Duratool D03047 500 V AC/DC Manual Ranging Digital Multimeter User Guide
- June 17, 2024
- Duratool
Table of Contents
Duratool D03047 500 V AC/DC Manual Ranging Digital Multimeter
Product Information
Specifications
| Specification | Detail |
|---|---|
| Voltage Measurement Safety Limit | 60V DC or 30V AC rms |
| Measurement Duration Limit | Less than 10 seconds per measurement |
Product Usage Instructions
Getting Started
Before using the product, ensure that it is properly assembled and connected
to the power source.
Operation
To operate the product, follow these steps:
- Turn on the power button located on the device.
- Use the control panel to select your desired settings.
- Press the start button to begin the operation.
Maintenance
Regular maintenance is essential for the product’s longevity. Follow these
maintenance tips:
- Clean the product after each use to prevent buildup.
- Check for any loose parts and tighten them if necessary.
- Refer to the user manual for specific maintenance guidelines.
Troubleshooting Steps
Check the test leads, probes and case insulation before using. If you find any breakage or abnormality, or you consider the device is broken, stop using the device immediately.
- When using the test probes, keep your fingers behind the finger protection ring.
- Do not use the meter with the back cover open.
- Select the appropriate test range for measurements.
- Ensure all inputs are less than the range selected otherwise, it may cause electrical shock or meter damage.
- Do not change the range selector position during voltage or current measurements.
- Do not apply a voltage exceeding the marked voltage between the COM terminal and the ground.
- Take caution when working voltages are above 60V DC or 30V AC rms.
- Do not connect the meter to voltage signals when the range selector is on current, resistance, diode or continuity range.
- When measuring current, each single measurement should be shorter than 10 seconds.
FAQ
-
Q: What should I do if the product stops working?
A: If the product stops working, first check the power source and connections. If the issue persists, contact customer support for assistance. -
Q: How often should I clean the product?
A: It is recommended to clean the product after each use to maintain optimal performance. -
What should I check before using the device?
Check the test leads, probes, and case insulation for any breakage or abnormality before use. -
What is the maximum voltage for safe measurements?
The maximum working voltage for safe measurements is 60V DC or 30V AC rms. -
How long can a current measurement be taken?
Each current measurement should be shorter than 10 seconds to prevent damage to the meter or for safety. -
Can I change the range selector while a measurement is in progress?
No, you should not change the range selector position during voltage or current measurements.