VOVO TCB-9100GA Integrated Smart Bidet Toilet Installation Guide
- June 16, 2024
- VOVO
Table of Contents
VOVO TCB-9100GA Integrated Smart Bidet Toilet
Cautions before Installation
- (This may differ from the product specification)
Water Pressure
- A minimum of 1.5 kg/cm2 (STATIC 40PSI) water pressure is required. If the pressure is not secured, please be aware that the flushing may not work properly to discharge the dirt.
- Even if other modifiers are used at the same time, it still requires more than the minimum required water pressure. The maximum water pressure is 7.5 kgf/cm2 (STATIC 75PS).
Extract bad water before installing
- Direct the supply hose end into a 3 gal (11.4L)or larger bucket.
- Make sure that the supply stop can provide a minimum of 1.5 gal (5.7L)or more in 10 seconds.
- Shut off the water supply. Proceed to the next step
Drawing for Installation
FAQ
Q: What is electrical requirements? Is it energy efficient?
- A: 6~10 Amps at 120V, 60 Hz is necessary for this item.
- A separate circuit breaker is recommended. It has a power save mode which uses least amount of energy.
Q: The power-saving LED light keeps flashing. (Turned off and on)
A : Please open the valve, please check the water has entered to the bidet. If
it still flashes, please try reset. (Unplug the cord and plug it back after 30
seconds)
Q: How long is the cord?
A : 4ft (1.2m).
- Please open the seat and the lid when you reset the bidet toilet
Installation Accessories
Installation
How to install the Ceramic
- The water may overflow out of the rim when cleaning the bowl in the region with high water pressure. Using a screwdriver, turn the shutoff valve clockwise to reduce the water pressure.
Read User Manual Online (PDF format)
Loading......