cecotec 2070 MAX DUAL WHITE Fan Heater Instruction Manual

: June 17, 2024
: cecotec

Table of Contents

SAFETY INSTRUCTIONS
PARTS AND COMPONENTS
BEFORE USE
OPERATION
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
TECHNICAL SUPPORT AND WARRANTY
COPYRIGHT
Customer Support
Read User Manual Online (PDF format)
Download This Manual (PDF format)

cecotec 2070 MAX DUAL WHITE Fan Heater

This product is not suitable for primary heating purposes.
This product is only suitable for well insulated spaces or occasional use.

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the device.
Keep this instruction manual for future reference or new users.

Make sure the voltage of your mains supply matches the voltage requirements specified in the rating label of the appliance.
This device is designed for domestic use only and is not intended for bars, restaurants, farmhouses, hotels, motels, and offices.
If the power cable is damaged, it must be replaced by the
Technical Support Service of Cecotecor similar qualified personnel to avoid risks.
This symbol means “do not cover”.
WARNING: to avoid overheating, do not cover the appliance.
The heating appliance must not be placed immediately below a socket outlet.
Do not use the heating appliance in the immediate vicinity of a bath, shower, or swimming pool.
Do not use this heating appliance if it has been dropped.
Do not use if there are visible signs of damage to the heating appliance.
Use this heating appliance on a horizontal and stable surface, or fix it to the wall, as applicable.
Keep the device out of the reach of children under 3 years old, unless constantly supervised.
Children between 3 and 8 years old should only switch the appliance on or off when it has been placed in its normal, intended operating position and if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children between 3 and 8 years old should not plug in, adjust, and clean the appliance and should not carry out maintenance tasks.
WARNING: some of the product’s parts may become very hot and cause burns. Particular attention should be paid when children and/or vulnerable people are present.
WARNING: do not use this heating device in small rooms that are occupied by people who cannot leave the room by themselves, unless permanent supervision is provided.
WARNING: to reduce the risk of fire, keep textiles, curtains, or other flammable material at least 1 m away from the air outlet.
Do not insert or allow objects to enter through the ventilation slots, as this may result in electric shock, fire, or damage to the appliance.
Do not immerse the cable, plug, or any other non-removable part of the appliance in water or any other liquid. Do not expose the electrical connections to water.
Always make sure that your hands are dry before operating or adjusting any switches on the product or touching the plug and socket.
Never leave the device unattended during use.
One of the most common causes of overheating is the building up of debris or fluff in the appliance. Be sure to clean these accumulations periodically by vacuuming the vents and grilles.
Do not place the appliance on carpets, and do not place the cable under carpets. Position the cord in such a way as to avoid obstructing passage and cause tripping hazards.
Do not store it until it cools down. Store it in a cool, dry place when not in use.
When using, maintain a minimum distance of 50 cm between the window and the wall.

PARTS AND COMPONENTS

Control knob
Thermostat knob
Light indicator
Handle
Air inlet grille
Air outlet grille

NOTE:
the graphics in this manual are schematic representations and may not exactly match the device.

BEFORE USE

This appliance is packaged in a way as to protect it during transport. Take the device out of its box and remove all packaging materials. You can keep the original box and other packaging elements in a safe place. This will help you prevent damage to the device when transporting it in the future. In case the original packaging is disposed of, make sure all packaging materials are recycled accordingly.
Make sure all parts and components are included and in good conditions. If there is any piece missing or in bad conditions, contact the official Cecotecor Technical Support Service immediately.

Box content

Heater
Instruction manual

OPERATION

Select a suitable location for the appliance considering all the warnings mentioned in this manual.
This heater cannot be hung but must stand: upright (on legs) or flat with the control knob and thermostat knob upwards.
Make sure that the heater, when in operation, is always placed on a firm, flat, horizontal surface.
Check if the control knob is in the OFF position (0).
Fully extend the power cable and plug it into the power outlet.
To avoid overloading the circuit, check that no other appliances are connected to the same unit.
Turn the thermostat knob clockwise to the maximum position.

Switch on the heater by turning the control knob to one of the following three positions:

fan only (thermostat always at maximum)
heating at medium power (900W/1000W)
heating at maximum power (1800W/2000W).
The light on the front will turn on.
It is most economical to heat the space at maximum power and then switch to medium power to maintain the temperature.
Both at medium and maximum power, the fan rotates at the same speed. The difference between the two lies in the number of heating elements in use.
Once the desired temperature has been reached, slowly turn the thermostat knob backwards until you hear a click. The temperature is now set. The heater will automatically switch on and off to maintain the selected temperature.
When the heater is switched off, the pilot light will also go out.
To set a higher or lower temperature, turn the thermostat knob clockwise or counterclockwise.
To turn the heater off, turn the thermostat knob to “O” (off). The pilot light will go out. The pilot light indicates that the heater is switched on, not that it is connected to the mains.
Unplug it.

Protection against overheating

In case of internal overheating, the protection against overheating will turn off the heater.
This may occur if the heater cannot emit enough heat or if it cannot draw in enough fresh air.
As mentioned above, this is often caused by (partially) covering the heater, obstructing the air inlet and outlet grilles, or installing the heater too close to a wall or similar. When the protection against overheating switches the heater off, turn the thermostat knob to “O” (off), unplug the heater and allow it to cool down. Eliminate and/or modify the cause of the overheating and return the heater to normal operation. If the cause is not found and overheating occurs again, stop using the heater and have it checked/repaired.

CLEANING AND MAINTENANCE

Keep the appliance clean. Dust, dirt or deposits in the appliance often cause overheating.
Make sure that this type of accumulation is removed on a regular basis.
Always turn the appliance off, unplug it from the power supply and allow it to cool down before:

cleaning the device
performing maintenance of the device by the users
touching or moving the appliance.
Never switch on the device if you notice damage to the device, the cable, or the plug, if it is not working properly, if it makes strange noises, smells funny or you can see smoke, or if it has been dropped or shows any other signs of damage.
Unplug the cable from the power supply immediately. Have the appliance checked and/ or repaired by your supplier or a recognised electrician. Always request the use of original parts.
The device may only be opened and/or repaired by a competent and qualified person.
Do not carry out your own repairs, as this could be dangerous. Repairs carried out by unauthorised persons or modifications made to the device may damage the dust and water protection capability of the device and will void the manufacturer’s warranty and liability.
If the power cable is damaged, it must be replaced by the manufacturer, service technician or similarly qualified person in order to avoid creating a hazard.
Failure to comply with the above points may result in damage, fire and/or injury. The warranty will be invalidated and the supplier, importer and/or manufacturer will not be liable for the consequences.
Keep the heater clean. Dust and dirt deposits on the device are a common cause of overheating and should be removed regularly. Switch off the heater, remove the plug from the socket and allow the heater to cool down before cleaning or maintenance work.
Clean the outside of the heater regularly with a dry or slightly damp cloth. Do not use aggressive soaps, cleaning or abrasive sprays, waxes, polishes, or chemical solutions.

TECHNICAL SPECIFICATIONS

Product reference: 08284
Product: ReadyWarm 2070 Max Dual White
Supply voltage: 220-240 V, 50 Hz
Maximum capacity: 1800 W
Settings: 0-900-1800 W
Size: 26.3 x 14 x 25.7 cm
Weight: 1,1 kg

Name of the model:
08284_ReadyWarm 2070 Max Dual White

Technical specifications may change without prior notification to improve product quality. Made in China | Designed in Spain

DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES

This symbol indicates that, according to the applicable regulations, the product and/or batteries must be disposed of separately from household waste. When this product reaches the end of its shelf life, you should dispose of the cells/batteries/accumulators and take them to a collection point designated by the local authorities.
Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries. Compliance with the above guidelines will help protecting the environment.

TECHNICAL SUPPORT AND WARRANTY

Cecotecor shall be liable to the end user or consumer for any lack of conformity that exists at the time of delivery of the product under the terms, conditions, and deadlines established by the applicable regulations.
It is recommended that repairs be carried out by qualified personnel. If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact the official Cecotec Technical Support Service at +34 963 210 728.

COPYRIGHT

The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES, S.L. All rights reserved. The contents of this publication may not, in whole or in part, be reproduced, stored in a retrieval system, transmitted, or distributed by any means (electronic, mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC INNOVACIONES, S.L.