Lomax A2-BeBa_24892 L Shaped Acrylic Bath User Guide

Table of Contents

Before xing remove ALL protective covering and examine carefully. The polythene lm must be removed in full and the panel checked for any visible damage.
Unpack and check the product is complete and undamaged.
Have the correct tools available.
Please notify the retailer immediately of any damage or faults. The manufacturer cannot be held responsible for any installation costs that may arise from damaged or faulty products being installed. The guarantee does not cover impact-related damage. Please dispose of all packaging with due regard to the environment.
Please note : Read the installation instructions first. Although these instructions are comprehensive, it is always recommended that a technically competent installer should undertake the installation.

Handle the panel with care.
Should the cutting of panels be necessary (due to water pipes or skirting boards) a small ne toothed saw or sharp knife is recommended.
When drilling walls or doors, check first for hidden pipes and cables.
Use safety eyewear when drilling.
Keep small parts away from children.

*Tools shown not supplied

We have taken great care to ensure that this product reaches you in perfect condition. However, should any parts be damaged or missing please contact your point of purchase. This does not affect your statutory rights. In addition, if you require replacement parts your point of purchase will be happy to assist

Place the bath panel into position. (See Fig. I)
Ensure that the panel is vertical using a spirit level. Note – If fixing both the end and front panel check that the end panel is located behind the front panel at the corner joint.
Mark a line on the floor along the length Of the panel then remove the panel. (See Fig. 1)
Using suitable fixings secure the panel clips along the edge of the marked line on the floor, aligning to the panel clips ached to the underside of the bath. (see Fig. 2)
Push the panel into position so that it is held by the panel clips fixed to the floor and to the underside of the bath. (see Fig. 3)

Clean using warm soapy water only. Do not use scourers, abrasives, or chemical cleaners.

Please Note

Read through the instruction booklet first before commencing any work. If you are unsure of any aspect of the installation, we recommend you contact a reputable tradesperson.
Before fitting your panel, carefully remove all the packaging and film from the panel and examine the panel for damage and suitability of color match.
Check the panel fit and match before installation.
Any refixing costs or claims for wrong color match and/or any other fault will not be accepted after fixing.

NO claims for the above Will be accepted once the bath is fitted.