Bolon DJ0176ND Rattan Coffee Table with Sliding Door Instruction Manual
- May 15, 2024
- Bolon
Table of Contents
Coffee table
DJ0176ND Rattan Coffee Table
with Sliding Door
DJ0176ND Rattan Coffee Table with Sliding Door
General Guidelines
– Please read the following instruction carefully and use the product
accordingly.
– Please keep this manual and hand it over when you transfer the product.
– This summary may not include every detail of all variations and considered
steps. Please contact us when further information and help are needed.
Notes
– The item is only intended for home use. Any uses that do not match the above
description or unauthorized changes and modification are not permitted.
Otherwise, it may result in personal injury or breakage of the product. The
product must be assembled and used strictly in accordance with the provisions
of the manual. The seller does not assume any responsibility or liability with
respect to any damage caused by incorrect assembly or improper use.
– It is recommended to assemble it by 2 adults. Please read instructions
carefully and assemble the item according to the instruction.
– Please check parts first after unpacking. If there are defective, broken or
missing parts, please do not hesitate to contact.
– Please assemble the item in spacious room and do not place the unwrapped
product directly on the ground.
– It is recommended to wear gloves in the assembly to avoid scratches by the
sharp edges.
– Do not stand or sit on the wooden boards before the assembly.
– Please match the corresponding board and fitting based on the part number in
the manual.
– If the board does not match with the fitting, please check the pieces as
specified in this manual.
– Please refer to the diagram during assembly. Align all the screws with the
related pre-drilled holes first and later tighten the screws one by one after
putting all the parts in the correct places.
– Please remove all items on the product before moving.
– Two people are required to move the product as the item should be lifted off
the ground.
Please do not drag it along the floor as it may damage your floor.
– Do not expose the product to direct sunlight or rain. Do not put it in a
humid place. Failure to do so may accelerate the distortion, discoloration or
crack. Do not leave sharp objects.
Do not pour corrosive chemicals on the surface of the board.
– For daily care, please clean with a damp cloth and wipe dry immediately .
Warnings
– It is not intended for use by children under 3 years of age. Children must
be under adult supervision to use the product.
– Children are not allowed to climb or play on the item to avoid toppling over
which may cause serious or fatal injury.
– During the assembly process, keep small parts out of the reach of children.
It may be fatal if small parts are swallowed or inhaled.
– To avoid the potential dangers of suffocation, please keep all parts and
packaging (films, plastic bags and foam,etc.) away from babies and children.
Parts List
Hardware List
A | 8x30mm | Wooden dowel | 12 | PCS | |
---|---|---|---|---|---|
B | 6x35mm | Cam bolt | 16 | PCS | |
C | 15%11mm | Camlock | 16 | PCS | |
D | P15%1mm | Sticker | 6 | PCS | |
E | 7x50mm | Screw | 6 | PCS | |
F | 3.5x14mm | Screw | 40 | PCS | |
G | Sliding door wheel | 4 | PCS | ||
H | 35x190mm | Log leg | 4 | PCS | |
I | L-shaped corner code | 4 | PCS | ||
J | 6x15mm | Flat head silk | 8 | PCS |
Philips head screwdriver required for assembly (not included) The hardware
quantities listed above are required for proper assembly.
Some extra hardware may also have been included.
|
---|---
|
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>