PERKO 1355-1358 Series Dimmer Compatible L.E.D. Surface Mount Dome Light Instruction Manual
- June 4, 2024
- PERKO
Table of Contents
PERKO 1355-1358 Series Dimmer Compatible L.E.D. Surface Mount Dome Light
The above lights are not designed for navigational use.
MOUNTING INFORMATION
Read all instructions before proceeding.
- These lights are supplied with the proper circuit for operation on a nominally 12-volt system.
- These lights contain no user-serviceable components.
- Carefully pry off the lens. Place the fixture against the mounting surface and mark through the screw holes in the back plate. (Screw holes are 2-3/8” center-to-center).
- Drill holes in the mounting surface for 2 #8 screws.
- If supplied, the trim ring is held in place when the light fixture is fastened to the mounting surface.
- These fixtures can be dimmed using a marine-grade wall-mounted 12-volt D.C. dimmer. Follow the connection instructions provided with the wall dimmer.
- Attach supply connections to the light, making sure to wire in accordance with both A.B.Y.C. Standard E-9 and U.S. Coast Guard Safety Standards for Boat Electrical Systems (33CFR 183) If supplied with two black leads, these lights are not polarity sensitive; otherwise, connect red to positive and black to negative electrical supply.
- Attach the light to the mounting surface using #8 mounting screws. The above-referenced standards can be obtained from:
- American Boat & Yacht Council, Inc. 613 Third Street, Suite 10 Annapolis, MD 21403
- U.S. Coast Guard Washington, D.C. 20593 (or your local C.G. office)
Perko, Inc.
- Address: 16490 N.W. 13th Avenue Miami, FL. 33164-5707
- www.perko.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>