FENIX E09R Rechargeable Mini High Output Flashlight User Guide
- June 4, 2024
- FENIX
Table of Contents
LIGHTING FOR EXTREMES
E09R
RECHARGEABLE MINI HIGH-OUTPUT
FLASHLIGHT
E09R Rechargeable Mini High Output Flashlight
| 600 LUMENS MAXIMUM OUTPUT
---|---
| 124 METERS MAXIMUM BEAM DISTANCE
FENIX E09R FLASHLIGHT
- 600 lumens maximum output, 124 meters maximum beam distance.
- Luminus SST20 LED with a lifespan of 50,000 hours.
- Built-in 800mAh Li-polymer battery.
- Hidden USB Type-C charging port.
- Metal switch for on/off and output selection. Instant Burst.
- High-efficiency lens with a total reflective coating.
- Made of durable A6061-T6 aluminum.
- Premium type HAIII hard-anodized anti-abrasive finish.
- Size: 3.11″ x 0.76″ x 0.72″ / 79 x 19.3 x 18.4 mm.
- Weight: 1.59 oz / 45 g.
OPERATING INSTRUCTION
On/off
Press and hold the side switch for 0.5 seconds to turn on/off the light.
Output Selection
With the light switched on, single-click the side switch to cycle through
Moonlight—.Low—.Med—.High.
Instant Burst
Press and hold the side switch for 1.2 seconds to enter instant Burst, release
it the light will turn back to Moonlight mode.
Lock/Unlock
Lock: with the light switched off, double click the switch within 0.5 seconds
to lock the light, the light will blink twice on Moonlight to indicate locked
status.
TECHNICAL PARAMETERS
| ANSI/PLATO FL1 | BURST | HIGH | MED | LOW | MOONLIGHT |
|---|---|---|---|---|---|
| OUTPUT | 600 lumens | 300 lumens | 100 lumens | 25 lumens | |
| RUNTIME | I | 1.5 hours * | 4 hours | 16 hours | |
| DISTANCE | 124 meters | 91 meters | 56 meters | 28 meters | |
| INTENSITY I | 3970 candela | 2084 candela | 777 candela | 192 candela |
candela
IMPACT RESISTANCE| | 1 meter
SUBMERSIBLE| | IP68
Note: According to the ANSI/PLATO FL1 standard, the above specifications
are fromldlo results produced by Fenix through its laboratory testing using
the built-in 800 mAh Li-polymer battery under the temperature of 21±3°C and
humidity of 50% 80%. The true performance of this product may yaw according to
different working environments. *The High output is measured in a total
runtime including output at reduced levels up to temperature or protection
mechanism in the design.
Unlock: with the light locked, double-click the switch within 0.5
seconds, and the light will be unlocked and activated on Moonlight. in locked
status, clicking or pressing tho switch will activate 2 one second blinks on
Moonlight to indicate locked status.
Intelligent Memory Circuit
The light memorizes the last selected output excluding burst. When turned on
again the previously used output will be recalled.
CHARGING
- First loosen the light body to reveal the USB Type-C charging port and plug the USB A socket of the charging cable into an electrical outlet, then connect the USB Type-C socket of the charging cable to the light.
- The indicator will display red while charging and will turn green when fully charged.
- Once charging is completed, be sure to tighten the light head to maintain the dustproof and waterproof ability.
Note:
- Charge the light timely when the battery power gets too low to ensure the normal life of the battery.
- The normal charging time is approximately 1 hour from depletion to full charging.
- Recharge a stored light every four months to maintain the optimum performance of the battery.
INTELLIGENT OVERHEAT PROTECTION
The light will accumulate a lot of heat when used at High mode for extended periods. When the light reaches a temperature of 60°C or above, the light will automatically step down a few lumens to reduce the temperature. When the temperature drops below 60°C, it will then allow the user to reselection of the mode.
USAGE AND MAINTENANCE
- Disassembling the sealed head can cause damage to the light and will void the warranty.
- Lock the light to prevent accidental activation during storage or transportation.
- Long-term use can result in 0-ring wear. To maintain a proper water seal, replace the ring with an approved spare
INCLUDED
Fenix E09R flashlight, USB Type-C charging cable, Key chain, Spare 0-ring,
User manual, Warranty card
WARNING
- The flashlight is a high-intensity lighting device capable of causing eye damage to the user or others. Avoid shining the light directly into anyone’s eyes.
- This flashlight will accumulate a lot of heat when used for extended periods, resulting in a high temperature of the flashlight shell. Pay attention to safe use to avoid scalding.
- Do not shine an object at close range, to avoid burning the object or causing danger due to high temperature.
- The LED of this flashlight is not replaceable; so the entire light should be replaced when the LED reaches the end of its life.
- If any of the information provided in this manual is changed, the new version of the manual shall prevail; if your included user manual is an old one, it acquiesces that we won’t send a new manual.
LIGHTING FOR EXTREMES
|
---|---
https://www.facebook.com/fenixproducts/|
http://weixin.qq.com/r/83U_JiHEP3xArWVF9yDh
“Follow” us for more information about Fenix.
FENIXLIGHT LIMITED
Tel: +86-755-29631163/83/93 Fax: +86-755-29631181 E-mail:
info@fenixlight.com Web:
www.fenixlight.com Address: 2F/3F, West of
Building A, Xinghong Technology Park. 111 Shuiku Road. Fenghuanggang
Community, Xixiang Street, Bao’an District, Shenzhen City, Guangdong Province,
China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>