Nita 2m Smart LED Light Strip Instruction Manual
- June 17, 2024
- nita
Table of Contents
SMART LED LIGHTSTRIP
Indoor Base 16 Million Colors
2m Smart LED Light Strip
Instructions Manual
Technical specifications
- Alexa compatible: Da/Yes
- Android compatible: Da/Yes
- Google Assistant compatible: Da/Yes
- iOS compatible: Da/Yes
- Working power: 24V<27W
- Working voltage: AC220-240V
- Tuya protocol: Da/Yes
- Power supply ripple: <250mV
- Puttered max standby: <0.5W
- Working temperature and humidity: -20~45°/<80%RH
- Net weight: 250g
- Gross weight: 325g
- Working current Max: 0.015A
- Nozzle: LED
- LED type: 5050RGB+2835C+2835W
- Luminous flux: 800 LM
- Gama/Range: NITA CONNECTED LIGHTING
- GIP code: IP44
- Height: 4mm
- Width: 14mm
- Length: 2000mm
- Material: Silicon
- Correlated color temperature: RGB+(3000-6500K)
- Product type: LED Lightstrip
- Warranty: 2 ani/2 years
Product specifications
Make a temporary installation (without detaching the adhesive backing tape) before installing permanently by holding the strip in place with removable tape. Check the position, light effect, required length, remote control and power connection of the strip.
Do not power the strip in the packing reel
With the power disconnected only cut the strip at cutting points
Installation guide – PLEASE NOTE: Ensure the power is not connected
before proceeding.
Choose a suitable indoor, dry, clean, solid and smooth surface for the strip.
Avoid sandy, rough and Fiexible surfaces. Ensure the temperature of the strip
is at least 10° before installation. Remove all the dust and wipe the surface
line with dry cloth (Fig.1).
If the strip requires cutting, only cut the strip with a suitable tool at the
cutting points with the power off.
Once you have checked the position of the strip and power connection, with the
power off, carefully apply the strip to the surface by continuously removing a
portion of the adhesive backing tape as required (Fig.2).
Stick the strip and carefully press down on the strip for about 10 seconds
(avoid pressing on the LED’s) (Fig.3).
For a durable and secure installation, alternative screw fittings may be
required depending on the surface (Fig.4).
Connect the receiver module of the strip to the supplied plug (Fig.5).
Do not use diferent plug. Then connect the plug to the mains.
Now the strip is ready to operate.
Receiver Control
Short press to change the mode
Double press: ON/OFF
Long press (5 seconds): recovery mode
The receiver controller is not included in the package
Always disconnect from main supply before installation, connection and
servicing.
Risk of electric shock, do not use with extension cord near water or where
water may accumulate.
Avoid liquids on all electrical parts.
Do not connect the lightstrip to the supply while it is in the packing or
wound onto a reel.
This lightstrip must not be used without all gaskets being in place.
Do not connect this lightstrip to another manufacture’s product.
Interconnections shall be made only using the supplied connectors.
Clean with a dry cloth duster, do not use abrasives or solvents.
The light source of this luminaire is not replaceable; when the light source
reaches its end of life the whole luminaire shall be replaced.
The product is suitable for dry indoor usage.
Maximum allowed to extend it is up to 10m by interconnection.
Use only LED driver provided with the LED strip starter kit. For extension
product, only can work together with starter kit product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>