WOLF ARMOR 130 Inflatable Recreational Touring Kayak Owner’s Manual
- June 17, 2024
- WOLF ARMOR
Table of Contents
WOLF ARMOR 130 Inflatable Recreational Touring Kayak
WARNING
Paddle sports can be very dangerous and physically demanding. The user of this product should understand that participating in paddle sports may involve serious injury or death. You should receive qualified instructions to learn proper paddling techniques, water safety, and first aid before going boating. Observe the following safety standards whenever using this product.
- ALWAYS wear a nationally approved Life Jacket or Personal Flotation Device (PFD).
- place of arrival someone of your boating route, the time and place of your departure, and your intended time and
- This is not a life-saving device. Use only under competent supervision.
- Get paddle sports instruction from a licensed or certified instructor. Be sure to carry first aid and rescue equipment with you.
- Read the complete Owner’s Manual before use and store this Manual in a safe place for future reference.
- Check your equipment prior to each use for signs of wear leaks or failure.
- Dress appropriately for weather conditions. Boating in cold water and cold weather is very dangerous. Hypothermia may lead to death.
- Know and follow local water safety rules and boating regulations.
- DO NOT consume alcohol or use drugs that affect your ability to safely operate the boat before using this product.
- DO NOT exceed your paddling ability; be honest with yourself.
- DO NOT impair entry or exit access to the kayak when installing additional outfitting.
- DO NOT overinflate or use the high-pressure air compressor to inflate.
- NEVER go paddle in bad weather or dangerous waters such as severe winds, rainstorms, flood waters, tidal changes, etc.
- NEVER paddle alone. Minors need to use this boat under adult supervision.
- NEVER allow diving into this product. Never leave in or near the water when not in use. Never tow from any vehicle.
- When carrying the kayak, try to lift it off the ground as much as possible and do not drag it.
- Be careful of rocks or shells, as well as any objects that can scratch their surface.
DESCRIPTION
- Transport Handle
- Warning
- Zipper
- Seat Adjustment Velcro
- Seat D-ring
- Safety Handle
- Paddle Holder
- Floor Chamber Valve
- Side Chamber Valve
- Secure Bungee Tie-Down
- Drain Valve
- Detachable Skeg
- Directional Strake
STANDARD EQUIPMENT
- Adjustable Seats (2)
- Adjustable Foot Rests (2)
- Inflatable Child Seat (or dog)
- Double-sided Aluminum Alloy Paddles (2)
- Repair Kit
- Strap
- Interconnecting Nozzles
- Carry Bag
- Removable Skeg
- Double Actionhand Pump
PRODUCT INFORMATION
- Kindly note that the pressure gauge will not change until the kayak is inflated to 5 PSI.
- Please do not overinflate the Side Chamber Valve to avoid damage.
- The Floor Chamber Valve needs to be continuously inflated to make the pressure gauge display the correct pressure value.
ASSEMBLY TIPS
- Locate a clean area free of stones or other sharp objects, unfold and spread out the kayak flat, fill each chamber until it is stiff to the touch but NOT hard.
- This hand pump includes 3 interconnecting nozzles with hoses to inflate the kayak. Remove the adapter hose from the inflation port and attach to the inflatable port.(see Figure A)
- Unscrew the can of this double action pump to save vour energy when vou pump (see Figure B)
HOW TO USE
Removable skeg :
It is recommended to use the detachable skeg in deep water (lake, sea) where it will allow you to move forward in a straight line. Do not use it in shallow water or white water: the skeg would deteriorate the bottom of the kayak in shallow water and reduce the maneuverability in white water.
After the skeg is assembled, please push the lock pin in the skeg. The skeg cannot be installed when the kayak is fully inflated. The curvature of the skeg must be pointed towards the back end of the kayak. (see Figure C)
Side chamber valve:
1. Unscrew the valve cap counterclockwise from the Valve Insert.(see Figure
D)
2. Insert the pump hose end piece and inflate it until you will reach the
required pressure. (see Figure E)
3. After inflation, tighten the valve caps clockwise to prevent air from
leaking.
4. To release air from the side tubes, unscrew the valve insert from the
valve base counterclockwise.
Floor chamber valve:
- Unscrew the valve cap counterclockwise from the valve insert. (see Figure F)
- Insert the pump hose end piece and inflate it until you will reach the required pressure. ( see Figure G)
- After inflation, tighten the valve caps clockwise to prevent air from leaking.
- To release air from the bottom tube, press the valve insert from the valve base counterclockwise.
Adjustable seats:
Equipped with 2 adjustable seats. Place the seat into the kayak to match the position of the velcro strips on the floor.
And fasten the straps from the sides of the backrest to the D-rings on the inside of the kayak. Tighten the straps as needed for proper back support.You can choose the seat position for one or two persons. (see Figure H)
Adjustable seats:
Equipped with 1 padded child seat. Place the seat into the kayak to match the
position of the velcro strips on the floor (in the middle). ( see Figure I)
Equipped with 2 adjustable footrests that allow riders to have a sturdy base
to brace against when paddling. Place the see figure to the Kayak to match the
position of the velcro strips on the floor (before the adjustable seats).
CUSTOMER SUPPORT
Go to Your Orders, find your order in list, and click Get Product Support.
Problem with the order? Please email us: at
WolfArmorUSA@hotmail.com to give us a
chance to help you first.
Do you love your new WOLF ARMOR product? Help others find it by leaving a
product review online!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>