TOMOKA 2023 Soft Roll Up Truck Bed Tonneau Cover Installation Guide
- May 15, 2024
- TOMOKA
Table of Contents
TOMOKA 2023 Soft Roll Up Truck Bed Tonneau Cover Installation Guide
WARNING:
Tighten clamps securely on side rails before driving vehicle, to prevent cover
from blowing off!
01. Parts included in the Assembly:
02. INSTALLITION STEPS:
1-1. Check Contents of carton with the list above.
1-2. There are 3 Factory Bolts under the truck rail of each side. Unscrew the
Factory
Bolts that exist on the truck bed.(Need T30 head to remove the Factory Bolts)
2. Wipe and clean the tonneau before installation. If there is a gap between the front and side of bulkhead, adhere the seal strip(D) to the front bulkhead and align both ends equally.
3. Put the Tono Trap on the bed front rail.
4. Put the side Rails on each side of truck bed rail.
5. Place one side rail (B/C) on the truck bed and slide into the channel of cover assembly (A), proceed to tighten the set screws on both corners to secure the connection, Repeat the same process for the other side.
8. Roll the Tono Tarp to the truck tailgate, check and make sure the Plastic
Knob on the Rear Bar can lean against the Side Rail Locking Base (The Locking
Base is on the rear end of Side Rail).
In order to properly secure the cover, the gap between the side rail and
locking clip needs to be less than 1/16″. The empennage of cover will be
bounced if the gap is too large. In this case, please adjust the position of
the side rails.
11. To open the cover, open the truck bed tailgate, pull the handle in the middle of the cover Rear Bar, Unlock the bar, roll up the whole cover to the front of truck bed, then use the buckles to secure the rolled tarp.
TENSION CONTROL SYSTEM
CLEANING AND MAINTENANCE
CLEANING
- Clean the cover and vehicle in a shaded place like under a tree or in an open garage.
- Flood the cover with water to remove surface grit that will scratch the finish when wiped.
- Wash the cover with cool, clean water and a mild soap. Use a hose, rinse the cover well, making sure to remove all traces of soap and wipe off excess water using a sponge.
- Hose down the entire truck to prevent soap from streaking your truck’s paint finish. Do not use chemicals like detergents, dish washing liquids, bleaches, harsh cleansers, strong cleaners, dry-cleaning solvents, or any other strong chemicals as a cleanser.
- Using a white all-cotton towel, wash the entire cover with the cleaner. Never spot clean the cover to avoid rings or bright spots on the product. Make sure that you only use a soft cotton cloth or sponge as a cleaning tool.
- Do not use rough, abrasive cleaning pads because these can scratch the vinyl, creating pores that allow dirt and other unwanted particles to stick.
- Do not use vinyl protectants that contain petroleum, silicone, or citrus-based additives.
WARNING-CARE OF THE COVER TARP
Do not use cleaners for plastic or detergents. Clean the tarp with neutral
soap and water.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>