velleman WB036 Rotating Plate User Manual

velleman WB036 Rotating Plate

WB036

mm (1x)
M- F| Allen key 4 mm (1x)| inbussleutel 4 mm (1x)| clé à six pans, 4 mm (1x)
W-A| ST5.5 x 50 mm (3x)| ST5.5 x 50 mm (3x)| ST5.5 x 50 mm (3x)
W-B| nylon plugs (3x)| nylon pluggen (3x)| chevilles nylon (3x)
W-C| washer D6 (3x)| ring D6 (3x)| rondelle D6 (3x)
M- A| M4 x 14 mm (4x)| M4 x 14 mm (4x)| M4 x 14 mm (4x)
---|---|---|---
M- B| M5 x 14 mm (4x)| M5 x 14 mm (4x)| M5 x 14 mm (4x)
M- C| arandelas D4 (4x)| Dichtungsringen D4 (4x)| anilhas D4 (4x)
M- D| arandelas D5 (4x)| Dichtungsringen D5 (4x)| anilhas D5 (4x)
M- E| llave Allen 3 mm (1x)| Sechskantschlüssel 3 mm (1x)| chave Allen 3 mm (1x)
M- F| llave Allen 4 mm (1x)| Sechskantschlüssel 4 mm (1x)| chave Allen 4 mm (1x)
W-A| ST5.5 x 50 mm (3x)| ST5.5 x 50 mm (3x)| ST5.5 x 50 mm (3x)
W-B| taco de nylon (3x)| Nylondübel (3x)| bucha de nylon (3x)
W-C| arandelas D6 (3x)| Dichtungsringen D6 (3x)| anilhas D6 (3x)

INSTALLATION INSSTRUCTION

Introduction

Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If the device was damaged in transit, don’t install or use it and contact your dealer.

Safety Instructions

• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will not accept responsibility for any ensuing defects or problems.
• Damage caused by user modifications to the device is not covered by the warranty.
• Only use the device for its intended purpose. Using the device in an unauthorized way will void the warranty.
• Check the contents before assembly. Use proper tools and never use defective or deformed parts as an improper installation may cause serious injury.
• Any included hardware is for mounting on solid brick, concrete, or hardwood battens. When mounting on wood, do not use any concrete anchors. Do not use any included hardware for mounting on steel. If uncertain about the nature of the wall or mounting techniques, please consult an expert. Respect the product’s max. load specifications. Protect this device from shocks and abuse and avoid brute force when operating. Check the installation on a bimonthly basis.
• An adequate mounting is essential and falls outside the responsibility of Velleman NV. Respect all installation and operating directions of the device to be mounted/installed (LCD/plasma display). Only use the device at an indoor location, protected from rain, moisture, splashing, and dripping liquids. Make sure the chosen location spot is able to support the weight of the bracket and screen. Keep fingers away from articulations to avoid injury. Keep the device out of reach of children and unauthorized users at all times.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

Features

• full motion wall brackets for 13-23″ / 33-58 cm LED, LCD TVs and screens
• according to VESA standard 75×75, 100×100
• comes with all necessary plugs and screws for assembly and mounting.

Installation

Refer to the illustrations on pages 2, 3, 4, 5, and 6 of this manual.

Preparation
Lift the TV bracket from the wall bracket. To do this, release the screws (2) at the back.

Wooden Support

1. Choose an installation spot able to support the weight of the bracket and the screen.
2. The bracket must be mounted on beams and not simply on a panel.
3. Use the bracket as a template to mark the hole locations (see diagram 2a).
4. Check for electric lines or pipes, or metal studs in wood battens.
5. Make sure the holes are level.
6. Pre-drill the holes (± 30 mm deep) using a power drill and a 3 mm wood bit.
7. Fix the bracket to the wall using 3 lag bolts [W-A] and washers [W-C].

Concrete or Brick Support

1. Choose an installation spot able to support the weight of the bracket and the screen.
2. Use the bracket as a template to mark the hole locations (see diagram 2b).
3. Check for electric lines or pipes.
4. Make sure the holes are level.
5. Drill the holes (± 50 mm deep) using a power drill and an 8 mm masonry bit.
6. Insert a nylon plug [W-B] in each hole.
7. Fix the bracket to the wall using 3 lag bolts [W-A] and washers [W-C].

Covers

1. Place the plastic finishing covers on the wall plate.
2. Install the cable guide on the bottom or top of the bracket.

TV Bracket
Mount the TV bracket on the back of the TV. Depending on the TV screen, use the appropriate M4 or M5 screws and the appropriate washers (see diagram 4).

Installing the Display
Hook the TV mounting bracket over the wall mounting bracket and secure it with the mounting screws.
Note: This operation should be done by 2 adult persons.

Screen Position

1. Slightly release the 3 hex screws with the hex wrench [M-F] and adjust the angle of the screen (see diagram 6).
2. Tighten the hex screws to secure the screen in the desired position.

Note: Check all screws and brackets regularly to ensure safe use.

Technical Specifications

Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage or injury resulting from (incorrect) use of this device. For more info concerning this product and the latest version of this manual, please visit our website www.velleman.eu. The information in this manual is subject to change without prior notice.

COPYRIGHT NOTICE – The copyright to this manual is owned by Velleman NV. All worldwide rights reserved. No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the prior written consent of the copyright holder.

Velleman® Service and Quality Warranty
Since its foundation in 1972, Velleman® acquired extensive experience in the electronics world and currently distributes its products in over 85 countries. All our products fulfill strict quality requirements and legal stipulations in the EU. To ensure the quality, our products regularly go through an extra quality check, both by an internal quality department and by specialized external organizations. If, all precautionary measures notwithstanding, problems should occur, please appeal to our warranty (see guarantee conditions).

General Warranty Conditions Concerning Consumer Products (for EU):

• All consumer products are subject to a 24-month warranty on production flaws and defective material as from the original date of purchase.

• Velleman® can decide to replace an article with an equivalent article or to refund the retail value totally or partially when the complaint is valid and a free repair or replacement of the article is impossible, or if the expenses
  are out of proportion. You will be delivered a replacement article or a refund at the value of 100% of the purchase price in case a flaw occurs in the first year after the date of purchase and delivery, or a replacement article at 50% of the purchase price or a refund at the value of 50% of the retail value in case of a flaw occurred in the second year after the date of purchase and delivery.

• Not covered by warranty:

  • all direct or indirect damage caused after delivery to the article (e.g. by oxidation, shocks, falls, dust, dirt, humidity…), and by the article, as well as its contents (e.g. data loss), compensation for loss of profits;
  • consumable goods, parts or accessories that are subject to an aging process during normal use, such as batteries (rechargeable, non-rechargeable, built-in or replaceable), lamps, rubber parts, drive belts… (unlimited list);
  • flaws resulting from fire, water damage, lightning, accident, natural disaster, etc.…;
  • flaws caused deliberately, negligently, or resulting from improper handling, negligent maintenance, abusive use or use contrary to the manufacturer’s instructions;
  • damage caused by commercial, professional, or collective use of the article (the warranty validity will be reduced to six (6) months when the article is used professionally);
  • damage resulting from inappropriate packing and shipping of the article;
  • all damage caused by modification, repair, or alteration performed by a third party without written permission by Velleman®.

• Articles to be repaired must be delivered to your Velleman® dealer, solidly packed (preferably in the original packaging), and be completed with the original receipt of purchase and a clear flaw description.

• Hint: To save on cost and time, please reread the manual and check if the flaw is caused by obvious causes before presenting the article for repair. Note that returning a non-defective article can also involve handling costs.

• Repairs occurring after warranty expiration are subject to shipping costs.

• The above conditions are without prejudice to all commercial warranties.

The above enumeration is subject to modification according to the article (see article’s manual).

Made in PRC Imported by Velleman nv Legen Heirweg 33, 9890 Gavere, Belgium www.velleman.eu

References

• Velleman – Wholesaler and developer of electronics
• Manual-Hub.com – Free PDF manuals!

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>