Xtreme Mats Yamaha Drive2 Golf Cart Floor Mats Instructions
- May 15, 2024
- Xtreme Mats
Table of Contents
Yamaha Drive2 Golf Cart Floor Mats
Xtreme Mats Golf Cart Floor Mat Instructions with Clips
Xtreme Mats Golf Cart Floor Mats covers your entire OEM flooring from the
bottom of the dash down to the base of the seat. These floor mats are perfect
for your golf cart; they keep dust, dirt, sand, and moisture out, so you don’t
have to worry about ruining your beautiful golf car.
Installation on the following models: Yamaha / ICON / Advanced EV1
The Xtreme Clips work by securing the Xtreme Mat to the OEM (manufacturing)
flooring under the dash. The long arm of the clip goes underneath the factory
flooring, and the small arm hooks over the trim edge of the Xtreme Mat.
Before installing the mat, be sure the golf cart is turned off. Lay the mat in
the cart by going around the foot pedals carefully and up under the dash. With
the Xtreme Mat in place, look under the dash to find the edge of the factoring
flooring and pull the mat and the factory flooring slightly away from the
cart’s frame. Take the short arm of the clip with the slightly hooked edge and
place that against the inside lip of the trim piece. With the long arm facing
away from you toward the factory flooring and the short arm pressed against
the lip of the trim, pull the manufacturer flooring together with the Xtreme
Mat, swing the clip around, and slide it under the manufacturing flooring.
Press the flooring back down into place once it has been secured to the Xtreme
Mat. The two mats will now be clipped together, as in the illustration below.
You will receive 4 clips with your purchase, and they can be placed anywhere
under the dash where you are able to access the edge of the factory flooring
to attach them.
The picture below only shows how the clip attaches the Xtreme Mat to the
factory flooring, not where it should be attached. The clips go anywhere along
the top of the mat where it meets the dash, not on the sides of the cart.
