HAIRMAX Professional 12 LaserComb Instruction Manual

: May 15, 2024
: hairmax

Table of Contents

HAIRMAX Professional 12 LaserComb
Product Information
Usage Instructions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

HAIRMAX Professional 12 LaserComb

Product Information

Specifications:

Product Name: Lux 9, Professional 12 LaserComb
Model Options: Lux 9, Professional 12
Treatment Duration: Lux 9 – 11 minutes, Professional 12 – 8 minutes
Treatment Frequency: 3 times per week

Usage Instructions

Step 1: Charging
A. Charge your LaserComb using either the charging cradle (Figure A) or by placing the power cord directly into the handle end of the LaserComb (Figure B). For initial charging, allow 2-3 hours to fully charge your LaserComb. A green light will illuminate on the side of the charging stand indicating that your power cord is operating properly. During charging, the display on the LaserComb will illuminate for 20 seconds and the battery indicator bars will light up indicating the battery level and confirm the charging process. After 20 seconds, the display will turn off but the battery will continue to charge.

Step 2: Turning on the LaserComb
C. To turn on the LaserComb, press the power button and hold until the power button light turns green. Next, press the laser button which will light up red. This indicates that the LaserComb is ready for use (Figure C).

Step 3: Sensitivity Test
D. Before beginning treatment, be sure to test the LaserComb for sensitivity (see page 5 of your User Manual). To start your treatment, place the LaserComb flat on your scalp so that both rows of teeth are touching the scalp (Figure D). Start at your hairline.

Step 4: Treatment Process
E. Move the LaserComb from the front to the back of the scalp. Lift the LaserComb off your scalp (Figure F) and start at a new position at the hairline. Continue in this manner from front to back and then side to side (Figure F) until you cover your entire scalp with multiple passes. When the LaserComb is on, it will beep and vibrate every four (4) seconds. This means that it is time to move the LaserComb to the next area of the scalp. Repeat these passes for a total treatment duration of 8 minutes for Professional 12 and 11 minutes for Lux 9 models.

Step 5: Hair Placement
G. If you have long hair, use your fingers to lift your hair out of the way while using the LaserComb to ensure that the laser energy reaches your scalp (Figure G).

Step 6: Turning off and Storage
H. After treatment, turn off the LaserComb by pressing and holding the power button (lower button) until the green indicator light turns off (Figure H). Store the device in the charging cradle for future use. You may leave the power cord plugged into the charging cradle at all times.

Frequently Asked Questions (FAQ)

Q1: What is the purpose of the Lux 9 and Professional 12 LaserComb models?
A1: The Lux 9 and Professional 12 LaserComb models are indicated to treat Androgenetic Alopecia and promote hair growth in males who have Norwood Hamilton Classifications of IIa to V and in females who have Ludwig (Savin) I-4, II-1, II-2, or frontal patterns of hair loss and who both have Fitzpatrick Skin Types I to IV.
Q2: How often should I use the LaserComb?
A2: The LaserComb should be used 3 times a week. Use the Lux 9 for 11 minutes and the Professional 12 for 8 minutes. The treatments should be spaced every other day, for example, Monday, Wednesday, Friday.
Q3: Can I use the LaserComb on wet or dry hair?
A3: Yes, you can use the LaserComb on wet, towel-dried, or dry hair. It is recommended, but not essential, that the LaserComb be used on a clean scalp after washing. The LaserComb should be used prior to applying any topical treatments, gels, sprays, or concealing products.
Q4: How should I position the LaserComb during treatment?
A4: Place the LaserComb flat on your scalp so that both rows of teeth are touching the scalp. Start at your hairline and move the LaserComb from the front to the back of the scalp. Lift the LaserComb off your scalp and start at a new position at the hairline. Continue in this manner from front to back and then side to side until you cover your entire scalp with multiple passes.
Q5: What should I do if I have long hair?
A5: If you have long hair, use your fingers to lift your hair out of the way while using the LaserComb to ensure that the laser energy reaches your scalp.

Please Note:

The total time required for treatment with the HairMax LaserComb is 8 minutes for Professional 12 and 11 minutes for Lux 9 models.
It is important to move the LaserComb very slowly. Remember you are bathing the scalp with laser light. If you move it too fast, the treatment will not achieve the optimal results to promote hair growth.
While there are no negative effects from overuse, it is recommended that you use the LaserComb according to directions.
The LaserComb has advanced electronics to make sure that the device is working properly. If for some reason you are experiencing difficulties with your device, before sending it back to us for repair, please refer to the Trouble Shooting section of your User Manual.
For further assistance please call +1-561-417-0200.

REGISTER
To validate your warranty please register online at www.hairmax.com/warranty or call Customer Service toll-free at 1-866-527-3726

CONTACT
Lexington International, LLC 777 Yamato Road, Suite 105 Boca Raton, FL 33431 +1-561-417-0200 HAIRMAX.com

The HairMax LaserComb® is a very effective device when used correctly. It is manufactured using precision components and should last 10-15 years under normal usage. Please take time to read the entire User Manual before operating the LaserComb

Lux 9, Professional 12 LaserComb Models

Use the LaserComb Lux 9 for 11 minutes, and the LaserComb Professional 12 for 8 minutes, 3 times a week. The treatments should be spaced every other day, for example Monday, Wednesday, Friday. Move the LaserComb slowly 1/2 inch every 4 seconds.
It is recommended, but not essential, that the LaserComb be used on a clean scalp after washing. Your hair can be wet, towel dried or dry. The LaserComb should be used prior to applying any topical treatments, gels, sprays or concealing products

Charge your LaserComb using either the charging cradle (Figure A) or by placing the power cord directly into the handle end of the LaserComb (Figure B). For initial charging, allow 2-3 hours to fully charge your LaserComb. A green light will illuminate on the side of the charging stand indicating that your power cord is operating properly. During charging, the display on the LaserComb will illuminate for 20 seconds and the battery indicator bars will light up indicating the battery level and confirm the charging process. After 20 seconds the display will turn off but the battery will continue to charge.
To turn on the LaserComb press the power button and hold until power button light turns green.
Next, press the laser button which will light up red. That means the LaserComb is ready for use (Figure C).
Before beginning treatment, be sure to test the LaserComb for sensitivity (see page 5 of your User Manual). To start your treatment place the LaserComb flat on your scalp so that both rows of teeth are touching the scalp (Figure D).
Start at your hairline. Move the LaserComb from front to back of scalp in a slow combing motion, stopping every ½ inch (1cm) and pausing for 4 seconds (Figure E). Do not lift the LaserComb off your scalp while combing from front to back.
Next, lift the LaserComb off your scalp and start at a new position at the hair line. Continue in this manner from front to back and then side to side (Figure F) until you cover your entire scalp with multiple passes. When the LaserComb is on it will beep and vibrate every four (4) seconds.
This means that it is time to move the LaserComb to the next area of the scalp. Repeat these passes for the total treatment of 8 min. for Professional 12 and 11 min. for Lux 9 models.
If you have long hair, use your fingers to lift your hair out of the way while using the LaserComb to be sure that the laser energy reaches your scalp (Figure G).
After treatment, turn off the LaserComb by pressing and holding the power button (lower button) until green indicator light turns off (Figure H). Store the device in the charging cradle for future use. You may leave the power cord plugged into the charging cradle at all times.

The HairMax Lux 9 and Professional 12 are indicated to treat Androgenetic Alopecia, and promote hair growth in males who have Norwood Hamilton Classifications of IIa to V and in females who have Ludwig (Savin) I-4, II-1, II-2, or frontal patterns of hair loss and who both have Fitzpatrick Skin Types I to IV.