RIGEL R1002TOF BLE Sensor and Gateway User Manual
- June 17, 2024
- RIGEL
Table of Contents
R1002TOF BLE Sensor and Gateway
Product Information
Specifications
-
Compliance: Part 15 of FCC rules
-
Radiation Exposure Limits: FCC approved for uncontrolled
environment -
Minimum Distance: 20cm between the radiator and the body
Product Usage Instructions
Installation
-
Select a suitable location for the equipment.
-
Ensure there is a minimum distance of 20cm between the radiator
and your body. -
Place the equipment in the desired location and secure it
properly.
Operation
- Make sure the equipment is connected to a power source.
- Turn on the equipment using the designated power button.
- Follow the instructions provided in the user manual for
specific operations or functionalities.
Maintenance
-
Regularly clean the equipment using a soft, dry cloth to remove
dust and debris. -
Avoid using any liquid or abrasive cleaners that may damage the
equipment. -
Keep the equipment away from extreme temperatures, humidity,
and direct sunlight. -
If you encounter any technical issues, refer to the
troubleshooting section in the user manual or contact our customer
support.
FAQ
Q: What should I do if I experience interference with the
equipment?
A: If you experience interference, try relocating the equipment
to a different position. Ensure there are no other electronic
devices or sources of interference nearby. If the problem persists,
contact our customer support for further assistance.
Q: Can I use the equipment in a controlled environment?
A: Yes, the equipment can be used in both controlled and
uncontrolled environments. However, it is recommended to follow the
minimum distance requirement of 20cm between the radiator and your
body for your safety.
Q: How often should I clean the equipment?
A: It is recommended to clean the equipment regularly or
whenever you notice dust accumulation. This helps maintain optimal
performance and prolongs the lifespan of the product.
FCC warning:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: -Reorient or relocate
the receiving antenna. -Increase the separation between the equipment and
receiver. -Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. -Consult the dealer or an experienced
radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.