SPEC D LT-WRX15JMLED-SQ-TM Sequential Bar LED Tail Lamps Instruction Manual
- June 17, 2024
- SPEC D
Table of Contents
**INNOVATE PERFESSIONAL SERVICE
INSTALLATION & CARE**
2015 -2019 SUBARU WRX SWITCHBACK SEQUENTIAL LED TAIL LIGHTS INSTALLATION INSTRUCTIONS
BEFORE INSTALLATION:
- If you experience any difficulties that the instructions did not cover, please seek assistance at a local automotive shop.
- Please wear proper protective equipment before you work on any vehicle.
- An assistant is recommended when removing the front bumper from your vehicle.
- Please be cautious when working with the bumper or any parts belonging to the vehicle’s body to prevent scratching.
- Do not make direct contact with the halogen bulbs or the wire assembly until the unit has cooled down after use.
TOOLS AND SUPPLIES REQUIRED
1/4 Ratchet| 8 mm socket| Plastic Pry bar| Trim Pad
Remover
---|---|---|---
| | |
| | |
| | |
| | |
| | |
PRODUCT NUMBER
LT-WRX15JMLED-SQ-TM
LT-WRX15BBLED-SQ-TM
LT-WRX15BKLED-SQ-TM
LT-WRX15RLED-SQ-TM
LT-WRX15GLED-SQ-TM
LET’S START THE INSTALLATION
Remove the three plactic clips
Remove the trunk trim panel cover
Remove the three plactic clips and pull out the trunk side liner cover to access the back of the tail light
Disconnect the tail light hamess and remove the three 8mm tail light mounting nuts
Remove the factory tail light housing
Seat the new tail light assembly in place
Reinstall the three 8mm tail light mounting nuts
Connect the tail light harness
Connect the tail light resistor and set the resistor on the metal area
Reinstall the trunk side liner cover and the three plastic clips
Please repeat the steps from 3 to 10 for the opposite side
Close the trunk to complete installation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>