UGO UDR-1358 Zephir 2.0 Black and Green User Manual

: June 16, 2024
: UGO

UGO UDR-1358 Zephir 2.0 Black and Green User Manual

BEFORE USING THE DEVIECE, READ ALL INSTRUCTIONS FOR DEVICE, BATTERY OR

OTHER CONNECTED DEVICES.

Do not expose the charger or cables to rain, water spray, solvents, liquids, or any direct flow of water. Always keep clean and dry.

Important Safety Instructions

DANGER –RISK OF ELECTRIC SHOCK, BURNS, OR FIRE.
Never replace, splice, or repair cables or connectors supplied with the device.

DANGER

Only charge devices in well-ventilated areas. If charging inside the car, make sure sufficient ventilation is provided.

RISK OF ELECTRIC SHOCK – Do not open. No user-serviceable parts inside.

RISK OF BURNS..

Operating Instructions:

Charge only properly maintained and rechargeable devices of the same voltage that is printed on the device label. Charge only compatible with this device specyfication. Attempting to charge other battery types or voltages, damaged batteries, or improperly maintained batteries may cause them to burst, emit dangerous chemicals, or cause personal injury or damage.

WARNING

The device does not protect against faults, shorting, or overload of external wiring, vehicle wiring, or wiring to the battery being charged. All wiring to the battery must be properly protected against overloads, physical damage, and other failures. The user must ensure that wiring to the device adheres to the same vehicle wiring standards and safety precautions required for all other vehicle wiring.

Auto take off/ Land Quadcopter Dimension Blade Protection
Auto hover First Person View Auto Hover/Auto Trim
Max Flight Speed 5 m/s
One Key Return/Headless Mode Removable Battery Pack Dimension: 75 x 70 x 26 mm
Charging time: 60 min Flight time up to 8 min
Battery – 3.7V / 240mAh Li-Po Weight: 23g

PILOT:

Frequency 2.4GHz DSSS
Max. Communication Range 80 meters Power by 3 x AAA dry battery (not incl.) Dimension 11.2 x 7.7 x 5 cm

No.	Functions	Effect
1.	Speed	Adjust the aircraft left / right / forward / backward / left /

right side fly speed.
2.| Flips| This button is for 360 degree flip function , control the aircraft achieve the 3D flip function.
3.| Photo/Video (optional)| Touch to enter the camera function, and then tap to cancel the function. (optional)
4/8.| Forward/Backward trim| In the vehicle to the forward (backward) movers to the backward (forward) light, press this key can make

the vehicle stable.

the cancel function. no return

9.| Unlock/one key/take off/ land| Push up and down the remote control throttle lever to perform up and down operations.
10/12.| Rightward/Lefrward trim| In the vehicle to the left (right) movers to the right (left) light, press this key can make the vehicle stable.
11.| Emrgency stop| Touch this key to quickly drop the aircraft.
13.| Power on/off| Remote controls power, press the remote control power supply is turned on, press off the power.
14.| Indicator| The lamp flashes – during pairing. The lamp is constantly on – successful pairing.

Charging:

Connect one side of the USB cable with the charging port of drone, and the other side into any a USB port of computer or a smartphone charger (not included).
After fully charge, the charging indicator light (Red) on the USB cable will be

WARNING

To charge the battery, use only the supplied USB cable.

Battery Installation & Charging

To install batteries: Open the cover of battery case, then insert 3 x 1.5V AAA batteries according to indicated polarity (batteries not included).
Battery installation should be done under adult supervision only! Do not mix old and new batteries
Do not mix different types of batteries.

Standard operation steps:

Place the drone on te flat surface

For raising and falling the please use the left stick of the remote control. After moving it up to the drone it will start to rise, aftermoving down, the drone will start to fall.

Moving the left control stick to the left, the drone will rotate around its axis to the left, move the left control stick to the right, the drone will rotate around its own axis to the right.

For the forward and reverse flights the right control stick is responsible. When you move the lever forward, the drone will start to move forward, after moving the lever down, the drone will move backwards.

Moving the right control stick to the left, the drone will move to the left, move the left joystick to the right, the drone will move to the right.

Flips and rolls:

After you have the basics of flying, you’re ready to learn flip and roll your drone. To perform a flip or roll, make sure the drone is at least 3 meters off the ground. Press the button Flip, then quickly push the rudder in either direction to make the drone flip or roll. Once the manoeuvre is completed, steady the drone.

Gyroscope Reset:

Before first flying, pull the Throttle and Rudder down to 45 degree (Bottom Right corner as picture) for 2-3 seconds, you will hear beep ‘Di-Di’, then let go of the Throttle and Rudder. And gyroscope reset complete.

SAFETY INFORMATION

Use as
Non-authorized repairs or taking the device to pieces make the warranty void and may cause the product
Avoid to hit or friction with a hard object, otherwise it will lead to grind surface or other hardware
Do not use the product in low and high temperatures, in strong magnetic fields and in the damp or dusty
Do not drop, knock, or shake the Rough handling can break it.
Slots and openings in the case are provided for ventilation and should not be Blocking the vents can cause overheating of the device.

WARRANTY

2 years limited manufacturer warranty

GENERAL INFORMATION

The safe product, conforming to the EU
The product is made in accordance with RoHS European
The WEEE symbol (the crossed-out wheeled bin) using indicates that this product in not home Appropriate waste management aids in avoiding consequences which are harmful for people and environment and result from dangerous materials used in the device, as well as improper storage and processing. Segregated household waste collection aids recycle materials and components of which the device was made. In order to get detailed information about recycling this product please contact your retailer or a local authority.

This Impakt S.A. declares that the device complies with the essential requirements and other applicable provisions of the applicable EC directives. Full text of the CE declaration can be downloaded from the website of the distributor www.ugo-europe.com
Producer: Impakt S.A. ul. Stanisława Lema 16, 62-050 Mosina, Poland