AirPro LIM-AP4-XXX Portable Air Compressor User Guide

AirPro LIM-AP4-XXX Portable Air Compressor

TECH SPECS

• Model: LIM-AP4-XXX
• Battery Capacity: 4,000mAh | 3.7V Recharging Time (From 0%): 2-3 Hours Battery Level Display: 5% – 100%
• Type-C: 5V/2A (Max)
• USB Output: 5V/2.4A (Max)
• Max Operating Pressure: 120 PSI / 8.3 bar Max Instant Pressure: 150 PSI / 10.3 bar Air Pressure Range: 3-150 PSI / .2-10.3 bar Range Resolution: 0.5 PSI /  0.05 bar
• Air Pressure Tolerance: ±1.5%
• Product Working Temperature:  32°~104°F (0°~40°C)
• Charge Operating Temperature:  32°~113°F (0°~45°C)
• Discharging Operating Temperature: 14°~140°F (-10°~60°C)
• Flashlight: 25 Lumens
• Flashlight Modes: On | S.O.S. | Strobe
• Dimensions: 6.43” x 2.76“ x 2.13”
• Weight: 0.95 lb

WHAT’S INCLUDED

• A (1) AirPro™
• B (1) Storage Bag
• C (1) 12” Type-C Charging Cable (1) 1-Port USB Car Charger (1) 8” Hose
• D (1) 24” Hose with Air Chuck (1) Inflatable Adapter
• E (1) Ball Adapter
• F (1) Bike Tire Adapter

COMPONENTS

1. USB Charging Port (Output) Flashlight
2. Threaded Air Hose Connection Type-C Port (Input)
3. Exhaust
4. Adapter Storage Door Adapter Storage Slot
5. Control Panel
6. Air Compressor Mode
7. Digital Display
8. Unit of Measurement

ADAPTER COMPATIBILITY

Air Chuck
Cars, Trucks, Trailers, ATVs, Motorcycle Tires & more. Inflatable Adapter
Pool Tubes, Floats, Balloons, Toys, etc. Ball Adapter
Basketballs, Soccer Balls, Footballs, Volleyballs, etc. Bike Adapter
Bicycle Tires

CONTROL PANEL

Press:
Power AirPro On
Press & Hold (2 Seconds): Activate Air Compressor

Press:
Switch Pump Modes Press & Hold (2 Seconds): Switch PSI / BAR

Press:
Decrease 1 PSI / .1 bar Press & Hold:
Continual Decrease
Until Released

Press:
Increase 1 PSI / .1 bar Press & Hold:
Continual Increase
Until Released

Press:
Switch Light Modes Press & Hold (2 Seconds): Turn Off Without Cycling Through the Light Modes

HOW TO USE

Powering On The AirPro Press the AIR button

• The battery level will display for 5 seconds.
• The Car icon and current PSI will illuminate on the Digital Display. The Digital Display will read “0” if nothing is attached to the AirPro. The default unit of measurement is set to PSI

*The AirPro will automatically shut off after being idle for 60 seconds.

Adjusting the Modes
Use the SET , +, and – buttons to adjust the PSI/BAR setting to the desired level. Refer to the Control Panel instructions (left).

Connecting The Air Hose
Screw the end of the 8” Hose into the AirPro’s Threaded Connection.
The 24” Hose with Air Chuck can be used as an extender to create a 32” hose .

Connecting The Adapters
8” Hose:

1. Screw the threaded end of the Adapter into the end of the 8” Hose. Do NOT over tighten the Adapter.

24” Hose with Air Chuck:

1. Open the Lever of the Air Chuck and insert the threaded end of the Adapter.
2. Close the Lever to secure the Adapt

Checking the Tire Pressure

1. Connect both the 8” and the 24” Air Hoses to the AirPro.
2. With the Lever open, connect the Air Chuck to the vehicle’s air valve. Close the Lever. The Digital Display will illuminate the current PSI.

Using The Air Pump

1. Power on the AirPro, adjust the modes, and connect the Air Hoses.
2. Press and hold the AIR button to activate the air compressor.
3. The air compressor will automatically shut off once the desired PSI/BAR has been met.

• Press the AIR button to manually turn off the air compressor.

Notes: When using the air compressor for extended periods of time, It is recommended to allow the unit to cool after 8 minutes has surpassed to prevent over-heating.
Always refer to the manufacturer’s recommended PSI level for the item being inflated.

Using The Flashlight

1. Press the LED button once to turn on the Flashlight.
   • Single press the LED button to cycle through the light modes
   • Press and hold the LED button to turn off the Flashlight without cycling through the light modes.

Using The Power Bank

1. Plug a USB cable into the USB
   Charging Port and into a device.

2. Press the AIR or LED button.
   The device will begin to charge.

Recharging The AirPro
Use the included Type-C Charging Cable and
1-Port USB Car Charger or another compatible USB charger.

Air Compressor Built-In Protection Codes

E01 | Protection Type:
Battery Over-Temperature Protection
Troubleshooting: Turn off the AirPro and allow 10 minutes to cool down.

E02 | Protection Type:
Motor Over-Temperature Protection
Troubleshooting: Turn off the AirPro and allow 10 minutes to cool down.

E03 | Protection Type:
Leakage Protection
Troubleshooting: Disconnect and reconnect the Air Hose.

SAFETY INFORMATION

By using the Limitless AirPro, you hereby agree that Limitless Innovations, Inc., an Illinois corporation and its affiliates (“Limitless”) shall have no liability for any losses associated with property damage, personal injury or loss of life that are incurred by you or by any third party in connection with or relating in any manner whatsoever to your use of the Limitless AirPro. By using the Limitless AirPro, you hereby agree at all times to comply fully with all safety warnings, operating instructions and general safety information in this user manual. By using the Limitless AirPro, you further agree to hold harmless Limitless, (and Limitless’ officers, directors, shareholders and employees) in connection with any losses sustained by you (including, without limitation, losses arising in whole or in part from property damage, personal injury or loss of life) relating in any manner whatsoever to your use of the Limitless AirPro.

WARNINGS

• Do NOT leave the AirPro unattended during inflation.

• Limitless AirPro is NOT a toy and should be kept away from children.

• Do NOT use the Limitless AirPro near a magnetic or electric field.

• Do NOT use the Limitless AirPro in direct sunlight or extreme heat for extended periods of time.

• Do NOT use the Limitless AirPro if it has been damaged and/or modified.

• Do NOT subject the Limitless
  AirPro to harsh chemicals.

• Do NOT submerge the Limitless AirPro or its accessories in water.

• CAUTION: The surface around the Threaded Air Hose Connection may be hot while the air compressor is in use.

• CAUTION: Risk of fire and burns.
  Do NOT open, crush, heat above 140° F (60° C) or incinerate. Follow manufacture’s instructions.

• Do NOT insert any foreign objects into the openings or port of the Limitless AirPro.

• Do NOT charge the Limitless AirPro in high humidity conditions.

• Do NOT attempt to replace the battery as it is a non-serviceable part.

• Do NOT attempt to disassemble, repair, or open the Limitless AirPro or its accessories in any way.

• Do NOT use at an altitude higher than 6,562 feet (2,000 meters).

• Do NOT paint or apply coatings to the Limitless AirPro as you might affect moving parts or damage internal components.

• Do NOT use third party power supplies or non-approved adapters with the Limitless AirPro.

• Batteries should be recycled or disposed of, as per state and local guidelines.

• Do NOT stare into beam.

• Turn off the lamp before opening.

• Use eye protection during servicing.

To view the complete user manual, please visit: LimitlessInnovations.com/AirPro

All rights reserved. Limitless AirPro™, AirPro™, and Limitless™ are trademarks of Limitless Innovations, Inc. Design and specifications subject to change without notice. Products may vary from images shown. Accessories sold separately.

LimitlessInnovations.com
Support@LimitlessInnovations.com
855-843-4828

Limitless Innovations, Inc.
4800 Metalmaster Way
McHenry, IL 60050

© Limitless Innovations, Inc.
Designed & Innovated in USA
Made in China

References

• Cutting-Edge Consumer Electronic & Tech | Limitless Innovations

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>