Aiper 6002 Seagull Pro Cordless Robotic Pool Cleaner User Manual

Aiper 6002 Seagull Pro Cordless Robotic Pool Cleaner

Product Information

Aiper Seagull Pro

Specifications

• Model: Aiper Seagull Pro
• Power Source: Battery
• Battery Type: Lithium-ion
• Battery Capacity: Not specified
• Charging Time: Not specified
• Runtime: Not specified
• Cleaning Modes: Multiple modes (exact number not specified)
• Pool Compatibility: Suitable for all pool types
• Warranty: 24-month battery warranty

Product Usage Instructions:

Charging the Device
Before using the Aiper Seagull Pro, ensure that the device is fully charged by following these steps:

1. Turn off the device if it is powered on.
2. Check if there is any debris blocking the charging port.
3. Connect the charger correctly to the device.
4. Verify if the LED indicator is turned on. If not, please contact Aiper customer service.

Cleaning and Wall Climbing Issues:
If your Aiper Seagull Pro is not cleaning or climbing your pool’s wall properly, please follow these troubleshooting steps:

1. Inspect the roller brush for excessive wear. If the brush is in poor condition, contact customer service for a replacement.
2. Ensure the wheel gear is properly attached and secured. If it has fallen off or falls off during operation, contact Aiper customer service for a replacement part.
3. Clean the filter basket before each use to prevent solidified debris from affecting the device’s performance.
4. Note that the device’s ability to traverse curved walls may be affected.

Mode Dial Issues:
If the mode dial of your Aiper Seagull Pro is not turning, try the following:

• Check if small debris has become lodged under the mode dial.
• Use a hose or high-pressure water gun to clean the area around the knob.

Upper Cover of Garbage Bin
If the upper cover of the garbage bin is not tight, follow these steps:

• Press firmly on the upper cover until you hear it close tightly.
• Press on the cover to ensure it doesn’t spring up again.

Battery Life and Replacement:
If your device does not clean as long as advertised or you need to replace the battery, consider the following:

1. Check the LED indicator to ensure the device is fully charged before each cleaning.
2. Remove any debris obstructing the rotor, as it can significantly impair performance.
3. The battery comes with a 24-month warranty. If not covered under warranty, parts and services may be purchased separately.

Trash Leakage
If trash frequently leaks after the machine is taken out of water, try these steps:

1. Check if the inlet cover at the bottom of the trash bin is obstructed.
2. Clean the filter basket after each use to prevent potential debris overflow or leakage.

Top Water Outlets Not Working:
If the top water outlets of your device are not functioning underwater, follow these steps:

1. Shut down the drain motor for a short time to allow the machine to automatically correct itself if it is trapped.
2. If a boot error occurs during startup, restart the machine and allow it to correct itself.

Alarm Sound and Flashing Red Light
If you hear an alarm sound and see a flashing red light, it indicates a blocked rotor or a flooded motor. Please contact customer support for replacement or repair.

Frequently Asked Questions (FAQ)

Q: Why won’t the machine charge?
A:

1. First, make sure the device is turned off. Devices that are powered on will not charge.
2. Check if there is any debris blocking the charging port. If the charger isn’t correctly connected, the device will not charge.
3. Check if the LED indicator is on. If not, please contact Aiper customer service.

Q: Why is my device not cleaning or climbing my pool’s wall?
A:

1. Check the roller brush for excessive wear. If the brush is in poor condition, please contact customer service for a replacement roller brush.
2. Check that the wheel gear is properly attached and secured. If you discover the wheel gear has fallen off or falls off during operation, please contact Aiper customer service for a replacement part.
3. Ensure the filter basket is clean before each use, as solidified debris may prevent the device from operating at full capability.
4. If your pool has curved walls, this will affect the device’s ability to traverse your pool’s walls.

Q: Why won’t the mode dial turn?
A: Check if small debris has become lodged under the mode dial. Use a hose or high-pressure water gun to clean the area around the knob.

Q: Why is the upper cover of the garbage bin not tight?
A: Press firmly on the upper cover until you hear it close tight. Press on the cover to ensure it doesn’t spring up again.

Q: Why does my device not clean as long as advertised? Can the battery be replaced?
A:

1. Please check the LED indicator to ensure the device is fully charged before each cleaning.
2. Check if any debris is obstructing the rotor, as an obstruction can significantly impair the device’s performance.
3. The battery comes with a 24-month warranty and potential repairs may be covered. If your device is not covered under warranty, parts and services may be purchased separately.

Q: Why does trash frequently leak out after the machine being taken out of water?
A:

1. Check if the inlet cover at the bottom of the trash bin is obstructed in any way as this can cause debris to fall out.
2. Clean the filter basket after each use to prevent any potential debris from overflowing or leaking from the filter basket.

Q: Why are the device’s top water outlets not working under water?
A:

1. The machine may be trapped, shut down the drain motor for a short time to allow the machine to automatically correct itself.
2. A boot error may have occurred during start-up, please restart the machine and allow the device to correct itself.

Q: Why is there an alarm sound and a flashing red light?
A: The flashing red light means the rotor is blocked or the motor is flooded. Please contact customer support for replacement or repair.

Aiper Seagull Pro

Frequently Asked Questions (FAQ)

Q: Why won’t the machine charge?

1. First, make sure the device is turned off . Devices that are powered on will not charge.
2. Check if there is any debris blocking the charging port. If the charger isn’t correctly connected, the device will not charge.
3. Check if the LED indicator is on. If not, please contact Aiper customer service

Q: Why is my device not cleaning or climbing my pool’s wall?

1. Check the roller brush for excessive wear. If the brush is in poor condition, please contact customer service for a replacement roller brush.
2. Check that the wheel gear is properly attached and secured. If you discover the wheel gear has fallen off , or falls off during operation, please contact Aiper customer service for a replacement part.
3. Ensure the filter basket is clean before each use, as solidified debris may prevent the device from operating at full capability.
4. If your pool has curved walls, this will affect the device’s ability to traverse your pool’s walls.

Q: Why does my device not clean as long as advertised? Can the battery be replaced?

1. Please check the LED indicator to ensure the device is fully charged before each cleaning.
2. Check if any debris is obstructing the rotor, as an obstruction can significantly impair the device’s performance.
3. The battery comes with a 24-month warranty and potential repairs may be covered. If your device is not covered under warranty, parts and services may be purchased separately.

Q: Why does trash frequently leak out after the machine being taken out of water?

1. Check if the inlet cover at the bottom of the trash bin is obstructed in any way as this can cause debris to fall out
2. Clean the filter basket after each use to prevent any potential debris from overflowing or leaking from the filter basket.

Q: Why are the devices top water outlets not working under water?

1. The machine may be trapped, shut down the drain motor for a short time to allow the machine to automatically correct itself.
2. A boot error may have occurred during start-up, please restart the machine, and allow the device to correct itself.

Why won’t the mode dial turn?

Check if small debris has become lodged under the mode dial. Use a hose or high-pressure water gun to clean the area around the knob.

Why is the upper cover of the garbage bin not tight?

Press firmly on the upper cover until you hear it close tight. Press on the cover to ensure it doesn’t spring up again.

Why is there an alarm sound and a flashing red light?

The flashing red light means the rotor is blocked or the motor is flooded. Please contact customer support for replacement or repair.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>