Kmart 43307470 Playstation Icons Light Instruction Manual
- June 17, 2024
- Kmart
Table of Contents
Instruction Manual
43307470 Playstation Icons Light
ICONS LIGHT INSTRUCTIONS
Flat Dimensions: 210 (H) x 297mm (W)
PLAYSTATION ICONS LIGHT
Instructions
CONTENTS
WARNNINGS/INSTALLATION
The light can be powered by batteries or by micro USB. When the micro USB
cable is connected to the base the batteries will be bypassed. Caution! This
product is not to be directly connected to the mains supply. This item can be
used with a compatible mains powered transformer. This must be a short-circuit
proof safety isolating transformer according to IEC 61558-2-16 or a toys
transformer according to IEC 61558-2-7. Max rated output: 5V DC
FUNCTIONS
WARNNINGS/BATTERY INSTALLATION
Caution! This light is not a toy. LEDs are not replaceable. To insert /
replace batteries: Use 3 x 1.5v type AAA batteries. Take care to fit batteries
observing the plus & minus markings. Replace all used batteries at the same
time. Do not mix used and new batteries, rechargeable, different types
(alkaline or carbon zinc), or different brands of batteries. Only use
batteries of the same type. Non-rechargeable batteries are not to be
recharged. Rechargeable batteries are to be removed from the product before
being charged. Rechargeable batteries are only to be charged under adult
supervision. The supply terminals are not to be short-circuited. Exhausted
batteries are to be removed immediately. Unscrew battery cover and insert
batteries, observing polarity guide. Ensure battery cover is securely screwed
in place before use. The crossed out wheelie-bin symbol on this product is to
remind you that waste electrical and electronic products, batteries and
accumulators should not be disposed of with household waste. If you are unable
to re-use or recycle your article it should be disposed of at a civic amenity
site/local authority recycling facilities. Under the environment with
electrostatic discharge the device may malfunction. lf this happens, you will
need to reset the device by turning it off/on again.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. tf this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equioment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consutt the dealer or an experienced radio/ TV technician for help.
MADE IN CHINA
FOR AU / NZ: IMPORTED FOR KMART MICRO USB INPUT
STORES IN AUSTRALIA AND NEW ZEALAND. = 5V DC 500mA
43-307-470 26/23 ****
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>