IKEA 104.747.72 SILVERGLANS Driver for Wireless Control Instruction Manual

SILVERGLANS

104.747.72 SILVERGLANS Driver for Wireless Control

HOW TO STEER YOUR LIGHTING
When the driver is connected to the mains, it is possible to turn ON/OFF all products connected to the driver, but if you want to dim or connect your products to IKEA Smart lighting products, you need to buy a separate steering device (e.g. remote control).
The steering device needs to be paired with your driver/s. If you have more than one (1) driver you can pair each one with the steering device, so that the entire combination can be turned ON/OFF or dimmed at the same time.
PAIRING A STEERING DEVICE TO YOUR DRIVER

1. Connect at least one (1) product to the driver before you begin the pairing. Make sure that the mains power is turned ON.
2. Locate the pairing symbol on the driver. Hold the steering device close to the pairing symbol (no more than 5 cm away).
3. Press and hold the pairing button on the steering device for at least 10 seconds. A red light will shine steadily on the steering device. The product connected to the driver will begin to dim and flash one time to indicate that the driver is being paired to the steering device.

HOW TO FACTORY RESET YOUR DRIVER
If the driver does not respond or if you want to un-pair the driver from a steering device you might have to make a factory reset. The driver is forced to factory reset by carefully push and holding the small button (marked RESET) with the tip of pen on the driver enclosure and applying slight pressure. A factory reset can also be done by toggling the main switch 6 times.
IMPORTANT!

• The driver is for indoor use only and can be used in temperatures ranging from 5ºC to 45 ºC.
• Do not leave the driver in direct sunlight or near any heat source, as it may overheat.
• The declared radio range between the driver and the steering device is measured in the open air. Different building materials and placement of the units can affect the wireless connectivity range.

CARE INSTRUCTIONS

To clean the driver, wipe with a dry soft cloth.
Never use abrasive cleaners or chemical solvents as this can damage the product.

PRODUCT SERVICING

Do not attempt to repair this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks.

TECHNICAL DATA

Type: ICPSHC24-30-IL44-1
Input: 220-240 VAC, 50/60 Hz, 0.23A
Output: 24.0V DC
Max total load: 1.24 A, 30.0 W
Radio range: 10 m in open air.
Operating frequency: 2405-2480MHz
Output power: 14 dBm
IP-class: IP44

(EU/UK)
Average active efficiency: 88.1 %
Efficiency at low load (10 %): 75.6 %
No load power consumption: 0.28 W
Indoor use only
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN

**** The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.

Complies with
IMDA Standards
DA106634
© Inter IKEA Systems B.V. 2020
AA-2275989-2

Documents / Resources

| IKEA 104.747.72 SILVERGLANS Driver for Wireless Control [pdf] Instruction Manual
104.747.72 SILVERGLANS Driver for Wireless Control, 104.747.72, SILVERGLANS Driver for Wireless Control, Driver for Wireless Control, Driver
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>