jollyroom 10230612 Explore 3 In 1 Activity Center Instruction Manual
- May 15, 2024
- jollyroom
Table of Contents
jolly room 10230612 Explore 3 1 Activity Center
WARNING
Read the instructions carefully before use and keep them for future reference.
The child may be hurt if you do not follow these instructions. Before using,
remove and dispose of any plastic bags and other packaging (e.g. fasteners,
fixing ties, etc.) and keep them out of reach of children.
- Before using, check that the product and all of its components have not been damaged during transportation.
- Check regularly that the product is not broken or damaged. If the product is broken or damaged, keep it out of reach of children.
- The product must only be assembled by an adult. For the correct assembly of the product, please refer to the following instructions.
- WARNING! STAIR HAZARD: Avoid serious injury or death. Block stairs/step securely before using the activity centre.
- Only use Beemoo Play 3 in 1 Activity Center on flat and stable surfaces.
- Never leave a child unattended.
- Always keep the child in view while in the activity centre.
- WARNING! Prevent access to stairs, steps uneven surfaces, slopes or unstable floors, swimming pools or other sources of water.
- Guard all fires, heating and cooking appliances.
- Remove hot liquids, electrical cables and other potential hazards from reach. Prevent collisions with glass in doors, windows and furniture.
- Do not use the product if any components are broken or missing.
- This activity centre frame should be used only for short periods (e.g. 20min).
- This product is intended only for a child who can sit up by himself until it can walk by itself or weighs more than 15 kg.
- Do not use accessories or replacement parts other than those approved by the manufacturer.
PARTS
Check that you have all the parts for this model before assembling your product.
No tools are required.
- Leg
- Adjustment belts
- Table
- Multi-purpose board
- Padded seat
- Storage basket
- Toy
ASSEMBLY
To assemble the activity centre, Stage 1:
Sit Swivel Rounce and Plav
-
Insert the legs into the table, a “click” sound means they are in place.
-
Thread the adjustment belts into the holes of the board as the picture shows to ensure the belts cannot release easily.
-
Adjust the position according to the baby’s height and the tips of the belt.
CAUTION: Be careful not to exceed the maximum limit. -
Put the seat cushion on the tabletop and make sure the wheels under the seat are inserted into the slot, hear a “click” to make sure it is installed in place. The seat cushion can be rotated 360°.
-
Insert the arch toy into the toy tray, and put all the toys in the positions as the picture shows. Press and hold the button on the base of the toy then insert it into the holes, making sure the button snaps back to lock.
-
As shown in Figure (1), pull up the toy tray and the owl toys directly to disassemble.
-
Press and hold the button on the base of the toy, lift the button position to make a gap between the table and the toy base, insert the finger into the gap pull up the toy base, and then release the entire toy.
-
The other toys could be disassembled in the same steps as shown in Figure (2).
-
Be sure to disassemble the toy first and then the leg, otherwise it will be damaged! To assemble the activity centre, Stages 2 & 3: Convert to the Reading/Drawing table or the Block table.
-
Put the storage basket on the table.
-
Cover the table with the flat side facing upwards to become a reading/drawing table.
-
Cover the table with the other side of the board facing upwards to become a block table.
FITTING AND / OR REPLACING BATTERIES
WARNING!
- The toy of the play centre frame requires 3X”AA” 1.5 Volt alkaline type batteries (not included).
- Batteries must only be fitted by an adult.
- To fit and/ or replace batteries: loosen the screw on the battery compartment cover with a suitable screwdriver, press the tab and remove the battery compartment cover.
- Then remove the spent batteries and fit new ones, ensuring that they have been fitted in the correct polarity, as shown inside the battery compartment. Replace the battery cover and tighten the screw.
- Always keep batteries and tools out of reach of children.
- Always remove the batteries if the toy will not be used for a long period.
- Only use alkaline batteries of the same type or equivalent to the type recommended for the correct function of this product.
- Never mix new and old batteries or different types of batteries.
- Do not burn or dispose of spent batteries in the environment. Dispose of spent batteries at an appropriate differentiated collection point.
- The use of rechargeable batteries is not recommended and cannot be used.
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries are to be removed from the toy before being charged.
- Rechargeable batteries are only to be charged under adult supervision.
- Batteries are to be inserted with correct polarity.
- Exhausted batteries are to be removed from the toy.
- Do not short-circuit the battery terminals.
CARE AND MAINTENANCE
Seat fabric
- Hand wash cold with a mild detergent.
- Do not tumble dry
- Do not bleach
- Do not iron
- Do not dry-clean
- Air dry flat
Plastic and metal parts
- Clean with a damp cloth and a mild detergent. Dry thoroughly. Do not use abrasives.
- Do not fold or store the product when it is wet and never store it in wet conditions, as it can lead to mould growth.
- It is normal for the fabric to colour from sunlight and to show wear and tear after a long period of use, even when used normally.
- Check regularly if everything functions properly. If any parts are torn, broken, or missing, stop using this product.
- All pictures shown are for illustration purposes only. Actual products may vary due to product enhancement.
Produced by
Jollyroom AB
Sörredsvägen 111,
418 78 Göteborg
SWEDEN
Contact: +46313100013
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>