PERCEPT MPU11 Dual USB Rapid Charger Outlet Cover User Manual
- June 17, 2024
- PERCEPT
Table of Contents
PERCEPT MPU11 Dual USB Rapid Charger Outlet Cover User Manual
Before You Begin…
MPU11
100Percent
Input : 120V-, 60Hz, 0.SA Max
Output : S.0Vdc, 3.1 A (Total)
ATTENTION
To comply with the published safety standards, the following must be observed
when using this adapter.
- These charger are suitable for use with information technology equipment.
- These charger are intended to be operated up to 2000m above sea level.
- These charger are suitable for use in tropical and/or moderate climates.
- The rated maximum ambient temperature must not exceed 40°C.
- The charger are not intended to be repaired by service personnel in case of failure or component defect.
- These power adaptors do not require much attention. If you want to clean it, please use only dry cloths or a brush.
- A readily accessible disconnect device shall be incorporated external to the equipment.
WARNING : It is ABSOLUTELY CRITICAL that power has been shut off from the fuse panel or circuit breaker box to the designated outlet before installing this item. Placement of this item CANNOT BE DONE SAFELY UNLESS POWER HAS BEEN DISCONNECTED at the breaker panel or fuse panel for the property.
ONCE POWER HAS BEEN DISCONNECTED , test the outlet using a voltage meter capable of making the proper readings PRIOR to the installation of the item to ensure that the power has been properly disconnected.
If you are unsure or confused about anything presented in this manual involving disconnecting the power to a circuit, please consult a QUALIFIED ELECTRICIAN.
In the Box
Installation
1. Turn Off the Power
Locate the electrical cutoff point (fuse box, breaker panel, etc.) and turn off the power to the outlet being used by turning off the breaker switch or removing the fuse, as necessary.
NOTE : If you are unsure what this is or where it is located, please consult a qualified electrician.
After the outlet is powered OFF, test it using a voltage meter or by plugging a device into the outlet, such as a light, and turning it ON.
Once you have confirmed that the power to the outlet is OFF, you may proceed to step 2.
2. Remove the Existing Face Cover
NOTE: This section will require the use of a screw driver.
Unscrew and remove the existing face cover from the wall to reveal the outlet.
WARNING : Only unscrew the center screw. Do NOT remove the top or bottom screws from the outlet, this may damage the outlet or cause harm to the user.
3. Install the 100 Percent Face Cover Charger
Slide the face cover charger into the outlet so that the two prongs clip
into place on both sides of the middle of the outlet.
4. Finish Up
Screw the Face Cover screw into the outlet’s center screw hole.
NOTE : Do NOT tighten the screw too much, this may strip the screw threading.
Return power to the outlet via breaker or circuit box and test to ensure it is functioning.
Using the Charger
The Face Cover Charger can be use to charge up to two USB devices.
The left USB port is a 2.1 A port and the right a 1 A port. Use the 2.1 A port
to charge devices more quickly.
While usingthe USB ports, the LED indicator will turn ON.
Up to 2 devices can be plugged in at one time. While plugged in, the wall outlets will still be usable.
Questions and Customer Support
For any questions or support with our product, please visit us at our website:
www.SouthernTelecom.com
Click on Product Support
Additional Safety Information
Read and keep these instructions. Heed all warnings.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug.
A polarized plug has two blades with one wider than the other. A grounding
type plug has two blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. When the provided plug does not fit
into your outlet, consult an electrician for replacement of the obsolete
outlet.
10. Only use attachments/accessories specified by the manufacturer.
11. Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as power-supply cord or
plug is damaged; liquid has been spilled or objects have fallen into the
apparatus; the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
12. WARNING: The mains plug is used as a disconnect device; the disconnect
device shall remain readily operable.
13. WARNING: To reduce the risk of fire or electric shock, do not expose this
apparatus to rain or moisture. The apparatus shall not be exposed to dripping
or splashing, and objects filled with liquids, such as vases, shall not be
placed on apparatus.
Legal Information
READ CAREFULLY AND KEEP THIS MANUAL
Caution : Any changes or modifications not expressly approved could void
the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Rain/Moisture Warning
- Do not expose the unit to extreme temperatures (heat or cold), open flames, humid conditions, or wet conditions.
- Do not submerge in water.
- Do not open this product or attempt to repair the unit yourself should it not be working.
Limited Warranty
90 Days Limited Warranty
In the unlikely event that this product is defective, or does not perform
properly, you may within ninety (90) days from your original date of purchase
return it to the authorized service center for repair or exchange.
TO OBTAIN WARRANTY SERVICE:
- Go to our website portal to receive an SRO number.
- Provide proof of the date of purchase within the package (dated bill of sale).
- Prepay all shipping costs to the authorized service center, and remember to insure your return.
- Include a return shipping address (no P.O. Boxes), a telephone contact number, and the defective unit within the package.
- Describe the defect or reason you are returning the product.
Your product will be repaired or replaced, at our option, for the same or
similar model of equal value if examination by the service center determines
this product is defective.
Products received damaged as a result of shipping will require you to file a
claim with the carrier.
The shipping address of the authorized service center is:
<69 Customer Service Dept. 36
c/o Southern Telecom
400 Kennedy Drive
Sayreville NJ 08872
Should have any questions or problems concerning this product, please visit
our website at
www.SouthernTelecom.com and click on
Product Support.
Warranty Service Not Provided
This warranty does not cover damage resulting from accident, misuse, abuse,
improper installation or operation, lack of reasonable care, and unauthorized
modification. This warranty is voided in the event any unauthorized person
opens, alters or repairs this product.
All products being returned to the authorized service center for repair must
be suitably packaged.
Limitation of Warranty
- THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES, EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE) ARE HEREBY DISCLAIMED. NO VERBAL OR WRITTEN INFORMATION GIVEN BY AIT, INC. ITS AGENTS, OR EMPLOYEES SHALL CREATE A GUARANTY OR IN ANY WAY INCREASE THE SCOPE OF THIS WARRANTY.
- REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER. AIT, INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER OF WARRANTIES AND LIMITED WARRANTY ARE GOVERNED BYTHE LAWS OF THE STATE OF NEW YORK. EXCEPTTO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTIBILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE.
Some states do not allow the exclusion nor limitation of incidental or consequential damages, or limations on how long an implied warranty lasts so the above limitations on exclusions may not apply to you. This warranty gives you specific legal rights, and you also may have other rights that vary from state to state.
Printed in China
vl.07/2017
Documents / Resources
|
PERCEPT MPU11 Dual USB Rapid Charger Outlet
Cover
[pdf] User Manual
MPU11 Dual USB Rapid Charger Outlet Cover, MPU11, Dual USB Rapid Charger
Outlet Cover, Rapid Charger Outlet Cover, Charger Outlet Cover, Outlet Cover
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>