Bateria Power 60A MPPT Solar Charge Controller Installation Guide
- June 17, 2024
- Bateria Power
Table of Contents
Bateria Power 60A MPPT Solar Charge Controller
Installation
MPPT Solar Charge Controller SunRock 60
Make sure there is enough space for airflow, reserve at least 30 cm (12 in)
above and below the controller, and 50 mm (2 in) on two sides. Do not install
in a container where accumulator gas may accumulate.
Electrical wire connection and sequence
Start steps
- Step 1: Turn on the circuit breaker connected to the battery first, make sure that the controller is connected to the battery (the controller LCD will display the content), and set the battery type;
- Step 2: If a DC output is required to control the load, Please set the output control mode first, Then open the DC output “breaker”;
- Step 3 : Connect a circuit breaker that turns on the PV input of the solar panel, If the voltage of the PV input is within the charging operating range of the controller, the controller will enter the charging state; shutdown process: Turn off the “circuit breaker” in the turn of 3,2,1,CD
Operation on the screen and setting
- Press the ” OK” and ” S ” keys at the same time for 6 seconds to restore the factory settings. The specific operation and display logic are shown in the following figure.
- BUTTON ” S ” also acted as page up, and the button ” OK” acted as page down.
The information showing when pressing the button S
Short Press “S” button for reviewing
Parameter setting
Short Press “OK” on any page, and you will enter the settings page.
NOTE: Press the OK/5 button to select the parameter, long press “OK” 35
to save the settings, long press “S” 35 to exit editing.
Take the page of PV voltage as an example:
Specification
Installation Instructions
installation Precautions
- Be very careful when using batteries. Wear goggles and use fresh water to wash and clean any contact with battery acid.
- Use insulated tools and avoid placing metal objects near the battery.
Warning: D o not install the MPPT in an enclosure with an open/flooded
battery. Battery fumes are flammable and can corrode and destroy MPPT
circuits.
Reminder: When installing the MPPT in the enclosure, ensure adequate
ventilation. Installation in a sealed enclosure can result in overheating,
reduced power operation, and shortened product life.
Warning: Installation must comply with electrical code requirements.
Select suitable specifications for circuit breakers and fuses based on
application requirements.
- Do not install in a location prone to water ingress and very humid.
- Ensure that the cables are securely connected and secured using cable clips to prevent the cables from shaking during mobile applications.
- This MPPT controller can be connected to a battery or a battery pack.
- This MPPT controller prevents reverse current leakage at night, so diodes in series are not required in the system.
- This MPPT controller is only used for solar power generation. Connection to any other type of power source (such as a wind turbine or generator) may result in an invalid warranty.
support@bateriapower.com
www.bateriapower.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>