FORIOUS FB-0300 Two Handle Black Bathroom Faucet Instructions
- June 17, 2024
- FORIOUS
Table of Contents
FORIOUS FB-0300 Two Handle Black Bathroom Faucet
PARTS
INSTALLATION INSTRUCTIONS
FORIOUS INSTALLATION INSTRUCTIONS
Suitable for All FORIOUS Widespread Bathroom Faucets:
Before Installation:
- Turn off the water supply valves. Clean the mounting area of the sink.
- Recommended width of mounting area is between 15cm-31cm (6″-12*) measured between centers of outside mount holes as shown in the diagram.
- Diameter of mount holes must be between 32mm-35mm (1.26″-1.38*) as shown in the diagram.
- Max countertop thickness is 35mm (1.38″)
- Water pressure Min 0.05MPa (7 psi) / Max 0.75MPa (109 psi)
- Water temp Min ≥ 20°C (68″F) / Max s 85°C (185″F)
Installation Steps
-
Feed hose through center mount hole and fit the faucet onto the sink.
-
Beneath the sink, slide the rubber washer, metal washer and mounting nut onto the threaded end of the faucet.
-
Tighten the mounting nut by hand so that the faucet is firmly connected to the sink, be careful not to over-tighten.
-
Insert the two mount screws onto the mounting nut to fix it in place, again don’t over-tighten.
-
Carefully screw the male ends of the cold and hot water supply hoses into the respective faucets (blue=cold, red=hot) and tighten firmly by hand.
-
Fit the handles onto the sink using the correct outside mount holes and apply steps #3-#5 above to secure the handles.
-
Firmly connect the black water hose to the handles by attaching the quick connectors to the fittings extending from the bottom of each handle.
-
Firmly connect the quick connector in the middle of the black water hose to the short faucet hose. Check that there are no kinks in the hoses.
Note: The black water hose must be installed crosswise, as shown in the figure. -
Connect the hot and cold water hoses to the water supply valves.
Secure the connections with a wrench. Open water supply valves and check for leaks. -
Install the pop-up sink drain stopper.
Maintenance
- Always operate the faucet gently to ensure years of use.
- To maintain the finish, always blot dry any water on the faucet surface. Clean with a damp non-abrasive sponge and wipe dry with a clean soft cloth.
- Although the finish is very durable, certain cleaners can damage it. DO NOT use detergent powder. polishing powder, a nylon brush, or anything that may scratch the finish.
- DO NOT use acidic cleaners on the faucet.
- If air temperature falls below freezing (0°C / 32° F). run the faucet to prevent freezing.
- Shut off water supply valve when not in use for long periods.
- We reserve the right to make revisions to product design without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>