LYESS CW310 3 in 1 Fast Charge Instruction Manual
- June 17, 2024
- LYESS
Table of Contents
LYESS CW310 3 in 1 Fast Charge
Product Description
Product usage
- This product is charged by being connected to the type-c port on the QC3.0 adapter. When the bottom power indicator lights up, it indicates that the power supply is normal.
- Mobile phone charging: align the wireless charging position of your mobile phone with the circular region. When the screen of your mobile phone shows a “charging” sign, it indicates the phone is charging normally.
- Bluetooth headset charging: charge the bluetooth headset by plugging it onto its cradle (note: please remove the protective case on the cradle of the bluetooth headset; otherwise, it will cause bad contact and cannot be charged.)
- Watch charging: please stand up the wireless charging module of the watch and then put your watch on it to align with the magnetic. When the watch shows a “charging” sign, it indicates that the watch is charging normally.
- Working indicator: the blue indicator is always on when the mobile phone is charging, is always off when the mobile phone is not charging or fully charged, and flickers when the mobile phone is charging abnormally.
Product specification
FCC STATEMENT
FCC WARNING STATEMENT
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions. may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment must be installed and operated by provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 15 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
End-users and installers must be provided with antenna installation
instructions and transmitter operating conditions for satisfying RF exposure
compliance.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>