Jaryco KL6688-6688-1 Toddler Ride on Motorcycle User Manual
- May 15, 2024
- Jaryco
Table of Contents
User Manual
Age for: 18-36 months
Adult assembly required!
KL6688-6688-1 Toddler Ride on Motorcycle
Please read the user manual before use. The Owner’s manual contains assembly,
use and maintenance instructions. The vehicle must be assembled by an adult
who has read and understands the instructions in this manual. Keep the
packaging away from childre and dispose all packaging before use. Keep
instructions for future reference.
SPECIFICATION
Battery | 6V 4.5AH |
---|---|
Motor | Drive motor:6V 35W |
Age for | 18-36 months |
Maximum Capacity | 25kQ |
Vehicle size | 680360450mm |
Package size | 670300335mm |
Net weiQht | 4 kQs |
Use time | Each charge for 10-12 hours, use 1-2hours |
Charger | Output: DC6V 500MA |
Input: Depend on local voltage
Waring for Charging the battery
-
Ensure charger the battery to 12 hours at first time! Or the batter may damaged and can’t be repaired. Each charge no more than 16 hours.
-
Insert the DC charger plug into charge hole on vehicle body first, then connect the other end with power supply.
-
Charge the vehicle when each use after 1hour, normal charging time is 10 to 12 hours.
-
The charger and the battery may be a little heating-up, it will be acceptable if the temperature less than 60℃.
-
If the vehicle won’t use for a long time, it need to be charged at least once per month.
-
Only an adult who has read and understands the safety warnings should handle, charge or recharge of the battery. Never charger nonchargeable battery, always pick out the power exhausted batteries.
Never mix use different type battery or mix use new and old batteries. -
Pick the batteries out from the toy before charging if the toy use AAA rechargeable batteries; Insert the batteries by the correct polarity.
-
Never charge when the socket is wet, or may cause short circuit.
Battery terminals can’t been short circuit. -
Always use the original battery and charger we supplied with the vehicle to prevent electrical parts or circuit.
• Close the power switch if not use the vehicle. For a long time not use, please cut off the plugs for the battery.
• Once the vehicle speed is obviously be slow, the motor is not strong, and the music sound been lower, please charge the battery in time!
Parts list in package
- User Manual
- Rear axle 1
- Wheel 3
- Front axle
- Cushion 1
- Handle
1pcs | • Vehicle body | 1pcs |
---|---|---|
1pcs | • Forks | 1pcs |
3pcs | • Front fender | 1pcs |
1pcs | • Charger | 1pcs |
1pcs | • Front wheel sleeve | 2pcs |
1pcs | • Windshield | 1pcs |
WARNING !
The following safety hazards may result in serious injury or death to the
child, please note below:
- The product must be assembled by an adult!
- The small parts need to be keep away from the children under 3 years to prevent injury!
- Always use the vehicle in a safe, secure environment with continuous adult supervision. Child use the vehicle must under adult’s instruction!
- Only charge the battery by an adult. Please charge the battery before first use!
- Keep away the child from protective material and poly bags to prevent suffocation!
- Regularly check the product including charger, wires, vehicle body and other parts, once found damage, please stop to use until mend it well.
- Ensure that children use the product in a safe driving environment, such as home, garden or playground.
- Use in spacious flat areas.
- Must be usde and installed under adult supervision.
- In the course of use, you can use your feet in front of the ground to brake when there are obstacles or dangers in front of you.
- Be careful when using to avoid being overweight and causing injuries to users or third parties as a result of falls and collisions.
Assembly
-
Install the rear wheel: put the rear axle into the corresponding hole of the main body and the gearbox hole from the left side, and put the rear wheel into the two sides respe ctively and lock them with nuts.
-
Install the front wheel: thread the front wheel shaft into the front fork, front wheel shaft sleeve and front wheel respectively, and lock both sides with nuts.
-
Install the front fork, put the front wheel assembly into the body and the corresponding hole of the instrument, then put the glove into the front fork iron pipe, and lock it with the screw / nut.
-
Clip the windshield assembly into the instrument.
-
Assemble the battery: rotary the Lock of seat, battery to be Inserted with correct polarity (red to red, black to balck)
USE INSTRUTION
Charging instruction: plug the charger port into the input socket Use instruction: Ride on the vehicle, set the Forward/Backward switch at “Forward” location, press the pedal by foot, the vehicle will move forward, release the pedal, the vehicle will stop. Set the Forward/Backward switch at “Backward” location, press the pedal by foot, the vehicle will move backward, release the pedal, the vehicle will stop. Set the Forward/Backward switch at middle location, press the pedal by foot, the vehicle won’t move. (Note: Set the Forward/Backward switch at STOP position if not use.)
Maintenance
-
This product made of PP plastic, please not exposed it to the burning sun. Keep it far away from hot object, or the plastic may be melt.
-
The vehicle should be checked for damage, missing or badly worn parts before each use.
-
Check the tightness of the fasteners before each use.
-
Check the tightness of the wheel locknuts.
Note: If the wheel locknuts are not tight the drive wheel will not engage and the vehicle will not run. -
Ensure the battery is securely in place before use.
-
Occasionally use lightweight oil to lubricate moving parts such as wheels and steering linkage. Do not use oil on plastic or nylon parts. No lubrication is required.
-
Store the vehicle indoors or cover it with a tarp to protect it from the wet weather. Keep it away from sources of heat, such as stoves and heaters.
-
Clean the vehicle with a soft, dry cloth. To restore shine to plastic parts, use a non-wax furniture polish. Do not use car wax, abrasive cleaners or wash the vehicle with soap and water. Water will damage the motor, electrical system and battery.
WARNING FOR USE
- Before using the vehicle for the first time the battery needs to be charged for 16 hours. Failure to do so may damage the battery and can’t be repaired.
- Do not use the vehicle near streets, motor vehicles, drop-offs such as: steps, water (swimming pools), sloped surfaces, hills, wet areas, flammable vapors, in alleys, at night or in the dark.
- Only one rider use the vehicle, please not over load, the maximum capacity is 25KGS.
- Please not change the forward/backward switch position during the moving.
- Do not change the wires of the vehicle and add electrical parts.
- Please don’t use in the rain or immerse the vehicle by other way, and also keep away from the fire to prevent the circuit damaged.
- Once come to an obstacle, the vehicle will stop move, please leave the obstacle then ride again.
- Don’t ride the vehicle in the water, and not pour water and other liquid on the vehicle.
- Don’t use the vehicle indoor to prevent damage the furniture or hurt the child.
Safety attention:
- can not be used in places where people are too dense, to avoid the risk of the occurrence of trampled.
- can not be used in the slope of the slope greater than 30 degrees, to avoid the impact of the downhill impact is too large, there is a risk of collision.
- can not be used on the road too rugged, to avoid the risk of falling.
- can not be used on the highway.
- in the use of the car must be a comprehensive inspection, such as the discovery of the wheel loose or other places where there is damage, Must immediately abandon the use of the stroller.
- if the protective equipment use wear protective equipment such as helmets, gloves, knee pads, elbow pads.
- caution must be used under adult supervision.
- a reminder that the toy should be used with caution since skill is required to avoid falls or collisions causing injury to the user or third parties.
- Please use the toy in open and sparsely populated areas to avoid third-party collisions.
TROUBLESHOOTING GUIDE
Problem | Possible | Cause Remedy |
---|---|---|
Motor does not work | Pedals itch not connect well. The terminal and wire on |
motor loose
The plug for motor and battery not connected well The motor is damaged.|
Repair the pedal switch Connect the wire and terminal Reconnect the plug
Replace the motor
Vehicle can go forward but can’t backward| The forward/backward switch not
connected well.
The wire connect forward/back ward and battery loose| Replace the switch.
Reconnect the wire
The speed is slow| The battery with low power
The gear not fit well in the motor| Charge the vehicle Change the motor
The vehicle can’t be charged| The charger is damaged (if the output terminal
of charger tested The battery is damaged (connect the charger and check the
terminals on battery, there is a voltage of 6.8-8.0v)
The charge socket not connected well or the welding spot loose| Change the
charger
Change the battery
Tighten the socket or reweld the wires
The vehicle can move but no sound and lights| The button for music and lights
is damaged.
The wire from battery not connect the vehicle head plug well| Replace the
buttons. Reconnect them .
Motor works while the vehicle can’t move| The motor loose from the gear box
The gear in gear box damaged.| Open the gear box and tighten the screws to fix
the motor.
Change a new gear box.
The vehicle moves but not smooth| The user weight is over 25kg. The vehicle
moves on uneven surface.
The wheels or axle seized up by something.
The battery with low power.| No need mend.. No need mend. Just ride the
vehicle on smooth surface.
Check the wheels and axle. remove the debris. Charge the vehicle in time.
The vehicle can’t stop| The pedal can’t rebound when remove the foot.| Check
the pedal switch remove the debris. If damaged, change a new switch.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>