Evika KM 1.0 Gallon Pump Sprayer Instruction Manual

Instruction Manual

Warning: For your personal safety, READ and UNDERSTAND before using.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Parts

1. Trigger Assembly
2. Lance
3. Nozzle
4. Hose
5. Container Cap
6. Pump Handle| 7. Shoulder Strap
8. Pump Barrel
9. Inner Hose
10. Ssfety Valve
11. Lace Holder
12. Spray Bottle
---|---

Operating Instructions

Preparation:

1. Before filling, release any pressure built up within the bottle by lifting the safety valve.
2. Unscrew and remove the pump by turning the handle in an anti-clockwise direction.
3. Fill the bottle with liquid to the desired level. Do not exceed the maximum capacity level marked on the bottle.
4. Screw the pump handle back into position by turning the handle in a clockwise direction. Ensure all fittings are tightened before proceeding. Spraying:
5. Pressurise the bottle by pumping the lever up to 10 times. Do not over pressure.
6. Air will escape through the safety valve if the pressure is too high.
7. Spray the desired area by holding down the trigger on the nozzle. The trigger can be locked for continual spraying.

WARNING!
This sprayer is designed for use with liquid chemicals used for gardening, horticulture, agriculture, cleaning, degreasing, disinfecting and stripping materials when resistance to aggressive chemicals is required. The sprayer is equipped with Flurocarbon Seals (FKM).
For correct chemical use follow the chemical supplier’s instructions and seek their advice if unsure of chemical combability. To be used by adults only. Always work in a well-ventilated area. Seek medical attention if spray contacts your eyes or skin, is inhaled, or you develop any symptoms, illness or reactions after spraying.
Important: Under normal use and conditions the sprayer bottle has a maximum life of five (5) years after purchase date. The purchase date, place of purchase and product number should be recorded in this Product Manual.

Safety Instructions

Caution: contents under pressure. Read this before operating.

• Release pressure from the bottle before refilling or replacing parts. This is done by slowly pulling up the safety valve and holding until all air has been released. Then unscrew the container cap. Note: some remaining air may be expelled.
• Inspect the condition of all fittings before each use. Do not attempt to use your sprayer with worn or damaged parts. These parts should be replaced. Refer to spare parts list.
• Safety valve operation: over pumping will cause the safety valve to open and release excess pressure. It will close when safe operating pressure is reached.
• Safety valve test: fill the bottle to the maximum filling level with clean water. Pressurise by pumping a few times. Once it has reached full pressure the valve should lift, allowing the red indicator to become visible and air to escape. If this does not happen, replace the safety valve.
• Your sprayer is made from many different types of plastic materials, and although the liquid you may wish to use is packed in a plastic container, it is not guaranteed that it will not damage your sprayer. Your sprayer is designed for use with a broad range of domestic water based herbicides, fungicides, insecticides and fertilisers. Do not use other types of chemicals as they may be detrimental to the safe operation of your sprayer.
• Follow chemical suppliers on-pack instructions.

DO’S

• Release pressure before filling/servicing
• Release pressure and clean after use
• Wear safety goggles and gloves
• Wear protective clothing and mask
• Spray thin solutions. Thick solutions will clog the nozzle
• Ensure adequate ventilation
• Wash hands and face after use
• Wash contaminated clothing
• Store sprayer away from sunlight
• Hand tighten fittings only
• Rinse and dry inside of bottle before usewith compatible chemical
• Read and unaerstana cnemica: manufacturers safety directions
• Discard safely and legally any unused contents after use
• Lubricate regularly moving parts with silicone grease

DONT’S

• Spray flammable liquids or solvents
• Leave full bottle unattended
• Eat, drink or smoke when spraying
• Direct spray on humans or animals
• Spray in windy conditions
• Spray in confined spaces
• Leave within reach of children or animals
• Overfill the bottle
• Over pressurise
• Stand sprayer near naked flame or hot surfaces
• Tighten fittings with pliers etc.
• Allow children to use
• Modify bottle or safety valve
• Spray any volatile solvent e.g. white spirit
• Spray near food or preparation areas

Application

• Always wear protective clothing including safety glasses and gloves when using this sprayer.
• This sprayer is designed for domestic use and is to be used with water based liquids only.
• Liquids used with sprayers can be dangerous; if swallowing or skin contact occurs, always refer to the safety instructions of the liquid used or contact the poisons information centre or a doctor immediately.
• Avoid spraying in windy conditions.
• Store out of direct sunlight and away from children.
• Always release pressure before filling, cleaning or storing.
• Only person’s over the age of 18 should handle.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>