Puroma B07Z1Y4HY4 4 Digit Combination key Storage Lock Box Instruction Manual

Puroma B07Z1Y4HY4 4 Digit Combination key Storage Lock Box Instruction Manual

Product Using Instruction

To open the key box:

1. Slide the shutter board, scroll dials to the combination you set. The Factory Default Code is 0-0-0-0.
2. Push down the black button near the dials to open the box.
3. After the box door is open, keys can be put in or taken away.
4. After closing the door, mess up the dials to protect your combination and close the shutter board

To set your combination:

1. Open the key box, keep dials at the correct combination. (Factory default combination is 0-0-0-0).

2. Push the RESET button from position A to position B, as shown in Pic.1.
   

3. Now scroll dials to set your own combination.

4. Push the RESET button back to position A. Now the new combination has been set. Take a photo to save your password.

Important check operation:

• Do not close the door and mess up the dials, perform two verifications firstly:

1. Test whether the black button can be slid.
   If pass, proceed to the step ;
   If not, it means that the password is wrong. Please try the following steps to retrieve it, otherwise stop using the product. 2
   It is not aligned with the reference line while changing the password, which causes the actual new combination have a deviation of 1 digit from the combination you want.
   Solution: Dial a wheel to the previous or next number to test (for example, dial 2 to 1 or 3), and change only one wheel at a time until the correct combination is retrieved.
   a)
   After changing the combination, you unconsciously mess up the dials.
   Solution: Dial to the combination you set and try again.

2. Don’t close the door, mess up the wheels, and dial back the password you set to test whether the black button can be slid.

If pass, it means that the new combination is set successfully, and the actual new combination is the same as what you want to set. Take a photo to save your combination.

Important notes

• Keep the shutter board closed for water resistance.

• Always look straight on the numbers of the dials, otherwise you may misalign them with the reference line, which could cause the password actually set is different from what you want.
  

• If you cannot open the lock by the default code “0000” on first use, please try with the code “1000”, “0001”, “9000” or “0009” to open again.

• It is recommended that the dials are scrolled weekly to keep them work well.

Package Content

1 x Combination Lock Box
4 x Screws
4 x Plastic Expanded Plugs
2 x Black Rubber Plugs
1 x User Manual

Method 1: Lock on the door handle

Method 2: Mount on the wall

1. Open the box, pull the button inside the box from right sid e to left to plug out/in the shackle.

2. Insert black rubber plugs into the 2 small holes at the top of box to prevent dust and water from entering the box.
   

3. There are 5 holes in the back of the box, hold the box to the wall and mark position of holes with a pencil.

4. Using impact drill the holes into wall. The diameter of every small hole is 6mm.

5. Knock the plastic expanded plugs into the hole.

6. Place the box against wall with screws.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>