TASSULI Blanc Freestanding Bathtub User Manual

TASSULI Blanc Freestanding Bathtub

WARNING

1. Before using this bathtub, you must carefully read these instructions and keep them for future reference.
2. To install this bathtub, you must access the pipes located in the floor under the bathtub.
3. Make sure the pipes required to bring water and to drain it are adequate at the place where you want to install the bathtub.
4. To extend the life of the bathtub, never use water at over 80°C (176°F).
5. To clean the bathtub, please see the section on maintenance.

*CAUTION
The sizes provided herein are not intended as finished cut sizes. Never install unless you are in possession of the product. Measurements may vary as a result of improvements made to the product over time. Neither the manufacturer nor the distributor shall be liable for variances between the measurements shown here and the product’s actual measurements.
This product should be installed by a certified professional, in accordance with the regulations in effect.

INSTALLATION

After unpacking the bathtub, take the plastic pipe out.

Install the bathtub at the chosen place. Turn it upside down.
Adjust the feet so it is leveled and make sure they stand out from the frame at 1/8″ to 1/4” (3 mm to 6 mm) to avoid putting weight on the skirt of the tub. Once you have put the tub back on its feet, make sure they all rest on the floor and that everything is leveled.

Place the bathtub at the exact location where it will sit and align the drainage pipes (from the tub and on the floor).
Mark the floor around the outside of the skirt. Apply a bead of silicone or adhesive on the mark you made on the floor.
Don’t forget to take into account the space left from the feet.
Put the tub back in its place and allow the silicone to harden for 24 hours before completing the installation.

• Connect the draining pipes so that the water drains properly.
• Once the installation is finished, make sure all connections are watertight.
• Protect the surface of the bathtub while proceeding to the installation to avoid damages.
• Finish with a bead of silicone to provide rigidity to the skirt and to close the gap between the bathtub skirt and the floor.

NOTE

1. Push on the drainer cap to close it and push it again to open it and drain the tub.

MAINTENANCE

1. Use only soft soap to clean the surface. Never use an abrasive product, an acid or alkaline detergent or any solvent or sharp objects to clean the bathtub surface.
2. Polish the surface to make it shiny.
3. Clean the chrome with a soft soap.
4. After having used the bathtub, dry it with a soft cloth to avoid water stains.
5. If the drain gets clogged, simply unscrew the cap to remove what interrupts water flow.

SCOTIA
33002548

BLANC WHITE T2309

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>