Shikeshu JZ-21v Intelligent Under Cabinet Light User Manual
- June 17, 2024
- Shikeshu
Table of Contents
Shikeshu JZ-21v Intelligent Under Cabinet Light User Manual
Product Description:
Intelligent under cabinet light bar, made of 34 bright led beads ultra-thin aluminum shell material, with strong adhesive tape, can easily be stocked on the place you want. It can be applied on kitchen, closets, stairs, under cabinets, garages, shelf .corridors, etc
Function Introduction:
- The under cabinet light bar have 3 control methods, which is convenient and accurate.
- 2.4G remote control;
- 3-key controller;
- smart Bluetooth APP control;
- This intelligent cabinet lamp has 34 high-brightness LED beads and you can adjust color mode from cold white to warm white. Whether used for creating a cozy atmosphere or providing sufficient illumination, the intelligent cabinet lamp can offer you a perfect experience. When all 34 lamp beads are fully illuminated they will light up every dark corner, allowing you to enjoy warmth and comfort while also providing ample lighting. Additionally, the cabinet lamp features a high-quality lampshade design that avoids glaring issues.
- The brightness can be adjusted and the lights can be turned off in three ways.
Tips:
- This product is for indoor use only and is not waterproof
- We provide double-sided adhesive tape for installation, please install the light bar on a flat and clean surface.
- This light bar is powered by USB and comes with a 5V2A power supply, which is convenient and safe.
Installation Step
- Power supply location
- 3-key controller location
- Light bar installation location
- extention cord
4G Remote( Advancad Version)
Before using the remote control, pull out the bottom plastic piece
Key Controller
ON/ OFF: Turn the light on/off
Brightness Adjust: 10-level brightness adjustment
Light mode switching : Switching between warm white cold white and
neutral modes
Bluetooth APP
**Three ways to download the app
**
Bluetooth connection steps
-
Turn on Bluetooth, and make sure that your phone’s Bluetooth allows this app to be used.
-
Open the APP” Lotus CCT”, wait for a few seconds, the light strip will automatically connect to the app.
Timing mode
Before using the timing function, please make sure that the light is always
powered on.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency installed and used in accordance with energy and,
if not the instructions, may cause harmful interference to radio.
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>