Waterdrop WD-FC-02 Ultrafiltration UF Faucet Filtration System Owner’s Manual

Waterdrop WD-FC-02 Ultrafiltration UF Faucet Filtration System

About the System

Thanks for choosing the Waterdrop WD-FC-02 Ultrafiltration Faucet Filtration System!
This faucet filtration system will give you clean and healthy water with an Activated Carbon Fiber (ACF) filter and Ultrafiltration (UF) membrane filter. The accuracy of UF filtration will be up to 0.1 microns so that it will effectively filter rust, chlorine, unpleasant taste and odour, heavy metals, bleaching powder, and red worms. The system ensures to leave beneficial minerals in drinking water to maintain health.

System Specifications

To achieve optimal performance, it is recommended to use the system within the system specifications.

• System Model No. – — — — — — — — WD-FC-02
• Replacement Model No. — — — — – WD-FF-02A
• Rated Capacity* — — — — — — — — — — 320 gallons/ 1,200 liters
• Rated Flow – — — — — — — — — — — — — 0.5 gpm / 2 1pm
• Operating Temperature — — — — — — 41-100 °F / 5-38 °C
• Operating Working Pressure — — — 15-100 psi/ 100-689 kPa

NOTE:

1. Use with cold water only.
2. Do not use water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

The result is from testing data under laboratory conditions.

Parts List

• (A) Activated Carbon Fiber (ACF) Filter
• (B) Ultrafiltration (UFJ Membrane Filter
• (C) Filter Top Cover
• (D) Filter Base
• (E) Mounting Nut
• (F) Silicone Washer
• (G) Steel Mesh
• (H) Mounting Base
• (I) Display Area
• (J) PUSH Button
• (K) Accessories
• (K1) 6x Adapter
  • M 18.S(AS), 13/16″(A4),
  • M21.S(A6), 15/16″(A3),
  • M18.S(B4), 55/64″(B3)
• (K2) 1 x Teflon Tape

Installation Instructions

1. Remove your original aerator and its washer. Use a rubber jar opener if the aerator is difficult to remove. Choose the right adapter to match your faucet threading.
   How to Choose the Right Adapter

2. Unscrew the Mounting Nut (E) from the Mounting Base (H) by turning counter-clockwise. Then put the Mounting Nut (E) on the faucet.

3. Wrap Teflon Tape (K2) around the joint of the mounting base and the faucet. You can hand-tighten the adapter and do not over-tighten it.
   NOTE: The silicone washers have been installed into the adapters, and be careful not to omit the washer during the installation. Otherwise, this may cause water leakage.

4. Screw the Mounting Base (H) onto the Mounting Nut (E) firmly by turning clockwise.

5. Unscrew the Filter Top Cover (C) from the Filter Base (D). Take out the filter from the package and remove the protective film. Insert the filter into Filter Base (D). Twist the Filter Top Cover (C) back to the Filter Base (D) securely.
   NOTE: Please insert the filter firmly until it sits.

6. Align the slot of Filter Base (D) with the slot of Mounting Base (H).

7. Insert Filter Base (D) into Mounting Base (H) and rotate 90° upward.

How to Use

After installation, open the faucet. Press the “PUSH” button to the “pure” position, and the filtered water will run through. Press the “PUSH” button to “tap” position, and unfiltered water will run through.

NOTE:

1. Before first use, run cold water for 1 minute in a “pure” position. Do not run hot water through the filter. During flush, it is normal to see cloudy water and hear the sound of water pushing air out of the filter cartridge.
2. Check for leaks. If there is any leak, please refer to the FAQ.
3. Please gently press the “PUSH” button to avoid damage to the mounting base.

Filter Cartridge Replacement

For optimum performance, it is highly recommended you use a genuine Waterdrop® faucet replacement water filter. And it is also advisable to change your filter every 3 months or 320 gallons to keep water fresh, whichever comes first will vary based on water usage and water quality.

1. Twist the Filter Base (D) from the Mounting Base (H).
2. Twist the Filter Top Cover (C) off and take out the old filter.
3. Insert the new filter into the Filter Base (D).
4. Twist the Filter Top Cover(C) on.
5. Align the slot of Filter Base (D) with the slot of Mounting Base (H).
6. Insert Filter Base (D) into Mounting Base (H) and rotate 90″ upward.

Warnings

1. Do not use water above 38 °c /100 °F.
2. Flush the system for 1 minute before use after a long time of non-use.
3. Before each use, run water through the filter for 5 to 10 seconds to activate the filter.
4. The filter system must be protected against freezing temperatures, frost, snow, sleet, and ice. Exposure to these elements can produce cracks and product failures.
5. Please do not touch the filtered water outlet to prevent bacterial growth.
6. Do not use a steel wire brush or corrosive liquids to clean the product.
7. Change the filter every 3 months or 320 gallons for best filtration performance.

Frequently Asked Questions

1. Q: Why does water leak between the mounting base and the faucet?
   A: Please check if the Teflon Tape is wrapped properly. If not, bind the tape again around the joint of the mounting base and the faucet. If there is still water leakage, check whether the silicone washer is installed. Make sure that the silicone washer is installed in place.

2. Q: Why does the filtered water run quite slowly?
   A: The filter cartridge may be clogged. Replace the filter cartridge.

3. Q: Why does the unfiltered water run quite slowly?
   A: There may be dirt in the filter steel mesh. Clean the filter steel mesh.

4. Q: Why does the water taste funny?
   A: The filter cartridge is not installed appropriately, or it should be replaced.

Please re-install it correctly. If there is still bad taste, please replace it.

Limited Warranty

The Waterdrop WD-FC-02 Ultrafiltration Faucet Filtration System offers a 1-year warranty, which covers defects in materials and workmanship from the original date of purchase. If the product proves to be defective within 1 year from the date of purchase, call our technical support hotline.

During the warranty period, we will replace or repair any part that is deemed to be defective if the product has not been subjected to tampering, alteration, or improper use after delivery, and has not been repaired by the manufacturer. The product is not warranted against misuse, use in abnormal operating temperature conditions, conditions listed outside the operating parameters, or use in commercial operations or any other manner outside the “system specifications” outlined in the owner’s manual. Our obligation does not include the cost of transportation. We are not responsible for damage in transit; claims for such damage should be presented to the carrier by the customer.

NOTE:
It does NOT apply to any filter cartridge, which has a life expectancy that varies based on incoming water quality.

Qingdao Ecopure Filter Co., Ltd.

• Tel: 1-888-352-3558 (U.S.)
• E-mail: service@waterdropfilter.com
• Add.: No.13, Yishengbai Road Jimo, Qingdao, China.

Made in China.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>