DS18 JK-SQBASSHARNESS Under seat Amplified Subwoofer User Manual
- June 4, 2024
- DS18
Table of Contents
JK-SQBASSHARNESS
USER MANUAL
Item included:
Tools required:
A. Pin Remover
B. #2 Philips Screwdriver
C. ¼ Drill Bit
D. 7mm Socket
E .10mm Socket
F. 18mm Socket
G. T27 Socket
H. T40 Socket
I. Impact wrench
Equipment you will need
(Not included in the kit)
- SQBASS (Active subwoofer)
ATTENTION
Installation of mobile audio and video components requires experience with a
variety of mechanical and electrical procedures. Although this manual provides
general installation and operation instructions, it does not show the exact
installation methods for your vehicle. If you do not have the required
knowledge and experience to successfully complete the installation, consult an
authorized dealer for professional installation service.
ATTENTION
Disconnect the negative post (Ground) of the battery before you start the
installation. This helps avoid airbags coding and malfunctions, codes module
malfunction or any electrical issues
Under Seat SQBass Rack/Bracket installation
-
Starts with removing the bolts of the Driver seat using the 18mm socket with an impact wrench tool.
-
Remove the belt screw from the seat using a T40 socket, then you can remove the seat from the Jeep and put it on this position for easy access under the seat.
-
Locate the connector holder plate and remove it using the clip remover for the connector and the T27 socket for the two screws that hold it.
-
Relocate this wiring under the seat to one side using the same pin spots as you can see in the picture.
-
Using the ¼ Drill Bit open up these two holes where the factory bolts were located, then locate the SQ-BASS bracket “B” and secure it using a pair of the “A” Screws with the 10mm socket.
-
Locate the SQ-BASS bracket “A” and secure it on the SQ-BASS using the “B” screws supplied and tight them just enough but not too hard (The screw can break easily).
-
Locate the SQ-BASS under the seat and use a pair of “A” screws and secure the bracket using the 10mm socket, then using the “B” screws secure the other side of the SQ-BASS to the bracket “B” as you can see in the picture.
-
Now it’s time to connect all wires for the SQ-BASS, then get ready to put back the seat into the Jeep and route the rest of the wiring to the dashboard (behind the radio):
A. Factory Radio Harness
B. DS18 Radio T-Harness
C. Factory Radio Unit
D. Ground: connect to chassis
E. Audio signal Connector
F. Power Wires:
Yellow: +12V
Blue: Remote
Black: Ground
G. DS18 SQ-BASS8
Final Steps:
- Once all is connected, put back the seat and make sure all connectors are plugged-in so you can re-connect the negative post (Ground) of the battery.
- Turn on the Radio and check the sound making sure that all speakers are playing, then adjust the amplifier’s gain and crossover point to your preference.
- This should be all! Enjoy your new DS18 JK-SQBASSHARNESS.
FOR MORE INFORMATION
PLEASE VISIT
DS18.COM
We LIKE IT LOUD
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>