ILIVE ICP601B Clock Radio with Dock for iPod and iPhone User Guide

: June 16, 2024
: iLive

Table of Contents

Warnings and Precautions
Important Safety Instructions
Clock Radio With Dock For iPod And iPhone
Introduction
Setup
Clock And Alarm
iPod and iPhone
Radio and 3.5mm Audio Input
Company Information
Contact Information
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ILIVE ICP601B Clock Radio with Dock for iPod and iPhone

Warnings and Precautions

CAUTION : TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
WARNING : To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
CAUTION : Use of any controls or adjustments or performance of procedures other than those herein specified may result in hazardous radiation exposure.
WARNING : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
WARNING : Do not place the unit on top of any soft, porous, or sensitive surfaces to avoid damaging the surface. Use a protective barrier between the unit and surface to protect the surface.
WARNING : Use of this unit near fluorescent lighting may cause interference regarding use of the remote. If the unit is displaying erratic behavior move away from any fluorescent lighting, as it may be the cause.
CAUTION : Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
WARNING : There is a danger of explosion if you attempt to charge standard Alkaline batteries in the unit. Only use rechargeable NiMH batteries.
WARNING : The remote control’s button cell battery contains mercury. Do not put in the trash, instead recycle or dispose of as hazardous waste.
WARNING : Lithium batteries, like all rechargeable batteries are recyclable and should be recycled or disposed of in normal household waste. Contact your local government for disposal or recycling practices in your area. They should never be incinerated since they might explode.
WARNING : Shock hazard – Do Not Open.

Mains plug is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected from the mains socket outlet completely.

WARNING : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

Important Safety Instructions

Read these Instructions.
Keep these Instructions.
Heed all Warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with a dry cloth.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Do not defeat the safety purpose of the polarized or grounding – type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
Only use attachments/accessories specified by the manufacturer.
Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
Unplug this apparatus during lightning storms or when unused for long periods of time.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

FCC Warnings

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Additional Warnings

The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on apparatus.
Main plug is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected form the mains socket outlet completely.
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Caution marking is located at the rear or back of the apparatus.
The marking information is located at the rear or back of apparatus.

This symbol indicates that this product incorporates double insulation between hazardous mains voltage and user accessible parts.

Clock Radio With Dock For iPod And iPhone

Features

Made for iPod and iPhone
Plays and charges docked iPhone and iPod
Digital tune FM radio
Station memory presets (20)
Digital clock
Dimmer control
Dual alarm
Gradual wake
Wake to iPhone/iPod, radio, or buzzer
Sleep timer
Snooze
3.5mm audio input
Preset EQ
Last channel memory
Digital volume control
Built-in speakers
Wire FM antenna
AC power: built-in AC power cable

Included

Docking brackets for iPhone/iPod (5)
Warranty card
User’s guide

Introduction

Setup

Power

Plug the attached AC cord into a standard AC power outlet to power the unit.

Clock And Alarm

Setting the Alarms

Press the PoWeR button to turn the clock radio off.
Press and hold the Al1 or Al2 button.
While holding the Al1 or Al2 button, press the HR/MIn buttons to adjust the hour and the minute.
While continuing to hold the Al1 or Al2 button, press the soURCe button to adjust the alarm source. Buzz – Wake to Buzzer
Tune FM – Wake to the FM radio
iPod – Wake to a docked iPod
Release the Al1 or Al2 button to finish setting the alarm.

Cancelling the Alarm

Press the Al1 or Al2 buttons to turn alarm 1 and alarm 2 off or on.
The AL1 or AL2 indicators on the LCD display will appear when alarm 1 or 2 is active.

After the Alarm sounds

After the alarm sounds:
Press the Al oFF button to turn the alarm off until the set alarm time is reached again.
or
Press the snooZe button to delay the alarm for an additional 9 minutes.

setting the Clock

Follow the instructions for Docking an iPod or iPhone.
Press and hold the ClK ADJ button for 3 seconds then release.
The time will automatically sync with the set time on the docked iPod or iPhone.

Manually setting the Clock

Press the PoWeR button to turn the clock radio off.
Press and hold the ClK ADJ button.
The time will begin to blink.
While holding the ClK ADJ button, press the HR/MIn buttons to adjust the hour and minute.
Release the ClK ADJ button to finish setting the time.

setting the sleep Timer

Press the PoWeR button to turn the clock radio on.
Press the snooZe button repeatedly to set the sleep timer.
The sleep timer will appear on the display.
When the set sleep time expires, the clock radio will automatically power off.

iPod and iPhone

Docking an iPod or iPhone

Locate the numbered bracket that fits the iPhone/iPod model that will be docked.
Each included bracket has a number on it, indicating which iPhone/iPod model that bracket is compatible with. See the separate bracket chart page to identify which bracket is needed.
Snap the bracket into place over the iPhone/iPod connector in the dock.
Connect the iPhone or iPod to the connector inside the Dock for iPhone/iPod.
When the dock is plugged in, using AC power, the docked iPhone or iPod will charge.

Playing a Docked iPod or iPhone

Follow the instructions for Docking an iPod or iPhone.
Press the soURCe button to switch to iPod mode.
Press the PlAY/PAUse button to begin playing the docked iPod or iPhone.

Radio and 3.5mm Audio Input

Tuning the FM Radio

Press the PoWeR button to turn the clock radio on.
Press the soURCe button to switch to FM radio mode.
Press the TUne ± buttons to tune the FM radio.

saving a Radio station as a Preset

Follow the instructions for Tuning the FM Radio.
Press the PlAY/PAUse/MeM button.
The preset number will begin to blink on the LCD display.
Press the PReseT ± buttons to adjust the preset number.
Press the PlAY/PAUse/MeM button to save the current FM radio station to the selected preset number.

Tuning to Preset Radio stations

Follow the instructions for Tuning the FM Radio and Saving a Radio Station as a Preset.
Press the PReseT ± buttons to cycle through saved radio stations.

Using the 3.5mm Audio Input

Requires a 3.5mm audio cable (not included)

Press the PoWeR button to turn the clock radio on.
Press the soURCe button to switch to AUX mode.
Connect an MP3 player or other audio source to the 3.5MM AUDIo InPUT using a 3.5mm audio cable.
Use the connected device’s native controls to play, pause, and control your music.

Contact Information

Phone : 1-888-999-4215
email : prodinfo@gpx.com
Parts email : partsinfo@dpi-global.com
Website : www.gpx.com
Copyright © 2010 Digital Products International (DPI, Inc.) | All other trademarks appearing herein are the property of their respective owners. Specifications are subject to change without notice
For the most up-to-date version of this User’s Guide, go to www.ilive.net