TOYOTA PTR03-34220 2022 Tundra TRD Performance Air Filter Instruction Manual
- June 4, 2024
- Toyota
Table of Contents
TOYOTA PTR03-34220 2022 Tundra TRD Performance Air Filter Instruction Manual
Kit Contents
NOTE: Two (2) kits required for installation.
Hardware Bag Contents
Additional Items Required For Installation
Conflicts
Recommended Tools
General Applicability
Recommended Sequence of Application
*Mandatory
Vehicle Service Parts (may be required for reassembly)
Legend
Procedure
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this accessory should follow approved guidelines to ensure a quality installation.
These guidelines can be found in the “Accessory Installation Practices” document.
This document covers such items as:-
- Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).
- Safety (eye protection, rechecking torque procedure, etc.).
- Vehicle Disassembly/Reassembly (panel removal, part storage, etc.).
- Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.).
Please see your Toyota dealer for a copy of this document.
1. Prepare the Vehicle and Parts.
(a) Check the box for contents and any damage.
(b) Open the vehicle hood.
(c) Familiarize yourself with the installation and components before
beginning.
(d) Apply vehicle protection to prevent damage to painted surfaces.
(e) NOTE: Two (2) TRD Performance Air Filter kits (PTR03-34220) are required
for a complete installation.
2. Remove the Driver-Side Factory Air Filter.
(a) Unlatch the two (2) air filter housing clips (Fig. 2-1).
(b) Lift the filter housing lid up to expose the factory air filter (Fig. 2-2).
(c) Remove the factory air filter from the filter housing and discard it.
3. Install the Driver-Side TRD Air Filter.
(a) Insert the TRD air filter into the air filter housing with the deep side of the filter down in the housing (Fig. 3-1).
(b) Move the air filter housing lid into place and engage the two (2) tabs (Fig. 3-2).
c) Re-latch the two (2) air filter housing clips (Fig. 2-1).
d) Use a lint free cloth and a VDC-approved cleaner such as 3M Prep Solvent 70 or similar to clean the air filter housing lid adjacent to the intake duct (Fig. 3-3).
(e) Use a lint free cloth and water to clean the same area as in Step 3(d) (Fig. 3-3).
(f) Apply the TRD air filter warning label to the pre-cleaned area (Fig. 3-4).
4. Install Passenger-Side Air Filter
(a) Repeat Steps 2-3 to install second TRD Performance Air Filter to the passenger-side air intake (Fig. 4-1).
5. Finish the Installation.
(a) Remove the vehicle protection used to prevent damage to painted surfaces.
Checklist – these points MUST be checked to ensure a quality installation.
Issue: A 08/23/2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>