Wattsaving Level 2 EV Charger Up to 32 Amp 18 Foot Cable Instruction Manual

Wattsaving Level 2 EV Charger Up to 32 Amp 18 Foot Cable

Charging Operation

1 Plug-and-Charge Mode (Default)

• When the charging station is on standby, plug in the connector to your EV, and the LED will turn blue from purple.
• The LED will be flashing green while charging.
• When your EV is fully charged, the LED will be solid green, unplug the connector and place it back into the holster.
  • If you need an emergency stop while charging, please press the RESET BUTTON then unplug the connector.

RFID Mode

How to the Enable the RFID Cards

• When the charging station is on standby, press the RESET button and hold till the LED turns orange from purple.
• Place the RFID card into the RFID Reader (Interrogator) within 15 seconds and wait till the LED turns back to purple.

NOTE

1. Another RFID card will automatically be enabled without any operation.
2. Once you enable the RFID mode, the plug-and-charge mode will be disabled, if you want to use the plug-and-charge mode, please contact us for tech support.

RFID Charging Mode

• When the charging station is on standby, plug in the connector to your EV, and the LED will turn blue from purple.
• Tap the RFID card on the RFID Reader.
• The LED will be flashing green while charging.
• Tap the RFID card on the RFID Reader again to stop charging. When your EV is fully charged, the LED will be solid green, unplug the connector and place it back into the holder.

Product Overview

1. Led Indicator
2. RFID Reader (Interrogator)
3. RESET BUTTON
4. Cord Holder
5. J1772 Connector

If any problem occurs during operation, please refer to the user manual or contact us for support.

• support@wattsaving.com
• www.wattsaving.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>