Gayuan PA-CB01 PrintModa Studio Printable Cotton Instruction Manual
- June 15, 2024
- Gayuan
Table of Contents
Gayuan PA-CB01 PrintModa Studio Printable Cotton
Specification
Accessories List
Installation
Step 1: The control box is installed on the faucet by connecting the
pipes as following figure.
Step 2: The control box can be powered up by installing four 4AA alkaline
batteries. The sensor starts to work after installing one CR2450 in it. (The
faucet handle must be opened.)
Operation condition
Features
Repair
If the sensor or the control box is lost or damaged, the new sensor or the new
control box could be rematched by following steps.
Step 1: Power up the control box and long press the bottom for more than
3 seconds.
Step 2: The sensor will send the matching information after the power-on
reset.
Step 3: If the control box receives the matching information
successfully, the sensor function resumes.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, under Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used by the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with a minimum 20cm distance between the radiator and your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>