BRIGHTLUX AL17-36FT-RGB-2 36ft. LED Chasing Rope Light User Guide

June 6, 2024
BRIGHTLUX

BRIGHTLUX AL17-36FT-RGB-2 36ft. LED Chasing Rope Light

TOOLS REQUIRED

HARDWARE INCLUDED

A – 36ft. LED Chasing Rope Light x 1

| B – Inline Controller w/120V Plug x 1| C – Mounting Clip x 18
---|---|---
D – Screw x 36| E – 28 Key IR Remote x 1|

F – 3V CR2025 Battery x 1

INSTALLATION

PREPARING TO EXTEND THE ROPE LIGHTS
  • Ensure all rope lights are unplugged before adding the additional rope light (A) to the series.
  • Remove the end cap (1) from the last rope light in the series by turning counterclockwise.
  • Remove the power cord (2) from additional extension rope lights (A).
  • Extend up to 72ft. (21.9m) maximum. Use only the following BrightLux rope light extension segments: 9000-0002.
CONNECTING THE ROPE LIGHTS
  • Connect the last rope light in the series and the extension rope. light (A) together and ensure the connectors are tightly secured.
  • Attach the end cap (1) to the last rope light in the series and ensure the connection is secure
MOUNTING THE ROPE LIGHTS
  • Insert the screw (D) through the opening in the mounting clip (B).
  • Screw the mounting clip (C) into position at the installation location.
  • Place the rope light (A) securely into the mounting clip (C).
  • Mounting clips should be evenly spaced and be a maximum of 3ft. (0.91 m) apart.
  • Make sure the distance between two lines of rope light is at least 1/2in. (12 mm).

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

  • Ground Fault Circuit Interrupter (GFCI) protection should be provided in the circuits or outlet to be used for outdoor use. Receptacles are available that have built-in GFCI protection.
  • Only use outdoor extension cords such as type SW, SOW, STW, STOW, SJW, SJOW, SJTW, or SJTOW. This designation is marked on the wire of the extension cord.
  • The rated voltage for this product is 120VAC, 60Hz, 72W, 0.6A.
  • Do not operate this product with the flexible light tightly coiled.
  • Do not route the cord or flexible light cable through walls, doors, windows, or any similar part of a building structure.
  • Do not subject flexible lighting to continous flexing.
  • Do not exceed the maximum extension length in feet permitted by the marking. The maximum extension length for this rope light is 72ft. (21.9m).
  • The RF remote controller included utilizes a 3V CR2025 battery; only replace with same battery type. Please dispose of batteries properly. Batteries are not a toy! If swallowed, contact local emergency services immediatley

SAVE THESE INSTRUCTIONS

| WARNING: This product has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electrick shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless the plug can be fully inserted. Do not alter the plug.
---|---
| WARNING: When using this product outdoors, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury.
---|---
| WARNING: Do not cover this product as the covering may cause the flexible light to overheat and either melt or ignite.
---|---
| WARNING: Do not puncture, cut, shorten, or splice the flexible lighting.
---|---
| WARNING: Do not use if there is any damage to the light or cord insulation.Inspect periodically.
---|---
| WARNING: Do not mount or secure the rope light in a manner than can cut the outer jacket or damage the cord insulation. Inspect the rope light carefully before use and discard any rope lights that have a broken outer jacket, loose connections, or frayed wire insulation.
---|---
| WARNING: Do not submerge the flexible light in liquids or use the product in the vicinity of standing water or other liquids.
---|---
| WARNING: Secure the rope lights using only the mounting clips provided. Do not secure this product with staples, nails, or similar objects that may damage the insulation.
---|---
| WARNING: Do not install the rope light within 16 ft. (4.87 m) of pool or spa. Do not install rope lighting in cabinets, tanks, or enclosures of any kind.
---|---
| CAUTION: All units must be unplugged before you add additional segments. Only use segments recommended by the manufacturer of this lighting system.
---|---
| CAUTION: Ensure all connections and the end cap on the last segment are tightly secured to prevent the entry of water.
---|---

CONTROLLING THE SERIES

1| | ON: Press Green to turn ON Chasing Rope Light
OFF: Press Red to turn OFF Chasing Rope Light
---|---|---
2| | Brightness Increase Brightness Decrease
3| | Color Selection: Holiday Presets:
– U.S. Flag = Red, Blue, and White
– Pumpkin = Purple and Orange
– Gift Box = Red and Green
– Candy Cane = Red and White
4| | Color Selection: Static (solid) White
Color Selection: Static (solid) Color Toggle: Red, Green, Blue, Orange, Yellow, Light Blue, or Purple
Color Selection: 3-Color Mix: Red, Green, and Blue
Color Selection: 7-Color Mix: Red, Green, Blue, Orange, Yellow, Light Blue, and Purple
Color Selection: 16-Color Mix: Red, Green, Blue, Dark Orange, Light Orange, Dark Yellow, Light Yellow, Light Green, Light Blue, Medium Blue, Dark Blue, Light Purple, Purple, Pink, Dark Pink, and White
5| | Adjustable Speed: Increase or Decrease the speed of Flash and Fade modes or Directional Chasing Effects from keys 6, 7, & 8.
6| | Directional Chasing Effects
(< Power Side to End / End to Power Side >)
– Constant Chasing Function; < Power Side to End; Select preferred color settings from keys 3 & 4 ; Includes White Light between color intervals.
– Constant Chasing Function; End to Power Side >; Select preferred color settings from keys 3, 4, or 8; Includes White Light between color intervals.
– Stacking Spread to Fill Function; < Power Side to End; Select preferred color settings from keys 3 & 4.
– Stacking Spread to Fill Function; End to Power Side >; Select preferred color settings from keys 3 & 4.
– Staggered Chasing Function; < Power Side to End; Select preferred color settings from keys 3, 4; No illumination between color intervals.
– Staggered Chasing Function; End to Power Side >; Select preferred color setings from keys 3 & 4;No illumination between color intervals.
7| | Rainbow Mode: Automatically Chasing 256 color mix; Does not work with Directional Chasing Effects.
Flash Mode: Automatically blinks through colors; Select preferred color settings from keys 3 & 4..
Fade Mode: Automatically Fades selected color mix;Select preferred color settings from keys 3 & 4.
Smooth Mode: Automatically overlay each color one by one selected color;Select preferred color settings from keys 3 & 4.
8| | Auto Mode: Automatically cycles through Rainbow, Flash, Fade and Smooth modes, then Directional Chasing Effects using the active Color Selection.
9| | Timer Function: 4 hour or 8 hour

CONTROLLING THE SERIES

CONTROLLING THE SERIES VIA IN-LINE CONTROLLER

  1. The LED Chasing Rope Light can also be controlled using the in-line controller.
  2. Press the grey circle button to toggle through all color options and functions listed above.
  3. Press and hold the grey circle button to turn the LED Chasing Rope Light OFF.
  4. Press and hold the grey circle button to turn the LED Chasing Rope Light ON.
REPLACING THE BATTERY (HANDHELD REMOTE CONTROL):

To replace the remote control’s battery, follow the directions on the back of the remote control to slide the battery drawer out. Replace the battery (+ side up) and slide the battery drawer back into place

  • Always purchase the correct size and grade of battery (CR2025) most suitable for the intended use.
  • Clean the battery contacts and also those of the device prior to battery installation.
  • Ensure the battery is installed correctly with regard to polarity (+and -).
  • Remove batteries from remote control if it is not to be used for an extended period of time.
  • Remove used batteries promptly

FCC COMPLIANCE STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment into an outlet different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

MAINTENANCE

REPLACING THE FUSE

| WARNING: Risk of fire. The plug on the main rope light contains an electrical fuse as a safety feature. Do not remove or replace this plug. Do not use the light if the plug is damaged.
---|---

To replace the fuse:

  • Disconnect the power before replacing the fuse.
  • Grasp the plug (1) on the primary rope light and remove from the receptable or other outlet device. Do not unplug by pulling on the cord.
  • Slide the fuse access cover (2) towards the prongs of the plug (3) to open.
  • Carefully remove the old fuse (4) and replace with a 5-Amp 125-Volt fuse.
  • Close the fuse access cover (2) by sliding to the original closed position.

WARRANTY

The manufacturer warrants this product to be free for two (2) years against any defects that are due to faulty materials or workmanship. This warranty applies only to the original customer purchaser and only to products used in normal use and service. If this product is found to be defective, the manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s  discretion.provided that the product has not been damaged through misuse, abuse,  accident, modifications,alterations, neglect, or mishandling. This warranty shall not apply to any product that is found to have been improperly installed, set up, or used in any way not following the instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty workmanship. This warranty shall not apply to finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and specifically disclaim any warranty, whether expressed or implied or fitness for a particular purpose, other than the warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including any labor/expense costs involved in the replacement or repair of said product.
Contact Customer Service Team at 1-844-255-9692

Questions, problems, missing parts? Before returning to the store, call out Customer Service Team
8 a.m. – 5 p.m., MST, Monday – Friday
1-844-255-9692

SAVE THESE INSTRUCTIONS FOR FUTURE USE

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals