PERKO 094600112V Vertical Mount Stern Light Installation Guide
- June 9, 2024
- PERKO
Table of Contents
Cat. No. 0946 Series
MOUNTING TEMPLATE
Stern Lights
CAT. NOS.
094600112V
0946DP112V
0946DP332V
0946001WHT
0946DP1WHT
0946DP3WHT
This is a 3/4” circle in order to scale internet printed templates
094600112V Vertical Mount Stern Light
The above lights are designed for use on sail or power driven vessels under 20 meters (65.6 ft.) in length operating on a nominal 12 volt or 32 volt system. In order to comply with the ‘72 COLREGS and the U.S. Inland Rules, the following must be adhered to:
MOUNTING INFORMATION
Read all instructions before proceeding
- These Instructions show the orientation of the light after the proper location has been determined. For proper light selection, positioning and configuration, refer to A.B.Y.C. Standard A-16 the ‘72 COLREGS and the U.S. Inland Navigation Rules.
- These lights are supplied with the proper bulb for operation on a nominal 12 volt system or a nominal 32 volt system. Use PERKO Cat. No. 0070DP0CLR, 12V, 10W bulb for a 12 volt system (Cat. No. 094600112V and 09460DP112V Stern Light). Use PERKO Cat. No. 0070DP2CLR bulb for a 32 volt system (Cat. No. 0946DP332V Stem Light). NOTE: PERKO Series 0946 used with a 32V bulb is not certified in accordance with 33 CFR 183.810 as this light is intended for replacement use only on appropriate vessels constructed prior to 11/1/03. All previous certifications apply.
- These lights are designed to be mounted on a vertical surface that is perpendicular to the centerline of the boat and facing astern.
- Draw a 6 inch long horizontal reference line through the center of the selected mounting location.
- Cut out the mounting template, Tape it on the mounting surface such that the reference line (drawn above) passes through the exact center of the template.
- Drill two holes through the template as indicated for the #6 mounting screws.
- Drill a 2-1/8 inch hole to accommodate socket holder as indicated.
- Attach supply connections to the light, making sure to wire in accordance with both A.B.Y.C. Standard E-11* and U.S. Coast Guard Safety Standards for Boat Electrical Systems (33 CFR 183).
- Attach the light to mounting surface using #6 screws, noting that the lens is marked “up” and “down” for proper orientation (see template).
- The above referenced standards can be obtained from:
(1). American Boat & Yacht Council, Inc.
613 Thired Street, Suite 10
Annapolis, MD 21403
(2). U.S. Coast Guard
Washington, D.C. 20593
(or your local C.G. office)
PERKO, INC.
16490 N.W. 13th Avenue
Miami, FL 33169-5707
www.perko.com
0946INS1
07/22
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>