFICATIONS
| Input Impedance | 470k ohms |
|---|---|
| Output Impedance | 100 ohms |
| Maximum Output Level | +15.3 dBu |
| Power Supply | One 9 volt battery (006P) or external AC adapter (Use DC9V ) |
| Required Current | 125 mA©9V |
| Size [mm] | 100 (W) x 123 (D) x 63 (H) |
| Size [inch] | 3.9 (W) x 4.8 (D) x 2.5 (H) |
| Weight | 690g, 1.5Ibs (Including Battery) |
CHANGING THE BATTERY
-
Replace the battery with a 006P 9 volt battery ONLY.
-
When opening the rear panel for battery replacement, make sure the AC adapter is not connected. When the rear panel is opened, PCB (green board on which parts are soldered) appears. Do not touch this board with a conductor such as metal or it may cause damage to the equipment or electric shock.
1. Remove the four screws of the rear panel with a Phillips-head screwdriver.
2. Connect the new battery and place it in the case. (See Figure A) -
Unplug the instrument when not in use to prolong the battery life.
-
When battery power is running low, LEDs on the top panel gets dim or does not light. Replace the battery.
https://www.ibanez.com/world/support/manual/
|
---|---
http://www.hoshinogakki.co.jp/pdf/ibanez/manual/en/electronics/PTEQ.pdf|
http://www.hoshinogakki.co.jp/pdf/ibanez/manual/cn/electronics/PTEQ.pdf
OPERATION
-
On/off switch: Turns the 5-BAND EQ function on/off. When the 5-BAND EQ is turned on, blue LEDs on the sliders light up.
-
Q: The Q knob controls the frequency bandwidth boosted or cut by the equalizer in each band. Centered on the selected frequency, turning the Q knob fully counterclockwise gets the widest bandwidth, and turning it fully clockwise gets the narrowest bandwidth.
-
Frequency: Selects the center frequency of each band to be boosted or cut. Regarding the frequency range of each band, refer to the specification table.
-
Slider: Controls the amount of boost or cut that applied to each frequency band. Each slider provides boost or cut up to ±10dB.
-
LEVEL: Controls the overall output volume.
-
INPUT: Connects an instrument, such as a guitar or the output of another effect device via a shielded cable.
Plugging into this jack automatically puts power to the unit. -
EXT DC input: Be sure to use a center negative external DC 9V power supply. (AC/DC adapter etc.)
When using this jack, the internal battery is switched off. -
OUTPUT: Connects an amp or another effect pedal, via a shielded cable.
SPECIFICATIONS OF 5-BAND EQ
| Freq. band | Low | Low mid | Mid | High mid | High |
|---|---|---|---|---|---|
| Max. | 100Hz | 360Hz | 1.3kHz | 4.0kHz | 14.5kHz |
| Center | 80Hz | 250Hz | 780Hz | 2.4kHz | 7.0kHz |
| Min. | 30Hz | 85Hz | 200Hz | 620Hz | 1.5kHz |
HOSHINO GAKKI CO., LTD.
No.22, 3-Chome, Shumoku-Cho,
Higashi-Ku, Nagoya, Aichi, JAPAN
© HOSHINO GAKKI CO., LTD.
PRINTED IN CHINA SEP231233
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>